不同步

Due to the complexity of the cell jitter, the NonSynchronous Tining Recovery methods are currently not mature With the emphasis being given to the Class A CBR traffic, this paper analyzes the performance of the queueing delay and cell jitter at the source node and intermediate nodes, and discusses the Source Timing Recovery at the destination node in ATM networks Firstly, this paper presents a description of the cell jitter of CBR traffic, and gives the definitions of two kinds of cell jitter regarding the Source Timing Recovery for CBR traffic Then, by using exact mathematical models and analysis methods, this paper analyzes the impact of the factors, such as the capacity of the queueing buffer, the randomness, the deterministic nature and the correlation in cell arrivals of the background traffic sources, on the queueing delay and cell jitter performance of the CBR traffic through Statistical Multiplexitng To obtain an insight into the power spectral distribution and look for better schemes for the depression and filtering of the cell jitter, within the analyses we succeed deriving the power spectrum of the cell jitter for CBR traffic Hence, not only the power spectral distribution of the cell jitter can in the frequency domain be qualitatively understood, but also can the rms (root-meansquare) value of the cell jitter be quantitatively obtained so as to more accurately measure the amplitude of the jitter In the end-to-end performance analysis of the queueing delay and cell jitter, we propose a kind of quasi-periodic cell stream model to characterize the jittered CBR traffic, and present an initial queueing analysis of the CBR traffic following such a model at a generic intermediate node Additionally, we briefly discuss the buildout/playout and Source Timing Recovery functions of the destination node Finally, regarding the Source Timing Recovery of CBR traffic, this paper systematically discusses several important principles of the cell jitter filtering and depression reported in the literature, introduces several implementation schemes of the Source Timing Recovery e.

由于信元抖动的复杂性，非同步定时恢复方法目前还很不成熟。本文针对A类CBR业务流在ATM网络源节点和中间节点的排队时延和信元抖动性能，以及在目的节点的源定时恢复问题作了较为全面的研究。首先，文中描述了CBR业务流的信元抖动，并具体地给出了两种与CBR业务源定时恢复有关的信元抖动的定义。然后，采用了精确的数学模型和分析方法，有针对性地分析了业务背景中信元到达的纯随机性、确定性和相关性以及排队缓存器容量等因素对CBR业务流经过统计复用后的排队时延和信元抖动性能的影响。为了了解信元抖动的功率频谱分布和寻求更好的抑制和滤除抖动的方法，在性能分析中，我们成功地完成了CBR业务流信元抖动的功率谱分析，使得不但可以从频域定性地认识信元抖动的能量分布特性，而且还可以定量地求出信元抖动的均方根值(rms：root-mean-square)，以更为准确地衡量抖动的大小。在CBR业务流的多节点端-端排队时延和信元抖动性能分析中，我们提出了一种准周期性(quasi-periodic)信元流模型来描述感染了信元抖动的CBR业务流，并基于这一模型进行了CBR业务流中间节点的初步排队分析。

The holistic design of the system and resolved the designs of software and hardware based on VXI bus are put forward according to the demand of test system. The hardware and software is designed, including the formation and design of hardware system, visual instrument software architecture, program design for instrument driver, high speed real-time data collection. In the dynamic test program, the idea of"software is instrument"was applied to meet the diverse test demands. Last, it is proposed that the VXI test system be developed to more totalization and networked. The basic theory of system identification was introduced briefly at first. The principle of spectrum analysis system identification based on Wiener-Hopf equation was expatiated. and the questions in applying Peusdo Random signal as spectrum analysis methods stimulate signal was studied, The generation principle of the peusdo random signal is researched, the characteristic of peusdo random are analyzed from time domain and frequency domain, the inverse repeat peusdo random signal is brought forward to make up the shortage of ordinary peusdo random signal. And a new chaos genetic algorithmis presented to solve the unprecise problem of the traditional method. In the servo valve dynamic characteristic test system, the spectrum analysis methods was applied successfully, the servo valve dynamic characteristic could be acquired rapidly and exactly, the test results were analyzed and the ameliorate methods were brought forward at last.

结合航天某集团液压测试中心测试系统的需求，提出了基于VXI总线的液压测试系统的整体设计方案，完成了测试系统的硬件设计与软件设计，包括硬件系统构成与设计、虚拟仪器软件结构、仪器驱动程序设计、高速同步实时数据采集等内容；以伺服阀动态特性测试为例设计了测试模块，该模块体现了VXI总线仪器软件开发所倡导的&虚拟仪器&的思想，以软件的灵活应用满足了不同的测试需求；结合自动测试系统的发展，研究了VXI测试系统与网络技术结合，实现各种软硬件资源共享，进一步提高设备及数据的利用率和系统的扩展性，使自动测试向综合化、网络化方向发展；研究了伪随机信号作为谱分析法辨识的激励信号时存在的问题，讨论了伪随机信号的产生机理，从频域和时域分析了伪随机信号的性质及其应用，提出了用逆重复伪随机信号弥补了普通伪随机信号的不足，并以混沌遗传算法对逆重复伪随机信号产生过程中的参数进行优化，可以更合理而不是凭经验产生需要的逆重复伪随机信号。

Thus,if the problem is resolved radically,we must quicken the balance of the development between the city and the country,and among regions,advance the urbanization and the construction of the rural area simultaneously,and promote the social structure more rationalization and tranquilization.

