不均匀的

The effect of fluid flow nonuniformity on heat exchanger's efficiency is the most important one among them because it can intensify longitudinal wall heat conduction and the maldistribution of interior temperature.

因为物流分配的不均匀会加剧换热器内部温度场分布不均匀和纵向传热，从而加剧了换热器整体效能的下降，所以物流分配不均匀性对换热器效能的影响在三者中是最主要的。

In the second part, by using uniform design and orthogonal design methods, some groups of mix test of foam lightweight with different component are conducted, the test data is analyzed by neural networks model and regression model, and optimum mix proportion is obtained. Orthogonal design for mix material considering density factor is presented, as well as uniform design for mix material adapting to different density. The mechanic characteristics of foam lightweight material and engineering characteristics differing from general material under an allround press are founded. Through the analysis of asymmetry settlement for Doulong sluice and the comparison of correct deflection scheme, the foam lightweight material shows some advantages in the load reduction.

在泡沫轻质材料的研究方面，利用均匀设计和正交设计方法进行了几组不同组分的泡沫轻质材料的配方试验，利用神经网络模型和回归模型对试验数据进行处理，得出最优配方；提出了考虑密度因素的混料配方的正交设计方法和适合不同密度时的混料配方均匀设计方法；研究了泡沫轻质材料的力学特性，并发现了在围压作用下所表现出的不同于一般材料的工程特性；论文将上述研究成果用于斗龙港闸工程的处理设计，通过对该闸的不均匀沉陷分析和各种纠偏方案比较表明，采用泡沫轻质材料进行减载处理有一定的优越性。

The 11 kinds of surface crack features of round cast billet formed by high casting temperature, mould flux lubricating film un-uniform at billet shell, unstale casting speed, tundish nozzle eccentric, alloy steel cast billet cooling and reheating speed overhigh, deleterious elements Pb,Sn,As,Sb and Bi residual content in steel over standard requirements and mould copper tube shifting,...

叙述了浇铸温度高，保护渣润滑膜不均匀，铸坯拉速不稳定，二冷水不均匀，中间包水口不对中，合金钢铸坯冷却和再加热速度过快及钢中五害元素超标和结晶器铜管偏移等致使圆铸坯表面形成的 11种裂纹的特征及其预防措施。

Through the experiments on hydration of AH in the following sulphate（Li_2SO_4、MgSO_4 、 Al_2(SO_4)_3 、MnSO_4 、CuSO_4 、CoSO4 、CdSO_4 、ZnSO_4 、NiSO_4 、FeSO_4）, dissoluble sulfate hydrate origining from hydration process of AH affects it's hydrous rate, hydrous rate of AH does not connect with Z/R of cation in stimulation, theory that Z/R affect hydrous rate of AH does not exist. Third, hydration of AH in dissoluble sulfate complies with dissolve-nucleate -grow theory, concentration of Ca~2+ from dissolving of CaSO_4 is higher than one of CaSO_4·2H_2O, calcium sulphate dihydrite gets a motivity of crystallization. dissoluble sulfate takes the following function: double-salt or dissoluble sulfate hydrate from hydration of AH in it becomes heterogeneous particle and a kind of nucleation catalyzer, and reduces surface barrier when DH becomes crystal because the crystal of DH precedently appears in uneven place. Results indicate hydration of AH does not conform with double-salt theory, but it conform with this mechanism: dissolve-nucleate-grow, formation of DH is an uneven nucleation and crystalizaion process.

