丙烯酸
- 与 丙烯酸 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
This article reports a new kind of copolymer, non polar polar terpolymer : poly(styrene-butadiene-methyl methacrylate ) P(S-b-B-b-MMA prepared by anionic polymerization with n BuLi as initiator, 1,1 diphenylethylene as capping agent and lithium 2-(-methoxyethoxy) ethoxide as complex agent.
以正丁基锂为引发剂, 1 ,1-二苯基乙烯为戴帽剂, 2-(2-甲氧基乙氧基)乙氧基锂为络合剂,在环己烷、四氢呋喃混合溶剂中,采用阴离子聚合法,于-70℃~-40℃合成了非极性-极性的三嵌段共聚物聚苯乙烯-聚丁二烯-聚甲基丙烯酸甲酯,并借用GPC、1H-NMR、DSC、TEM、IR等仪器对共聚物进行了表征。
-
The coating composition comprises, in a specific proportion, a vehicle ingredient comprising in a specific proportion an oligomer having at least twoacrylate groups and an ethylenic monomer copolymerizable with the oligomer, aacrylic-modified chlorinated polyolefin having a specific chlorine content, an organic peroxide polymerization initiator, and a polyisocyanate compound.
该涂料组合物含有特定比例的由至少具有两个丙烯酸酯基的低聚物和可与该低聚物共聚的乙烯性不饱和单体形成的媒介物成分、特定氯含率的丙烯酰基改性氯化聚烯烃、有机过氧化物聚合引发剂、和聚异氰酸酯化合物。
-
A SPE procedure was suggested for extracting and concentrating fisetin by using different volume fractions of ethanol in aqueous solution as the loading conditions.
分别以中药黄栌的主要成分非瑟酮为印迹分子、丙烯酰胺为功能单体及乙二醇二甲基丙烯酸酯为交联剂,通过封管聚合法合成了分子印迹聚合物;将其装于自制的固相萃取柱中,研究了以不同体积比的乙醇-水溶液为溶剂时非瑟酮在柱上的保留行为;通过优化清洗及洗脱条件,使非瑟酮与它的结构相似物槲皮素在柱上得到了很好的分离。
-
Selective catalytic oxidation of propane has been a problem from the industrial point ofview because it is less expensive but difficult to functionalize.
丙烷作为重要的小分子烷烃,将其选择氧化制丙烯酸是一条很有前途的路线。
-
The volume ratio of furaldehyde to acetic anhydride is 1∶2; the mole ratio of furaldehyde with anhydrous potassium carbonate is 1.00∶0.54. The best phase transfer catalyst is PEG1000, the mass ratio of PEG1000 with furaldehyde is 4.3%, the reaction time is 11 min, the reaction power of microwave is 260 W. The yield ofα-furanacrylicacid is up to 72.3% under these reaction conditions.
研究结果表明:在微波辐射功率为260 W、微波反应时间为11 min、以聚乙二醇1 000(PEG1000)为相转移催化剂,糠醛与乙酐的体积比为1∶2,糠醛与无水碳酸钾的量比为1.00∶0.55时,α-呋喃丙烯酸的产率为72.3%。
-
Our main products category has chloride (pivaloyl chloride, acetyl chloride, Propionyl chloride, methyl acryloyl chloride, butyl chloride, 2 - furyl chloride already chloride, acryloyl chloride, is amyl chloride, etc.) and acids (positive acid, pivalate, propionate, acetic acid, methyl acrylate, 2 - furoic acid, etc.) and so on dozens of products.
我公司主要生产的产品有酰氯类(特戊酰氯、乙酰氯、丙酰氯、甲基丙烯酰氯、正丁酰氯、2-呋喃甲酰氯、己酰氯、丙烯酰氯、正戊酰氯等)和酸类(正丁酸、特戊酸、丙酸、乙酸、甲基丙烯酸、2-呋喃甲酸等)等几十种产品。
-
The yields of compounds 1, 2, 3, 4, and 5 based on furoin were 99.3%, 96.5%, 98.0% 99.4% and 98.7%, respectively.
醋酸糠偶姻酯(1)、月桂酸糠偶姻酯(2)、苯甲酸糠偶姻酯(3)、α-呋喃甲酸糠偶姻酯(4)和3-α-呋喃丙烯酸糠偶姻酯(5)的收率以糠偶姻计算,分别为99.3%、96.5%、98.0%、99.4%和98.7%。
-
Lucite and Plexiglas are trademarks used for glasslike acrylic materials.
卢西特和普列克斯玻璃是玻璃状丙烯酸材料的商标名。
-
The results showed that the effects of the oxidized starch and the glutin on solution time in the water were obvious, while the glycerin, sodium laureth sulfate and metacrylic acid ester had less influence.
实验结果表明:氧化淀粉和明胶用量对氧化淀粉改性PVA水溶性薄膜的水溶性影响非常显著,而甘油、十二烷基醚硫酸钠、甲基丙烯酸酯对水溶时间的影响较小。
-
Stability of electrodeposition liquid, the physical and chemical resistance properties of the film depend on amine value, kinds of glycidic ester used, GA content and the amount of blocked polyisocyanate used.
结果表明,环氧基在固化过程中会参与交联反应,电泳液的稳定性、涂膜的物理性能和耐化学品性能由胺值、缩水甘油酯单体种类、丙烯酸缩水甘油酯含量和封闭型多异氰酸酯用量等因素决定。
- 推荐网络例句
-
But we don't care about Battlegrounds.
但我们并不在乎沙场中的显露。
-
Ah! don't mention it, the butcher's shop is a horror.
啊!不用提了。提到肉,真是糟透了。
-
Tristan, I have nowhere to send this letter and no reason to believe you wish to receive it.
Tristan ,我不知道把这信寄到哪里,也不知道你是否想收到它。