不同成分

Methods A series of experiments using the attractant extracts of different main components of Laminaria were conducted at different temperatures and humidity conditions.

提取和分离海藻主要成分，在不同温度、湿度条件下，用不同成分提取物对钉螺进行诱食实验。

The result shows that the BH value of the Nb-ULC and Ti-Nb-ULC composition series fluctuates relatively little.

介绍不同成分体系的极低碳烘烤硬化钢汽车板实际生产情况，生产结果表明：Nb-ULC、Ti-Nb-ULC成分体系的BH钢BH值波动较小。

In this study, copper alloy adding Ti-Zr and Al-Zr was the target and made the cupper alloy ingots by vacuum arc remelter. After rolling and heat treatment, the two-inch round target was cut by wire electrical discharge machining. DC sputtering deposited cupper alloy thin films on silicon base materials and optical glasses to discuss the thin film microstructures、compositions、practical performances and optical characteristics.

中文摘要本研究以自行设计之铜基合金靶材，在铜基材料中添加钛锆与铝锆等微量金属，以真空电弧熔炼制作铜合金方锭，经滚压加工及热处理后，以线切割机切成两吋之圆型靶材，再进行直流溅镀沉积铜合金薄膜於矽基板和光学玻璃基板上，探讨不同成分比例下之薄膜显微结构、成分组织、实用性能与光学特性。

Treatment with periodate or trypsin caused a decrease in elicitor activity. It seems that the protein moiety is more...

因此IWF中可能含有几种不同成分的激发子，或是同种成分而聚合度不同的激发子

SEM result showed that the sample had uniform phase distribution and smooth surface at dried state as well as interpenetrate network structure at hydrogel state. It was seen from the swell ing behavior curves that groups T1, T2 and T3 swelled rapidly within 10-30 minutes, and formed elastic composite hydrogel pipes. In addition, the expanding ratio of inner and outer diameter of the tube was 20%-30% and 100%-120% with swell ing, respectively. The equil ibrium water content of the hydrogel pipes increased with increase of collagen composition. Three groups of samples were immerged in PBS solution contained 2 mg/mL lysozyme at 37 for 1 month, their nozzle cracked, their wall became thin and more transparent. And also, there was small floc deposited on the tube surface.

扫描电镜观察到液氮脆断的人工泪小管内部成分分布均匀，内外壁表面平整，冷冻干燥的人工泪小管断口呈凝胶态的互穿网络结构。3 组不同成分的人工泪小管在PBS 溶液中浸泡30 min 后均快速吸水溶胀，外径扩大100%～ 120%，内径扩大20%～ 30%，并且随胶原含量增高，溶胀速度增快，平衡溶胀率增大。3 组人工泪小管在37℃含2 mg/mL 溶菌酶的PBS 液中浸泡1 个月后，表面有部分细小絮状物，管口开裂，管壁变薄，透明度增加。

It was indicated by the CALPHAD that the solute content at the end point of primary solidification changes synchronistically with the start point, solute content in dendritic arm and the partition coefficient increase with the solid fraction. Simple Scheil equation was shown to be able to calculate the eutectic amount on the base of partition coefficient calculated by thermodynamics, its prediction for the different solutes is self--consistent and agreeable with the CALPHAD. The eutectic amount and SDAS was measured in DC experiment and compared to model value, it was shown that the experimental data are in agreement with the model prediction.

相图计算耦合Scheil模型的计算结果显示， Al--Cu--Zn合金单相凝固结束点的溶质含量与凝固初始点的成分同步变化，溶质含量和溶质分凝系数随凝固过程的进行不断增加；在热力学计算出合金分凝系数的基础上，简单Scheil方程可以计算初生相含量，从不同溶质得到的计算结果是自洽的，并与相图计算耦合Scheil模型的预测值一致；实验测定了不同成分铝合金的共晶含量和枝晶间距，实验数据与模型结果基本一致。

A model for predicating friction coefficient of resin-based friction materials based on artificial neural network was established to forecast its friction performance,and the ANN network model was trained by using 30 kinds of frication material's data of friction coefficient,and then fitted.

为了预测不同成分的树脂基摩擦材料的摩擦性能，建立了摩擦材料成分与摩擦因数之间的人工神经网络预测模型。

In order to explore the influence of the bath composition on Ni-W-P alloy coating structure and properties, to find the right ratio, so as to lay the foundation for follow-up experiments, SEM/EDS, X-ray diffraction, and metallographic analysis and other methods were adopted to study the composition and structure of different chemical deposition of Ni-W-P alloy. And the hardness of different components of the sediment layers plated state and the hardness after heat treatment were measured.

为了探索镀液组分对Ni-W-P合金镀层结构与性能的影响规律，寻求合适的镀液配比，为后续实验莫定基础，采用扫描电镜／包谱、X射线衍射以及金相分析等方法，研究了不同成分和结构的化学沉积Ni-W-P合金层，测量了不同成分沉积层的镀态与热处理后的硬度。

Effect of elicitors with different molecular weight and ingredients; prepared from the same fungus through different methods; on cellular defense response and taxol production were disparate.

同一真菌由不同的方法制备成的不同分子量大小或不同成分的激发子，对细胞的抗病反应与紫杉醇合成的影响不同。

Forming mechanisms of the spin glass state and re-entrance phenomenon of B2 type FeAl compound were analyzed, and it was thought that different mechanisms existed in FeAl compounds with various ranges of compositions such as indirect exchange interaction, short-range ordering of partial atoms, and finite and infinite radical coexistence.

研究了不同成分的B2型FeAl化合物磁化强度与外场的关系、磁化强度与温度的关系、磁滞回线的特点，分析了B2型FeAl化合物自旋玻璃态、再进入现象的形成机制，认为FeAl化合物不同成分范围内应存在不同机制如间接交换作用、部分原子短程有序、有限、无限原子集团作用并存。

The split between the two groups can hardly be papered over.

这两个团体间的分歧难以掩饰。

This approach not only encourages a greater number of responses, but minimizes the likelihood of stale groupthink.

这种做法不仅鼓励了更多的反应，而且减少跟风的可能性。