丙烯酸

In this paper applications and developing process of acrylic resin as retanning agent were discussed,and the synthesis and development of amphoteric acrylic polymer syntan were discussed.

本文讨论了丙烯酸树脂复鞣剂的应用现状及其发展前景，并讨论了两性丙烯酸类树脂鞣剂的合成方法和发展过程。

Research on techniques for the synthesis of ACR impact modifier with core-shell structure;2. Preparation of polymer-tungsten-silica composite microspheres with multi-layer core-shell structures;3. Organosilicon-acrylate micro emulsion with core-shell structure was synthesized with OP-10,JFC and amyl alcohol nonionic compounded emulsifier by means of seeded emulsion polymerization.

运用种子乳液聚合工艺以OP-10/JFC/戊醇非离子复合乳化剂合成了具有核-壳结构的有机硅-丙烯酸酯微乳液，研究了复合乳化剂类型、丙烯酸酯单体、有机硅单体加入方式和含量、pH值、硫醇对微乳液聚合过程中稳定性和光泽度的影响，通过差示扫描量热仪和透射电镜对微乳液的结构进行了表征。

Organosilicon-acrylate micro emulsion with core-shell structure was synthesized with OP-10,JFC and amyl alcohol nonionic compounded emulsifier by means of seeded emulsion polymerization.

运用种子乳液聚合工艺以OP-10/JFC/戊醇非离子复合乳化剂合成了具有核-壳结构的有机硅-丙烯酸酯微乳液，研究了复合乳化剂类型、丙烯酸酯单体、有机硅单体加入方式和含量、pH值、硫醇对微乳液聚合过程中稳定性和光泽度的影响，通过差示扫描量热仪和透射电镜对微乳液的结构进行了表征。

The effect of the amount of organfluorine on the rate of water absorption as well as water contact angle of latex film was also studied.

通过热分解引发体系，用有机氟单体对丙烯酸树脂进行改性，合成了性能优异的氟改性丙烯酸乳液，并研究了有机氟单体对乳胶膜吸水率及对水的接触角的影响。

But it is very difficult to have good mechanics function and antifouling capability if we use organic polymer resin simply.

因此本文通过有机硅单体与丙烯酸酯类单体进行共聚制得具有低表面能特性的有机硅改性丙烯酸树脂。

The emulsion polymerization was used to prepare the fluorine-contained resin with butyl acrylate and methacrylic hexafluoro butyl ester as monomer,so as to improve the apparent shade depth of fine-denier dyed polyester fabric.

以丙烯酸丁酯和甲基丙烯酸六氟丁酯为单体，采用乳液聚合法合成含氟树脂，用于提高涤纶染色织物的表观深度。

Low polydispersity homopolymers with branched or linear fluorocarbon side chain were obtained through the controlled polymerization of fluorinated acrylates.

实现了具有不同氟碳侧链结构的丙烯酸酯的可控聚合，得到了窄分子量分布的聚氟烷基丙烯酸酯。

Isobornyl methacrylate ; Ion exchgange resin ; Methacrylic acid ; Camphene ; Kinetics

甲基丙烯酸莰醇酯；离子交换树脂；甲基丙烯酸；莰烯；反应动力学

The influence of added methyl acrylate on the emulsion copolymerization of methacrylic acid and chloroprene in the presence of polyvinyl alcohol as a protective colloid was investigated.

研究了丙烯酸甲酯对聚乙烯醇为乳化剂的氯丁二烯和甲基丙烯酸乳液共聚合的影响。

And VTMS is added in late stage of polymerization, in this situation the system has the lowest coagulum. When the hydroxyl value of such polymer increases, the coagulum decreases; and solid content of such polymer increases, the coagulum increases greatly, so it is difficult to get higher solid content emulsion.

采用正交实验方法，通过对有机硅改性丙烯酸乳液聚合过程中凝聚物含量、乳液粘度影响的研究，确定的最佳的反应条件是：以SLS/OP为乳化剂、比例为4/6、用量为2％、丙烯酸单体的用量1.5％、反应温度为75℃、改性剂VTMS用量是1.5％、改性剂后加入方式下聚合反应过程中有最低的凝聚物含量。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。