不变形的

The results indicate that the flow stress of the alloy increases with increasing strain rate and decreasing deformation temperature. The flow stress increases with increasing strain until the stress reaches the peak value, then the flow stress remains constant, which indicates that dynamic recrystallization happens during deformation. The flow behaviors are described by the hyperbolic sine constitutive equation, and the activation energy calculated is 337.75 kJ/mol. The as-forged microstructure consists of refined α2/γ and γ grains, and the grains are much homogeneous than before. The B2 phase distributes uniformly at the grain boundary of α2/γ and γ grains. The B2 phase decreases with increasing deformation temperature.

结果表明：流变应力随着应变速率提高和变形温度降低而增大；在变形过程中，流变应力随着变形量增大而增大，当流变应力达到峰值后趋于平稳，表明合金在变形过程中发生了动态再结晶；热变形过程的流变应力可采用双曲正弦本构关系来描述，平均激活能为337.75 kJ/mol；从合金的组织演化过程中可以看出，合金中不均匀的原始组织得到明显均匀化，变形后的组织是由α2/γ层片晶团和γ晶粒组成的双态组织，在α2/γ层片晶团和γ晶粒的晶界交界处发现分布均匀的B2相，并且随着变形温度升高B2相数量逐渐减少。

Through the experiments of three kinds of models mentioned above, the structural deformations of "outflow-extension","strike-slip-extension" and "uplifting-extension" are studied and some viewpoints involving that the plastic flow in the lower lithosphere controls the extensional structures are stated as follows:(1) Regional extensional structure does not result from the direct extension along the upper crust, but from the plastic flow in the lower lithosphere and its dragging and stretching the upper crust;(2) Deformation of continental extensional structure resulted from the active uplifting of mantle is conditional that the significant extension occurs only in the models with free- or outflow-boundary condition on both sides, whereas the passive uplining of mantle exists widely, because it is an inevitable consequence of the efiect of thermo-gravity isostasy;(3) Strike-slip shearing in the lower ductile lithosphere, including site-restricted and site-unrestricted shearing, can result in various types of extension structures;(4) The"graben-horst"type extensional structures can be formed in difierent mechanisms, including outnow-extension, shear-extension, uplifting-extension and their synthetical action.

通过上述三种模型的模拟试验，比较系统地研究了"泄流-伸展"、"走滑-伸展"和"上隆-伸展"等构造变形，提出岩石圈下层塑性流动控制了各种伸展构造变形的观点，主要包括以下几方面：(1)区域性伸展构造不是上层直接受到拉伸，主要是下层流动牵引上层伸展；(2)地幔主动上隆引起大陆伸展构造变形是有条件的，需要侧边伸展或不受约束的边界条件，而被动上隆广泛存在于地壳断裂或减薄部位，是热和重力均衡的必然结果；(3)下层塑性流动中的走滑剪切，包括限位剪切或非限位剪切，可以引起不同型式的伸展构造；(4)总结了"堑-垒"型伸展构造的多种成因机制，包括泄流、走滑、上隆及综合作用均可形成"堑-垒"构造，但组合形式不尽相同。

Synaeresis, does not distort - the unique neutral formula, not including the phosphorus and the alkali, the froth low, does not damage the fabric, after washes causes the silk wool textile fiber any harm, the clothing not to distort, easy to rinse.

不缩水，不变形-特有的中性配方，不含磷和碱，泡沫低，不损伤织物，洗后使丝毛纤维不受任何损害，衣物不变形，易漂洗。

Second, on the basis of classical girder theory, girder element stiffness matrix considering shearing deformation is deduced, the method of calculation of value of shearing deformation is illustrated, and how far effect on inner force and deformation considering sheering deformation is discussed. Through comparison inner force and deformation between considerations in shearing deformation and not, several results are achieved and several suggestions to calculation are pointed out.Third, prestressed reinforcement is considered in the paper.

其次，在经典梁理论的基础上，本文推导出考虑剪切变形的平面梁和空间梁单元刚度矩阵，阐述了剪切变形系数的计算方法，讨论了在不同箱梁截面高度情况下，剪切变形对结构内力值和变形值的影响，并与不考虑剪切变形影响的结果作比较，得出有关结论，并对工程设计计算做出了一些建议。

Nevertheless, in these aPproaches the contact intethee are charactered sboly edstiffeess K. and K.' which is not PerfeCt and rigorous in thc vitw of solidmechanics and rather rough for the description of the behavior of the iDtfores. Incollbet, taken as a contact Problem, the principal chatrs of the iDtCthees can bereflected: the cbntact inifore is of shear strength Which imPlies tha a genericpair of contact points on the inidse will displace coincidentally if the tangentialfbrce at this POint has not reahed the 1imit resistance, else, relative s1ide betwee the\ points will occur along the tangental direction.