社会结构空间上的人口流动、社会发展的不均衡以及制度性约束是春运问题产生的根源，因而要从根本上解决春运问题，必须加快城乡、区域的均衡发展，同步推进城市化与农村建设，促进社会结构的日趋合理与稳定。

Results Serum EDLS increased within 24 h after brain trauma of different degree in all patients with brain injuries of various intensities.The group of slight injury was the most typal,EDLS demonstrated no change or decrease in a few patients with the injury intensity growing;In most cases EDLS decreased after brain operation or accompaning the wounded recovery; Contents of EDLS at 24 h among different pathological types of brain injuries showed no difference, but in the successful recovery patients with severe or ultra-severe brain injuries, EDLS contents at 72 h posttrauma were lower than in the patients of death or disability. The above change characteristics of EDLS related to injury locations and the degree of brain injury.

结果 不同程度脑外伤后24小时内血清EDLS均升高，以轻伤组最为典型；随着损伤程度的加剧，少数病例EDLS不变甚至下降；术后或随伤情的恢复，EDLS多同步下降；不同病理类型的脑损伤24小时内EDLS无明显差异，在成功康复的重型、特重型脑损伤病人，伤后72小时EDLS含量低于死亡或伤残组；EDLS 的上述变化特点与损伤部位和程度不同有关。

An embodiment of a method may include rejecting an arriving packet at a destination node on a semiconductor chip's ring interconnect, e.g., an unbuffered, synchronous ring interconnect, if all of the destination node's buffers are not available, leaving the rejected packet on the ring interconnect to continue traversing the ring, and accepting the rejected packet upon arrival at the destination node, if a buffer is available.

方法的实施例可包括，如果例如无缓冲、同步环形互连(120)的半导体芯片的环形互连上的目的地节点110(1-n的所有缓冲区均不可用，则在该目的地节点处拒绝到达的分组，将该被拒绝的分组留在环形互连(120)上以继续遍历该环，并且如果有缓冲区可用，则当被拒绝的分组到达目的地节点110(1-n之后接受该分组。

The study will develop the important research domain in the high efficiency grinding which has great potentialities, considering that the increase of heat transfer efficiency means an synchronous increase of the limit material removal rate under the condition of grinding unburn, therefore the further perfection of this study will not only increase the available material removal rate to a new level, but also solve the workpiece burn problem of the difficult-to-machining materials in the high efficiency grinding, which has great technical and economical significance

本项研究可望开拓高效磨削的极富潜力的重要研究方向，考虑到换热效率的提高本身也就意味着磨削时不发生烧伤的材料极限去除率的同步提高，因而进一步完善此项研究不仅可望将现有高效深切磨削的材料去除率提高到一个新水平，而且将有效解决难加工材料的高效磨削问题，其技术经济意义十分重大。

The load transfer of the squeezed branch pile has obvious time and sequence effects. The roles the bearing disks play are unsynchronized.

3挤扩支盘桩的荷载传递是具有非常明显的时间效应和顺序效应，各个承力盘作用的发挥不是同步的。

The results that CHP fixed fracture of the distal clavicle with dislocation of the acromioclavicular joint are ideal. Fractures ununited is avoided. Early functional exercise promotes fracture healing with function recovered at the same tine. CHP is relatively simple with less injury, rapid postoperative recovery, convenient application, less operative, less complications and should be recommended extensively in clinicle application .Therefore, The CHP fixation is the best method of effective treatment of the trauma at present.

CHP对锁骨远端骨折并肩锁关节脱位治疗效果理想，骨折不愈合可以避免，并且可以早期功能练习，使骨折愈合与功能恢复同步进行，而且具有操作简单、易掌握、损伤小、疗效确切的特点，值得临床应用推广，是目前有效治疗此种损伤的最佳方法。

The results indicate that in the synchronizing condition the MRF is unyielded, every point of MRF in the flow field has the same angular velocity. Under the slipping condition, with the increase of magnetic field or the decrease of slip speed, MRF may transfer from whole yield to partial yield. When the MRF wholly yields, the angular velocity of MRF increases nonlinearly with its radius, the non-linear distribution becomes more obvious as the magnetic intensity in the working gap increases. When the MRF partially yields, the yield region expands with the decrease of magnetic intensity or the increase of slip speed and the unyield region always reaches the driven rotor. The transfer torque of MRTD increases with the increase of the external magnetic field, but the transfer torque maintains a constant value approximately with the variation of slip speed at the same magnetic intensity.

研究结果表明，在同步工况下，传动装置流场中磁流变液未屈服，各点角速度相同；在滑差工况下，随外加磁场的增大和滑差转速的减小，磁流变液逐渐从完全屈服向部分屈服转变；磁流变液完全屈服时，磁流变液角速度随半径呈非线性增加，工作间隙中磁场越强，流场的非线性分布越明显；磁流变液部分屈服时屈服区域随外加磁场的增大而减小，随滑差转速的增大而增大，未屈服区与主动转子相连；稳态下磁流变传动装置传递的转矩随外加磁场的增加而近似呈线性增大，但在相同外加磁场下，传递转矩基本不随滑差转速改变而改变，表现出良好的恒转矩特性。

For projects with few developers, or for synchronizing a few private repositories, this may be all you need.

对于开发人员不多的项目，或者是对于涉及同步隐私的版本库来说，这些已经足够满足你的需要了。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