不均匀的

The fundamental imaging features of osteosarcoma were showed bone destruction, periosteal reaction, neoplastic bone and soft-tissue mass. Among 49 cases examined by radiography, osteoblastic pattern sarcoma was found in 19 cases, osteolytic pattern sarcoma was found in 13 cases and mixed pattern sarcoma was found in 17 cases. The detection rates of bone destruction, periosteal reaction, soft-tissue mass, neoplastic bone and Codman triangle by radiography were respectively 61.2%, 95.9%, 71.4%, 73.5%and 27.7%. All 10 cases with CT scan were showed bone destruction, soft - tissue mass and neoplastic bone. The detection rates of periosteal reaction,憇ieve sign挶 and Codman triangle with CT scan were respectively 90%, 90% and 11%. The tiny neoplastic bone and"sieve sign"were showed sensitively by CT, but Codman triangle was showed by radiography superior to CT.32 cases with MRI scan presented the normal marrow was replaced by the tumor, which was showed low to intermediate signal intensity on T1-weighted images and promiscuity signal intensity on T2-weighted images. 7 cases presented hemorrhage and 24 cases presented necrosis.

骨肉瘤基本影像表现为骨质破坏、骨膜反应、瘤骨和软组织肿块。49例X线表现为成骨型19例，溶骨型13例，混合型17例；X线对骨质破坏、骨膜反应、软组织肿块、瘤骨和Codman三角的检出率分别为61.2%、95.9%、71.4%、73.5%和27.7%；10例CT表现均可见骨质破坏、软组织肿块及瘤骨，CT对骨膜反应、筛孔征和Codman三角的检出率为90%、90%和11%；CT对显示细小肿瘤骨和筛孔征最敏感，但对Codman三角的显示不如X线平片；32例MRI表现为骨髓腔内正常的骨髓高信号被肿瘤信号所取代，T1WI呈低～等信号，T2WI呈混杂信号，7例合并出血，24例中央坏死囊变，32例增强扫描均呈不均匀强化及瘤周可见水肿区。

The curve continual steel box Liang shearing force stagnates the effect finite element analysis box section Liang has the big flexural rigidity and torsional stiffness, the stress performance good, spanning ability big, on the bridge the field of vision open and so on the merits, is in the bridge design the commonly used structural style, when receives under the dead load or the symmetrical live load function winding, because the lifting surface detrusion causes its bending stress to present the non-uniform distribution condition along the Liang width direction, this phenomenon is called "the shearing force to stagnate the effect".

曲线连续钢箱梁剪力滞效应的有限元分析箱形截面梁具有较大的抗弯刚度和抗扭刚度、受力性能好、跨越能力大、桥上视野开阔等优点，是桥梁设计中常用的结构形式，在受恒载或对称活荷载作用下挠曲时，由于翼板的剪切变形致使其弯曲应力沿梁宽度方向呈现不均匀分布状态，此现象称为&剪力滞效应&。

At present, the highway communication in the west of our country is in energetical developing period, and some western provinces are the most serious area of expansive soil, so expansive soil engineering problems have already become one of the technological difficult problems demanding prompt solution in road construction in the west of our country.

本文结合南友路路堤试验段修筑的处治膨胀土路堤，分析全填膨胀土路堤与各种处治路堤在降雨条件下的不均匀变形，并在此基础上进行路面结构的力学响应分析以及路堤边坡的稳定性分析。

In allusion to the character of the granulometric micro-image, a method of binarization of partitioning curved surface has been held up, which can eliminate not only the nonuniformity of the microscopical illumination effectively, but also the noise of the granulometric micro-image effectively.

针对颗粒显微图象的性质，提出分块曲面二值化方法，能有效地消除数据采集时显微镜的光照不均匀，也能有效地消除颗粒显微图象的噪声，且二值化所产生的图象质量好。

Such a telescope does not need any thermal control as its behaviour under homogeneous temperature changes is perfectly homothetic and thus keeps the image focused onto the detector.

这样的一个望远镜结构不需要任何的温度控制，因为在均匀的温度变化下热形变也是一致的，可以保证图像在探测器件上维持聚焦。

The consolidation and ill-defining diffuse nodule appeared in 8 cases, air bronchogram in 11 cases, bulging of the interlobar fissure in 4 cases,heterogeneous consolidation in 7 cases, cystic airspaces in 6 cases, and the CT angiogram sign in 2 cases, the consolidation were peripherally distributed in 15 out of 18 cases.

结果：18例肺炎型肺癌影像学表现两肺多发性分布7例，叶性分布8例，段性分布3例，所有病例均有实变存在，外周分布的15例，伴有不规则小结节的为8例，空气支气管征的11例，叶间裂向外突出的4例，实变影不均匀分布7例，不规则小囊腔6例，CT血管征2例。

At first,the curve of charge distribution,ionizable state of nonisothermatity sphere,Was obtained by computer to calculate ionized state according to distribution data of temperature and dinsity within Earth. Secondly,the pussibility of microgravitational testonosphere,Within the isothermality sphere,was found by balance between pressure and volumetric forcein Earth's interior.The thickness is 1 000 km or so.Finally,the result come into commom use various geophysical process withi...

首先依据地球内部温度和密度不均匀分布数据，用计算机计算它的电离状态，得到非等温分层电离状态的电荷分布曲线；其次从地球内部存在的流体压力与两类体积力：重力和静电力的平衡方程讨论中，发现在某一等温层内可能存在微重力构造圈，其厚度约为1000km左右；最后在地学研究向整体化和深部化发展趋势下，预期这个结果将有助于理解地球深部发生的各种物理过程且与地震S波在核－幔之间层中消失观测事实相一致。

Aiming at the special deformation mechanism during the with tension rolling of H beam in universal pass, a three-dimensional continuous kinematically admissible velocity field is put forward for the first time, in which, the non-uniform distribution of longitudinal velocity in lateral direction and the special deformation mechanism of the web and flange joint deformation zone are taken into consideration.

针对H型钢在万能孔型中带张力轧制时特殊的变形机理，首次提出了考虑金属横向流动的三维、连续运动学许可速度场；速度场中考虑了纵向流动速度沿横向的不均匀分布以及腹板和翼缘交界变形区的特殊变形状态。

Furthermore, the computational results indicate that the surface displacement fields varies with the distance form the fault, and the vertical displacement fields show strong inhomogeneity, in which largen displacement focuses on the ends of fault.

同时通过计算揭示了断裂错动过程中离断裂一定范围内的地表位移场变化情况，计算结果表明断裂错动形成的地表垂直存在较大的空间不均匀性，且主要集中于断裂的端部即映秀、北川和青川附近，并且位移场在这些地方变化都较强烈。

Based on the evolution history of Moon and other terrestrial planets, continental development process, plate movement tectonics, and solar nebular condensation petrology model that suggested by writers,a discussion about the action of water in Earth's evolution history has been carried.

在地球不均匀吸积模型的基础上，根据比较行星学所获得的行星演化理论、大陆进化的历史、板块运动的特点以及高温高压实验研究结果，对地球演化历史中水的总体行为进行了分析和推论。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。