不吸湿的

The contact angle of glycerol on the fiber plasma treated can decrease from 69°to 21°, i.e. reduction by 70%.

它的不吸湿性不仅使染色困难，而且大大地限制了其在服装面料上的应用。

The surface appearance and hygroscopicity of ADN after coating were analyzed by SEM and weighing method. Results show that a kind of floccule of PU is formed on the surface of ADN, which makes the hygroscopicity of ADN after coating less than that before coating evidently. When coated ADN is exposed in the atmosphere for 30 days with the RH less than 60%, the hygroscopicity of coated ADN is only 0.136% and does not increase with the increasing of exposure time.

用扫描电镜和称重法分析了包覆后ADN的表面形貌和吸湿性，结果表明，聚氨酯黏合剂在ADN表面形成絮状的包覆膜，使包覆后ADN的吸湿率明显小于包覆前ADN，在相对湿度60%以下，包覆后ADN在空气中暴露30天时吸湿率仅0.136%，吸湿率不随时间增加。

Results showed that TPSⅠ and TPSⅡ could dissolve in water and not in organic solvents of high concentration, and they had capacities of oil absorption, frothing and froth maintenance as well as capacities of moisture absorption and retention in humid and dry environment.

结果表明它们能溶于水，不能溶于高浓度的有机溶剂，随着纯度的提高，溶解性能降低；它们还具有吸油性、起泡性和泡持性，在湿润和干燥的环境中具有吸湿和保湿性能，纯度的提高增强了茶多糖的表观粘度，TPSⅡ的粘度是TPSⅠ的4倍。

Effects of dry temperature and dry time on properties of heat cured sand and the relationship with binder composition are as follows:sands bonded by binders that are not modified have high strength when dry temperature is high and dry time is long,but their anti-wettability power is poor . Sands bonded by binders that are modified by B but not modified by M can be dried quickly and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M but not modified by B can also be dried quickly to obtain maximum strength,then the strength becomes lower when they are dried continually for more time. and sand strength is high but anti-wettability power is also poor. Sands bonded by binders that are modified by M as well as by B at the same time can be dried quickly to obtain maximum strength at low temperature and short time. But the anti-wettability of sand mold is best when they are dried at high temperature and long time.

烘干温度和烘干时间对热硬砂性能的影响及其与粘结剂改性的关系是：未经改性剂B和改性剂M改性的粘结剂砂，脱水速度较慢，烘干温度越高，时间越长，则硬化强度也越高，但未经改性的粘结剂热硬砂的抗吸湿性较差；经改性剂B而不经改性剂M改性的粘结剂热硬砂，烘干硬化速度较快，强度也高，但在高湿度下的抗吸湿性不好；经改性剂M改性而不经改性剂B改性的粘结剂热硬砂，烘干时强度先随烘干时间升高至最大值后，继续烘干时强度又出现下降；经改性剂B和经改性剂M共同改性的粘结剂热硬砂能在短时间和较低的烘干温度下就可烘干到最高强度，即烘干脱水的速度较快，但试样的抗吸湿性差，若在更高温度和更长时间下烘干，试样的抗吸湿性得到改善，综合考虑烘干强度和抗吸湿性要求，对于φ30×30mm试样，理想的烘干温度是200℃，烘干时间20分钟。

Right now the nurse answers with gentle language, patient manner sucks phlegmy necessity and importance to patient and family member specification, and the serious consequence that rejects to suck phlegmy likelihood to bring about, and signal patient and gentleness of movement of family member operation, at the same time directive and sober patient cooperates to may decrease those who suck phlegmy place to bring is unwell, cooperate in order to obtain what the patient reachs a household. Whether do the 5 distances that check tracheal spile to be apart from fore-tooth have fluctuant reach auscultation sound of double lung breath is symmetrical. Sound of breath of 6 auscultation double lung, in order to judge the place of phlegmy fluid. The 7 patients as a result of tracheal spile, what aeriform exchange does not pass nose pharynx ministry is wet change, make inside tracheal spile drier, reason should time do pulverization inspiratory 2 / D~4 second / D, arrive in order to rise the wet path that spend energy of life, avoid the end with phlegmy scabby fluid.

此时护士应以暖和的语言，耐心的态度向病人及家属说明吸痰的必要性和重要性，以及拒绝吸痰可能导致的严重后果，并示意病人及家属操作动作轻柔，同时指导清醒病人配合可能减少吸痰所带来的不适，以取得病人及家属的配合。5检查气管插管距门齿的距离是否有变动及听诊双肺呼吸音是否对称。6听诊双肺呼吸音，以判定痰液的位置。7由于气管插管的病人，气体交换不经过鼻咽部的湿化，使气管插管内较干燥，故应定时做雾化吸入2次/d~4次/d，以起到湿化气道、防止痰液结痂的目的。

The results were found as following:(1) The damage value increases more significantly with the increase in PVF before 30% PVF, beyond which the increasing trend becomes gradually gentle.(2)Keeping the interphase strength and PVF unchanged, the damage increase with increasing moisture concentration in a nearly linear relation.(3)The results generated from the FCC model with consideration of the interphase debonding are in good agreement with the experimental data, meanwhile, the FCC model is also capable of predicting the critical load for the damaged and the undamaged dental composite subject too the 3-point flexural test.4 A 3D-fmite element analysis has been successfully exploited to examine the mechanical behavior of the restoration-tooth structure under the polymerization shrinkage and water sorption. It was found:(1) The low stiffness of the composite has the effect to limit the displacement occurring in the remaining tooth tissue. For lower interphase, the cuspal flexures are litter higher. The high interphase modulus acts as a \'shielding effect\' for stress transfer.

