不重合的
- 与 不重合的 相关的网络例句 [注:此内容来源于网络,仅供参考]
-
If the centroidal axis is not colinear with the element x-axis, applied
如果质心和剪切中心不是重合的,施加的剪切
-
In this method, a newmetric based on the principle of level set representation of difference area was designed.
定义了新的测度,该测度基于面积差水平集表示原理,将待分类的形状与已知类别的形状进行配准以使得它们的不重合面积最小。
-
The problem, of course, is that the extensionality principle is inconsistent with the constitution view if we assume that coinciding objects occupy the same place at the same time by having all of the same parts at those times.
问题是外延原则不一致于构成观,如果我们假设重合的客体占据相同的地点和时间,通过相同的部分。
-
Using DC and AC poling methods, three groups of polarized PZT/P 70/30composites have been prepared by poling only the ceramic phase(1), both ceramic and polymerphases in the same(2) and opposite(3) directions. Piezoelectric coefficients of group 1 compositesincrease as the PZT content increasing, while for group 2 composites, the piezoelectric coefficientschange the sign with increasing PZT content because piezoelectricity of copolymer is increasinglycompensated by that of PZT, and PZT content for zero-〓 isn't that for zero-〓. The experimentdata of both group 1 and 2 composites agree well with EMT-Shin model.
对复合材料的压电性能:只极化PZT粒子相的复合材料的压电系数随陶瓷分数的增大而增大,PZT粒子相与共聚物基体同向极化的复合材料的压电系数由于两相效应的部分抵消,随陶瓷含量的增大,发生符号的改变,且〓和〓零点不重合,它们与EMT-Shin模型都符合较好;而两相反向极化的复合材料的压电系数由于AC反向极化会导致陶瓷相极化程度的下降,导致实验值和理论预期偏差较大,尤其在PZT粒子高含量区。
-
The dynamic portfolio decision-making model with three-fund separation theorem based on stochastic benchmark ;2. Technological dimension chain is mainly used to fix the size and deviation when benchmark is not coincident.
工艺尺寸链主要用于基准不重合时工序尺寸及其偏差的确定,主要探讨工艺尺寸链在精度分析、粗基准选择和定位方案判定这三个方面的应用。
-
Because of the asymmetry of the inlet structure and the unstable characteristics of the swirl flow,the spinning center of the gas flow deviated from the geometrical center of the cyclone,which resulted in the asymmetry of the flow field and the change of the three dimensional velocity components.
蜗壳式旋风分离器入口结构的非轴对称以及气相旋流的不稳定性造成了气流的旋转中心与旋风分离器的几何中心不重合,从而导致了气相流场三维速度的非轴对称分布以及速度分量由于基准不同而产生的大小和方向变化。
-
The real tangential velocity fluctuation indicated that there existed an instability of swirling flow in the cyclone.This instability resulted in the rotation center of the swirling flow deviating from the geometric center of the cyclone,which produced the quasi-periodic oscillation of swirling flow and gave the real tangential velocity fluctuation.
瞬时切向速度的变化反映了旋风分离器内旋转流的不稳定性,这种不稳定性导致了旋风分离器内旋转流的旋转中心与几何中心不重合,旋转中心围绕着几何中心摆动,由此造成了瞬时切向速度随时间的类周期的波动变化。
-
The results show that, for the elasto-plastic contact of tip-substrate approach and separation process, the material plastic yielding in the atomic level is still governed by the von Mises criterion. For the adhesion of flat-ended wedges, continuum mechanics can be still applied down to a few lattice constants within the contact region, and give reasonable results, apart from the discrepancies near the contact edges. Moreover, adhesion hysteresis occurs during unloading due to the atomic steps, where the unloading curve does not coincide with the loading one. This in turn supports the presumption proposed by Pollock for the adhesion of stepped spheres.
本文首先对针尖—基体模型的弹塑性接触机理进行了深入研究,指出在原子水平上材料的塑性屈服仍由Von Mises准则控制;对平底锥冲头粘着接触的模拟表明,除了在接触区边缘附近有一定差别外,接触力学方法在接触区内几个晶格常数范围内仍能给出令人满意的结果;由于原子台阶效应,加载与卸载曲线不重合,出现粘着滞后,证实了Pollock关于具有纳米阶梯结构的球体粘着滞后现象的推测。
-
Besides,the minimum condition for the△f was also deduced. thin lens ; main flat surface ; the light heart error margin ; the Gauss method ; the total yoke method
本文在非理想状态下,仅讨论薄透镜的两主平面不重合于光心,即在存在光心误差的情况下,分析两种方
-
Jinsheng fiberglass has been widely used in construction,decoration,road,oil gas field. jinsheng fiberglass has built good reputation in domestic and asia,middle east,europe,and america etc.
&重合同、守信用、保质量、争河北易县纤维板厂&是我们不变的承诺,我们将以一流的品质,良好的信誉河北易县纤维板为海内外客户服务。
- 推荐网络例句
-
As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.
每逢看到沃林顿那刚毅的脸,那乌黑、忧郁的眼睛,她便会相信,他一定作过不幸的爱情的受害者。
-
Maybe they'll disappear into a pothole.
也许他们将在壶穴里消失
-
But because of its youthful corporate culture—most people are hustled out of the door in their mid-40s—it had no one to send.
但是因为该公司年轻的企业文化——大多数员工在40来岁的时候都被请出公司——一时间没有好的人选。