通过对CaSO_4在Na_2SO_4 、K_2SO_4 、Rb_2SO_4 、Cs_2SO_4 、(NH_4)_2SO_4溶液中水化过程，以及CaSO_4·2H_2O、CaSO_4与以上硫酸盐反应速度、产物的研究，说明复盐理论不正确；CaSO_4在（Li_2SO_4、MgSO_4 、 Al_2(SO_4)_3 、MnSO_4 、CuSO_4 、CoSO_4 、CdSO_4 、ZnSO_4 、NiSO_4 、FeSO_4）溶液中水化，水化过程中硫酸盐水合物的析晶影响着无水硫酸钙水化，与激发剂阳离子Z/R值大小无关，阳离子的Z/R参数影响水化率的规律并不存在； 3、无水硫酸钙在可溶性硫酸盐中的水化按照溶解-成核-生长理论进行，CaSO_4达到溶解平衡时Ca~2+的浓度大于CaSO_4·2H_2O溶解平衡的Ca~2+的浓度，CaSO_4·2H_2O获得结晶的驱动力，可溶性硫酸盐起到形成晶核的作用：水化过程与CaSO_4生成复盐或析出水合物所形成的细小物相，作为异质微粒使母相中存在不均匀性，这些不均匀性有效地降低成核时的表面能位垒，使CaSO_4·2H_2O晶核优先地在这些具不均匀性的地方形成，因此这些物质起成核催化剂作用。

Through analyzing those special radiometric variations in ScanSAR images, this paper has explored the approaches for scalloping compensation and beam band correction.

中文摘要在对ScanSAR特有辐射不均匀性进行分析的基础上，本文开展了方位向Scalloping校正和距离向条带不均匀性校正研究。

In order to describe the distribution condition of graphite particles in spheroidal graphite cast iron, a description method based on multi-fractal was proposed.

为了描述球墨铸铁中石墨颗粒的分散均匀性，提出了基于多重分形的描述方法，该方法采用Matlab分形工具箱提取石墨颗粒分布密度的分形特征来定量描述石墨分布的不均匀性，其多重分形谱的宽度以及最大最小概率子集维数之间的差别反映了石墨分布的不均匀性。

In this study, we take 1999 Mw7.6 Chi-Chi earthquake for example to study the effect of sub-fault model and layered geological crust model to the coseismic deformation.

本文以1999年Mw7.6级集集地震为例，讨论不同的位错模型和介质模型(均匀、层状均匀及横向不均匀等)对同震形变的影响。

Results CT showed a intrapelvic mass of rectal wall or surrounding soft tissue with inequality of size, relation closeness with intestinal wall; rectall wall different degree compression and narrowing,and extruding surrounding tissue.Below 5cm tumor density were slightly reduced,but symmetrical. Exceed 5cm tumor moderately enhanced, but asymmetrical. CT value of major mass were 25-35Hu, with boundary zone nodule enhancement, contrast-enhanced CT value 50-60Hu, and centricity necrosis.

结果 （1）盆腔内直肠壁或直肠周围软组织肿块，大小不等，肿块与直肠壁关系密切；（2）直肠不同程度的受压、变窄，肿块主要向直肠腔外生长，对周围组织产生推挤压迫；（3）径线在5cm以下肿瘤平扫时密度稍低，但均匀，增强时表现为中等度均匀强化，无坏死；径线在5cm以上10例肿块密度平扫时呈稍低密度且不均匀，CT值25-35Hu，增强时较大的肿瘤边缘带中等度结节样强化，CT值50-60Hu，肿块中心部分无强化，呈坏死样改变。

And then with the analysis to the regularity and the factors impacting the export, the ones (link 2 and link 3) which affect the quotiety of the velocity pulsation most have been put forward.

通过分析得出各杆件对输出速度不均匀系数的影响，其中杆2、杆3长度对装置输出速度不均匀性影响最大。

The effects of strain rate on plastic formation and dynamic recrystallization of 7050 aluminum alloy were discussed. The results show that the deformation of the specimen is inhomogeneous, and the effective strain in the center of the specimen is maximum. The deformation inhomogeneity increases with the increase of strain rate. The effective stress of specimen is inhomogeneous. As the strain rate increases, the minimum stress value moves from the drum-shaped region to the heart of specimen. The standard deviation of dynamic recrystallization grain size decreases with the increase of strain rate.

模拟结果表明，热变形过程中，试样的各个部位的变形分布不均匀，心部的等效应变最大，变形的不均匀性随应变速率的增大而增大，但是变化的程度不大；试样内部各部位的应力大小分布不均匀，随应变速率的增大，最小应力值由自由变形的鼓形区域逐步向心部移动；动态再结晶晶粒尺寸标准偏差随应变速率的增加而减小。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