得到如下结论：(1)相同的吸湿性，在30％PVF(颗粒体积分数：Particle volume fraction，PVF)前增加PVF，层间脱胶损伤值显著增加；此后损伤值的增加趋于平缓；(2)保持层间强度和PVF不变，层间脱胶损伤随吸湿率的增加而接近线性增加；(3)FCC(面心立方：Face-centred cubic，FCC)模型层间脱胶损伤的预测结果和实验数据基本吻合；同时此模型可以用于预测牙齿填充材料三点弯曲实验的临界载荷。4、建立理想牙齿修复结构，利用有限元方法研究了同时考虑聚合收缩和吸湿膨胀耦合作用下的填充修复材料和粘结界面层材料性能对牙齿修复结构的力学行为的影响，得到如下结论：(1)低弹性模量的牙齿填充修复材料能限制天然牙组织的位移，但天然牙组织的位移与粘结界面层的弹性模量无关。

It has been found that at room temperature, moisture absorption had little effect on the mixed-mode interlaminar fracture toughness of T300/5405, but at high temperature, the fracture toughness of laminate increased as the moisture content increase.

研究的结果表明：室温时，吸湿量对材料的断裂韧性影响不明显；高温时，吸湿会使得T300/5405的层间韧性增加。

Compared to the silk, moisture regains, level dyeing and thermal behavior of raw silk grafted by MA was better. The K/S value increased a little, the fastnesses decreased a little. But the level dyeing of raw silk grafted by EMA declined severely. Compared to the grafted degummed silk, the moisture regains and level dyeing improved a little.

MA生丝增重丝相对于熟丝吸湿性提高、酸性染料染色的K/S值略有上升、匀染性提高、各种染色牢度变化不明显、热稳定性有所提高；而EMA生丝增重丝吸湿性下降、酸性染料染色的K/S略有上升、匀染性变差、各种染色牢度略有下降、热稳定性有所提升。

By contrasted with silica gel, the corn hull desiccants by hydrolyzation method and heat treatment method have advantages as stabilization on moisture adsorption, less water of reversible adsorption and high moisture adsorption ratio in high humidity. These desiccants have disadvantages as lower moisture ratio than silica gel in low humidity and slower moisture adsorption speed than silica gel. The corn hull desiccant by derivation method has advantages as high moisture adsorption ratio, high moisture adsorption speed, stabilization on moisture adsorption and hardly any water of reversible adsorption.

通过与变色硅胶干燥剂的对比，通过水解法和热处理法得到的玉米渣皮干燥剂的优点是吸水稳定，可逆吸附水少，在高湿度下吸水率高，不足是在较低的湿度下，吸水率比变色硅胶干燥剂略低，吸水速度比硅胶慢；通过衍生方法得到的玉米渣皮干燥剂的优点是吸水率高，吸水速度快，吸湿稳定持久，几乎不含可逆吸附水，不足是再生后产品容易结块。

Through an analysis on mud-clogging mechanism of suction nozzles on wet type sweeper, a concept is suggested, that water ratio in dust nearing the wall of suction nozzle duct should be decreased so the mud stickiness can be controlled under a critical value and not sticking to the duct wall whereas water ratio in central dust passage of the duct is properly increased to satisfy effective dust absorbing. On the basis of the concept, a water spraying device is designed with improvement for suction nozzles. In the device, the water hole numbers, diameters and distribution along the nozzle circumference as well as initial direction of water spraying are all determined according to concrete suction nozzle structures.

通过对湿扫型道路清扫车的吸嘴易被泥土堵塞的机理分析，提出降低吸嘴流道近壁的尘土的含水率，控制泥块的黏性处于临界黏性以下，使泥块不黏附于流道壁面；而将吸嘴流道中心部位的尘土的含水率适当加大，以满足有效压尘的解决思路，并根据这种思路改进设计了一种吸嘴喷水装置，按不同吸嘴的具体结构确定孔数、孔径、孔沿圆周的分布规律和喷水的初始方向等要素。

Neither the killing of Mr Zarqawi nor any breakthrough on the political front will stop the insurgency and the fratricidal murders in their tracks.

在对危险的南部地区访问时，他斥责什叶派民兵领导人对中央集权的挑衅行为。

In fact,I've got him on the satellite mobile right now.

实际上 我们已接通卫星可视电话了