不均匀

The results show that:(1) The penetration resistance of functionally graded layered armour made of metal Matrix Composites is better than that of the Aluminum plate;(2) The penetration resistance of the functionally graded layered armour whichlay_up is 0%/57%/0%/26%/0%/12%/0% is the best;(3) The resistance penetration of the the functionally graded layered armour can be greately promoted through optimizing the lay_up and volume fraction of the reinforced particle;(4) The functionally graded armour in which the particles distribute continuous has better behavior of resistance penetration when the volume fraction of the reinforcements are constant;(5) The higher volume fraction of the reinforcements at the surface of FGM and the more non-homogeneous the reinforcements distribution, the higher thesurface Youngs Modulus and the flow stress are;(6) The behavior of penetration resistance of the functionally graded armour in which the particles distribute continuously is better than that of homogeneous steel plate;(7) The functionally graded armour provedes a important approach for the optimization and design of the resistance penetration;(8) The numerical results of simulation of the bird striking the aircraft structureshow that the finite element model of the balance leg is effective;(9) The numerical results show that the structure internal force is relative largewhen the bird strikes the top of the balance leg;(10) The process of the birdstrike is thaf.after the bird penetrting through the front skin of the balance leg and striking the front beam,the bird is broken up in three parts.

经过本文所进行的数值模拟后我们发现：(1)在层状梯度装甲板的抗侵彻过程中层状功能梯度板比铝板的抗侵彻性能好；(2)在层状梯度装甲板的抗侵彻过程中铺层顺序为0%/57%/0%/26%/0%/12%/0%的功能梯度装甲板的抗侵彻性能最好；(3)通过优化组合层状梯度板的铺层顺序以及增强颗粒的含量可以大大改善梯度板的抗侵彻性能；(4)当SiC颗粒体积含量一定时，增强颗粒连续分布的功能梯度板表现出了优越的抗侵彻性能；(5)增强颗粒连续分布的功能梯度板表面SiC颗粒体积含量越高，分布越不均匀，表面的弹性模量就越高，屈服应力就越高；畜此工业大学硕士研究生学位论丈(6)增强颗粒连续分布的功能梯度装甲板比匀质钢板表现出良好的抗侵彻性能；(7)功能梯度装甲板为整个抗侵彻性的优化设计提供了重要的途径。

Included among them are: characteristic frequency curve of reinforced medium; critical length of the anchor bar ; anchor bar density and nonuniform coefficient of the reinforced medium; embedded anchorage layer effect; bed plate effect; weak surface effect; distortion of the bow-shaped distributed state of the anchor bar frictional resistance and initiation, formation and development of the dominant glide control plane; criteria about the displacement velocity of side-wall stability status, critical status and unstability status, and the system of ordinate analysis method, et al

d。文中提出的若干新的概念、判据和分析方法，如加固介质特征频度线；临界锚杆长度；锚杆密度及加固介质不均匀系数；嵌固层效应；垫板效应；弱面效应；锚杆&弓形&受力形态的畸变与优势滑移控制面的产生、形成和发展；边壁稳定状态、临界状态和失稳状态的位移速度判据；纵坐标系分析法等，具有一定的理论价值，并对软土工程围护设计具有指导意义。

However, non-uniform settlement of wharf platform may occur due to large upper load and soil creep deformation, and bulkhead line may be concave or convex which will affect wharfs usage and beauty and cause the horizontal displacement of sheet-pile wall.

但是，在上部荷载较大且土体蠕变等因素下，码头作业平台往往会出现不均匀沉降，码头前沿线可能出现凹凸变形，从而影响码头的使用和美观，同时板桩墙不可避免会出现水平位移。

The results of test in locomotive showed that NiTi alloy intelligent washer can share alike the load between the bolts, and reduce the dynamic stress of bolts.

结果表明： NiTi 合金智能传力垫可以使螺栓组各螺栓间的受力不均匀度得到调整，动载荷降低。

The content of carbon and oxygen in the spot is respectively 6% higher than that in the normal coating,but the content of zinc and chromium belonging to the inorganic component is undifferentiated with that in the normal coating.It is concluded that organic resin is inhomogenously dispersed,which causes spot defects in the chromate-containing coating.

含铬绝缘涂层中斑点的C、O元素含量均比正常涂层高6%，而无机组分元素Zn、Cr含量与正常涂层无明显差别，研究表明，斑点是由于有机树脂分散不均匀所造成的。

The results of cold-flow model test indicate:(1) the pressure drop rises with increasing air quantity and solids quantity respectively, however, much more air quantity and solids quantity minish in the same height position;(2) the pressure drop rises with increasing solids quantity;(3) the average granule concentration minishes with increasing air quantity, and rises with increasing the granule quantity in the same level position;(4) the inhomogeneity of distribution granule concentration minishes with increasing air quantity, and rises with increasing the granule quantity in the same level position.

结果表明：(1)在同一高度截面上，循环流化床反应器炉膛内压降随风量的增加而增加，但是风量过于增大反而使压降在同一截面上减小；(2)压降随初始物料量的增加而增加；(3)在同一水平截面上，颗粒浓度随风量的增大而逐渐减小，随物料量的增大而增大；(4)颗粒浓度分布的不均匀性随风量的增大逐渐减小，随物料量的增加不断增大。

Adopting international advanced nanometer ultra micro powder technology and biological enzymolysis technology, it can perfectly cover face defect and line crack, adjust uneven skin tone, smoothen skin, build up skin transparency, in the meantime, it can resist pollution, improve skin tone, make your skin like crystal and lotus flower.

好处：精选天然珍珠精华、叶绿素逆时无痕修复因子、100%纯芦荟油等多种活性美肤成份，采用国际先进的的纳米超微细粉末技术和生物酶解技术，完美遮盖面部瑕疵及细纹，调整不均匀肤色，平滑肌肤，缔造肌肤透明感的同时，抵抗污染，提亮肤色，令肌肤晶莹剔透宛如出水芙蓉。

Brazil ranks among the world's highest in economic inequality, and the southeast's luxurious living standards often come under fire by impoverished regions such as the drought-stricken northeast.

巴西排列在世界上最高的经济上不均匀，而南部的豪华生活标准经常来自在火灾之下穷困的地区就像干旱遭殃的东北部。

Thin elastic foundation of cement concrete pavement design theory, in-depth analysis is to arrive at the grass-roots non-uniform bearing broken concrete pavement panels, gnawing edge, the wrong units, as well as the main reason for structural damage produced by taking certain measures to improve the concrete between the road surface and the grass-roots support conditions, and improve durability of the cement concrete pavement and stability.

通过水泥混凝土路面弹性地基薄板的设计理论，深入分析得出基层的不均匀支承是水泥混凝土路面断板、啃边、错台、以及产生结构性破坏的主要原因，通过采取一定措施改善砼路面面层与基层之间支撑条件，提高了水泥混凝土路面的耐久性和稳定性。

In accordance with the classic thermal conduction equation and the linear elastic dynamics equation, this paper analyzed the changing of material's optical and thermal physical properties under laser irradiation.

数值结果表明：材料内部的瞬态温度场分布在一个很小的局部区域，该区域存在很大的温度梯度，且分布极不均匀，材料热物理参数随温度的变化对整个瞬态温度场的影响很大。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。