不均匀的

The hardness of the laser clad layer is inhomogeneously distributed with the average value of HV 1100,higher than the substrate of HV 350. The hardness in the transition region is gradient distributed with steep reduction.

激光熔覆层的硬度不均匀，其平均值为HV 1100，远高于基体硬度HV 350，过渡区处硬度呈很窄的梯度分布。

Res ults: The maxillary central incisor was similar to the maxillar y lateral incisor in stress distribution. The highest stresses were observed in the root surface, the liwest in the periodontal ligament, the alveolar bone between them .

结果：上颌中、侧切牙的应力分布基本相同；上颌中、侧切牙及其支持组织的应力分布不均匀，牙根部受应力最大，牙槽骨次之，牙周膜最小。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

The theoretical and testing research results show that inhomogenous microzone of construction ,conce-tration and energy in austenite ,which is in demand for unusual decomposition of undercooling austenite ,can be obtainedby controlling heating or plastic deformation or controlling cooling.

通过理论和试验研究表明，过冷奥氏体异常分解所需要的奥氏体内在结构上、浓度上和能量上的不均匀微区，可以借助于加热过程控制或塑性变形、或冷却过程控制来获得。

The scheduling of nonuniform loop is one of the most frequently encountered problems in parallel computing.

不均匀循环的调度分配是并行计算中最经常遇到的问题。

This paper proposes a novel and practical method of measuring nonuniform light source by using digital imaging device.

介绍了利用数码成像器件测量不均匀面光源亮度的有效方法，分析了它与传统点式亮度计的差别。

In these applications, a value perceived to be an outlier may in fact be an accurate result of a nonuniform product.

在这些情况下，一个感觉是逸出值的数值实际上可能是不均匀产品的真实结果。

The essence of higher heating temperature for oxalate precursor is pockety La(superscript 3+) and Zr(superscript 4+).

草酸盐前驱体中镧和锆两种成分局部的分布不均匀是造成其处理温度比氨水法要高的直接原因。

Major conclusions are given in the end of this paper,that seismic statistical zone bases on the result of seismic belt delimiting,it only arises in and can be used in the especial PSHA method of China with considering spatially and termporally inhomogeneous seismic activities,and its concept should be clearly differentiated from the comcept of seismic belt.

文中最后指出，地震统计区划分是以地震带划分研究为基础，它产生并服务于考虑地震活动时空不均匀性的概率地震危险性分析方法，应将其与地震带概念加以明确区分，并加强其划分原则、理论和方法的研究。

By non-enhancement scan, 12 cases showed low density mass, 4 cases equal density mass, 1 case slightly high density mass, and 2 cases stippled calcification mass. By enhancement scan, 13 cases showed inhomogenous enhancement in cortical phase, 2 cases showed slight to moderate enhancement. Another 2 cases of small cystic RCC presented enhancement of wall with nodules and the partition. The enhancement of all tumor cases faded away in the following parenchymal phase and pyelographic phase, demonstrating some degrees of "fast washing out" phenomenon; 4 cases presented with pseudocapsule. The reconstruction of 17 "MPR/MIP" and 9 "VR" showed clearly the relations of kidney vessels, tumors and neighbor tissues and accessory renal arteries were founded in 2 cases.

结果：17例中小实性肾癌15例，小囊性肾癌2例；CT平扫呈低密度12例，等密度4例，稍高密度1例，伴有斑点状钙化2例；增强扫描皮质期13例呈不均匀明显强化，2例呈轻中度强化，另2例小囊性肾癌的囊壁、壁结节及囊内分隔明显强化；实质期、肾盂期扫描所有肿瘤强化均迅速减退，呈&快进快退&改变；4例可见假包膜。17例MPR/MIP、9例VR重建均能清楚显示肾血管、肿瘤与邻近组织的关系，并发现副肾动脉2例。

And Pharaoh spoke to Joseph, saying, Your father and your brothers have come to you.

47：5 法老对约瑟说，你父亲和你弟兄们到你这里来了。

Additionally, the approximate flattening of surface strip using lines linking midpoints on perpendicular lines between geodesic curves and the unconditional extreme value method are discussed.

提出了用测地线方程、曲面上两点间短程线来计算膜结构曲面测地线的方法，同时，采用测地线间垂线的中点连线和用无约束极值法进行空间条状曲面近似展开的分析。