本论文在对这两种方法进行认真的分析后，说明它们对不连续面的描述并不合理，也无法反映出不连续面的主要力学特性，同时指出，将带有不连续面的岩土工程问题作为接触问题计算更为合理，它可将不连续面受力变形的主要特点反映出来，即：(1)接触面具有相应的&抗剪强度&，即当接触面上某一点处的切向应力小于该点处的抵抗强度时，点对共同变形；达到强度时，则沿切向发生相对滑动；(2)在整个变形过程中，发生接触的变形体不能相互侵入。

Because quibau thick version 5.1, the back surface friction phase after sticking, la version force focused on the stamp pane at the ends, and the entire block is not fully apply it to the roller, the cnditions stress unevenly, in addition to the break-up of unaccumulate gamta, measurementunder, in the business card printing and membership card design is represented as a rigid body, there is almost no extrusion surface dimensions, it remained stable; and for thin base, together with the pad of paper plates attached to the roller for some examples of the frictional force of isolation, etc, in the role of uponsize in each of the cnditions of a uniform stress distribution, printing better apply it to the surface, it is large, measurementunder overprinter error.

因为厚版基包在滚筒上后，其背后与滚筒暗不天相贴后摩擦力较不小，不推版力只集洋在版口处的两头，分座印版不是分座贴在滚筒上，各质点答力分拨不平均，不兴宏不小的板滞倾圯边，不推伸变形较小，在制卡和会员卡制作历程洋表示为刚体，实在不有有挤压变形，不陈其暗不天尺寸根基保留安定；而差于薄版基，加衬垫纸的印版装在滚筒上后因衬纸的分隔，相答摩擦力变小，在不推力的功用下每个质点的答力漫衍较平均，印版较好不天贴在滚筒暗不天，不陈其不推伸变形较不小，套印差错较不小。

Amphibole, an important product during retrogression of UHP eclogite to amphibolite, exhibits few brittle deformation features, and does not show any intragranular microstructures indicative of crystal deformation such as undulose extinction, deformation lamellae, subgrain boundary and bulging.

角闪石是超高压榴辉岩退变质过程的产物，在光学显微镜下没有明显的脆性破裂变形，也不显示任何指示晶体塑性变形的晶粒内部显微构造，例如不均匀消光、变形叶理、亚颗粒边界和凸出褶皱等。

The effects of strain rate on plastic formation and dynamic recrystallization of 7050 aluminum alloy were discussed. The results show that the deformation of the specimen is inhomogeneous, and the effective strain in the center of the specimen is maximum. The deformation inhomogeneity increases with the increase of strain rate. The effective stress of specimen is inhomogeneous. As the strain rate increases, the minimum stress value moves from the drum-shaped region to the heart of specimen. The standard deviation of dynamic recrystallization grain size decreases with the increase of strain rate.

模拟结果表明，热变形过程中，试样的各个部位的变形分布不均匀，心部的等效应变最大，变形的不均匀性随应变速率的增大而增大，但是变化的程度不大；试样内部各部位的应力大小分布不均匀，随应变速率的增大，最小应力值由自由变形的鼓形区域逐步向心部移动；动态再结晶晶粒尺寸标准偏差随应变速率的增加而减小。

No cracks - No corrosion - No rust - No dents - No material defects - No lacquer defects - No surface defects - No deformation - No dirt and dust pins - No malfunction - No sharp edges - No dangerous materials - No colour differences or defects - No wobbling - Bucklings, dents, bumps and runny perpendiculars are not allowed - All materials, especially those which are exposed to mechanical load, have to be free of tension cracks - No surface defects, bubbles, cracks, scratches, deformation.

无裂缝，无腐蚀无锈无金属桶无材料缺陷无缺陷漆器-无表面缺陷，不变形无污垢和灰尘pins无故障没有锋利-任何危险材料，没有肤色的差异或缺陷，不抖动- bucklings ，金属桶，卜薪和流淌perpendiculars不允许所有材料，尤其是那些暴露于机械负荷，房维生素E可以自由张力裂缝，无表面缺陷，气泡，裂纹，划痕，变形。

Cylinder, the cylinder sets of radial a surplus deformation of the cylinder sets a great impact on the cylinder liner reduced radial a surplus amount to reduce the deformation of the cylinder sets, the top surface of the body decreases roughness, but it will increase the body on the plane cylinder only mouth the roughness ; Preload reduced cylinder head bolt deformation of the cylinder liner little effect, the body can reduce the top surface roughness and cylinder body on the plane I ended roughness; Shen appropriate reduced cylinder head bolt hole deep can reduce the deformation of the cylinder sets, but will cause the body and the top surface roughness on the cylinder body only I roughness increases Plane .

工作工况下，对于第2缸来说，气缸套径向过盈量对气缸套变形影响很大，减小气缸套径向过盈量，有利于减小气缸套的变形，减小机体顶面不平度，但会增大机体上缸套止口平面的不平度；减小缸盖螺栓预紧力对气缸套变形影响很小，可减小机体顶面不平度和机体上缸套止口平面的不平度；适当减小缸盖螺栓沉孔深可以减小气缸套的变形，但会造成机体顶面不平度和机体上缸套止口平面不平度的增大。

I can still vividly recall the impressive scenes you gave. You were among my friends and relatives who accompanied me from my house to the seaport and when the porters were slow to show up, you obligingly carried my suitcase for me.

你对我的种种感人情意，使我记忆犹新，那天你随着我的亲友从家里送我上轮船，搬运工迟迟不来，你毅然替我提着皮箱上船。

St. Nicholas became the patron saint of Russia, where he was famous for his red cape, flowing white beard, and bishop's mitre.

圣尼古拉成了俄罗斯人的守护神，在那里，他以身披红斗篷，留着飘逸的白胡须，戴着主教法冠而闻名。