不均匀分布

On one hand, it changes the distribution of meridional wind, thus the geostrophic vortivity develops in the ridge region on the south of the subtropical high at 500 hPa. On the other hand, it causes inhomogeneity of the vertical distribution of diabetic heating, triggering anomalous cyclonic circulation between two ridges and anticyclonic circulation in the ridge region on the south.

这一方面改变了经向风的分布，使500 hPa副高南侧脊线区域地转涡度平流项发展；另一方面引起非绝热加热垂直分布不均匀，在两脊线之间诱生一异常气旋性环流，在南侧脊线区生成异常反气旋环流。

The contact pressure and temperature distribute only at the asperities in real contact. The equivalent stresses have been interpreted in light of VonMises and Tresca principle.

粗糙实体上的接触压力和温度场分布均表现出明显的不均匀性，只分布在少数实际接触的微凸体上。

The distribution characteristics of wave force in front of the structure of circular caisson continuous wharf are expounded.

简述圆沉箱连续式码头结构前波浪力的分布特点，根据圆沉箱前波浪力与沉箱后土压力分布沿环向的不均匀性，总结了对圆沉箱顶部局部加强的 4种方法。

A major factor in deviation from optimal performance of the activated sludge secondary clarifier is the presence of density currents,resulting from the density difference and temperature difference.

异重流的形成是影响活性污泥系统二沉池水力学性能的主要因素，形成异重流的主要原因包括沉淀池内不均匀的污泥分布和温度分布。

Because of the uneven temperature's distribution in the space,the detected temperature'value will vary with the different placement of the temperature sensor in detecting temperature and then need to know the distributing curve of temperature in the given space.

由于温度在空间中分布不均匀，在进行温度检测时会出现检出温度随着温度传感器放置位置的不同而不同的现象，这时就需要知道特定空间内的温度分布曲线。

In contrast to current assumptions, our results show that both the background and the binding sites need to have a markedly nonuniform distribution in order to correctly model the observed ChIP-seq data, with, for instance, the background tag counts modeled by a gamma distribution.

和当前的假设相比，我们的结果显示背景和结合位点需要有一个显著的不均匀的分布，才能用例如，背景tag counts通过gamma分布来建模，正确的建模研究的ChIP-seq数据。

From the load factor analysis,it was found that both geometry and stress distribution have

通过负载系数分析发现：因为缺陷分布不均匀，所以在估算MEMS的受力情况时必须同时考虑几何因素和应力分布。

Second, we presented a dynamic model of a one-dimensional granular gas with quasi Gaussian size distribution, in which the rods are thermalized by a viscosity heat bath.

本文研究的重点在于建立均匀驱动的复杂颗粒系统的动力学模型，研究颗粒粒径分布的不均匀性对系统的动力学特征的影响。

The key technologies of Grid Method including grid divided in basin, impact radius of rainfall and number of reference rainfall stations have been discussed with example. The parameters of Grid Method have been selected through trial and error. Using simple random sampling to simulate the failure to collect rainfall, the relation between surface rainfall calculation error and station density, station distribution, uneven spatial distribution of rainfall has been sought.

论文探讨了流域网格剖分、降雨影响半径、搜索半径范围和参证站数量等关键技术，研究了网格法参数的优选，并采用简单随机抽样模拟降雨缺测情况，给出了面雨量计算误差与流域站网密度、均匀度、降雨分布不均匀性指标的关系。

In this paper, test research have been performed on the two important mechanical properties indicator compressive modulus of elasticity and shear modulus. Numerical simulation has been performed on the base of results of test under the situation uniform and uneven thickness of elastomer layer, which analyze internal stress distribution of the elastomeric bearing, as follows:(1) The traditional test methods of compressive modulus of elasticity test are rather cumbersome and take up experimentalists lots of time. This paper has improved the traditional test methods of compressive modulus of elasticity test, which has collected the holding-load time together to concentrate on holding load. The tests have been performed on different types of bearings, which results show that the results of the improved test method conform to the error range regulated by the standard and can effectively save time for the experimentalists, also eliminate the accumulative error.

本文主要对板式橡胶支座的抗压弹性模量、抗剪弹性模量两个重要力学性能指标进行试验研究，并在试验结果的基础上对均匀胶层厚度和不均匀胶层厚度两种情况进行数值模拟，分析橡胶支座内部应力分布规律，具体内容如下：(1)传统抗压弹性模量试验方法比较繁琐，占用试验人员大量时间，本文对传统抗压弹性模量试验方法进行了改进，将持荷时间集中起来进行集中持荷，通过对不同类型支座进行试验，试验结果表明该改进试验方法所得结果符合标准规定误差范围，为试验人员节省了大量时间，并且还消除了传统方法中的累计误差。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。