不决定系数

The result showed that the single correlation between the characters of weight and heart girth, chest width and circumference of cannon bone was significantly different. The correlation between weight and heart girth, chest width, circumference of cannon bone was highly positive correlation. Among seven regression models, the correlation index of six regression models was over 0.7, but that of 60 days was 0.452. The result suggested that selecting body weight was efficient through heart girth, body high, chest width and circumference of cannon bone.

对不同日龄各项体尺与体重建立的了回归方程，结果表明，60日龄回归模型的决定系数R~2=0.452，其它6个回归模型的相关指数均在0.7以上，其中方程1、5、6、7的相关指数都在0.9以上，表明这些回归方程中各项体尺指标与体重之间相关密切，根据胸围、管围、体高和胸宽对体重的选择都是有效的，具有一定的参考作用。

Which indicates the regression equation 6 is plagued by auto correlation and we can not trust on the estimated t ratios, and coefficient of determination.

这表明回归方程6所困扰自相关，我们不能信任比率估计吨，并决定系数。

In the study on the relationship between different grid sizes and variogram of the pupae, the variation in the range, the intensity of local spatial continuity and the sill was very low or non-existent when the grid size was 5m, 6m or 7m, the value of the decisive coefficient was more bigger when the grid size was 5m, so, it is ideal grid size.

对不同样方大小的变异曲线图进行比较得知：样方边长分别为5、6、7m时，变程、空间局部连续性强度和基台值的变化幅度均很小，几乎相等，而样方边长为5m时的决定系数较大，此样方为最适样方大小。

The second and more important qualification is that , for reasons explained in our earlier papers , it is inappropriate to use t-tests for the individual slope coefficients derived from the second-stage cross-section analysis as a measure of the significance of individual factor risk premia , A joint test , which can be used to determine whether the risk premia vector is null , is the appropriate one to use , although neither it nor the t-tests can indicate whether an individual factor-risk premium is significant .

第二的和更多的重要资格是那，对于理由在我们的较早文件中解释，使用 t 是不适当的-测试对于起源于如对个别因素危险 premia 的重要性的衡量第二个阶段的跨区段分析的个别倾斜系数，一个关节能用来决定危险 premia 矢量是否是无效力的测试是使用的一个适当的，虽然既不是它也不是 t-测试能指出个别的因素-危险的额外费用是否是重要的。

Through designing of composition and structure of the bioactive graded coating,innerstress and its distribution in the coating were analyzed and calculated, the resultsshowed that when composition distribution coefficient n was 1.5, a reasonable stressdistribution could be got, that was at the beginning of deposition the suspension containingrichly BG granules was used so that a rich BG granules layer, a good transitional layerbetween BG layer at the bottom and the coating could be obtained at the titanium alloy side,the bottom of the coating; the stress value near the interface and surface and its character,pressure stress or tensile stress, were decided by the character of its composition itself.Changing composition distribution coefficient n could only change the variation tendency ofstress in the coating, but did not change the stress distribution rule in the coating. Thethinner the coating is, the sharper stress variation in the coating is, which does not mean thatthicker coating is better because the thicker the coating is, the little the permitteddeformation of coating is, so the coating thickness should be thinner, for example, about50μm for bending applications, but for applications only bearing pure shear stress, such asroot of tooth implant, the coating can be thicker little, for instance, about 80～100μm. The study on electrification characteristic and electrophoresis deposition of HAand BG granules in aqueous and non-aqueous solution system found that EPD almost didn'toccur in aqueous solution system. However, because HA granules take position charges inabsolute alcohol, a homogeneous EPD be carried out on the cathode titanium alloy slice, but taking negative charge in absolute alcohol the BG granules not be deposited on the cathode. A guided HA crystallizing, 100～300nm, on surface of the BG granules be realized by metathetical reaction, which cover BG granules with HA microcrystals and make the covered BG granules taking position charges in absolute alcohol, sequentially realize the EPCD of the BG and HA granules on the cathode, so it is feasible to make a titanium alloy/BG/HA bioactive graded coating by making use of EPCD technology. The corrosion experiment of rich boron bioglass coating and plasma spray coating showed that split phase, rich boron and rich silicon phase, occurred during its preparation. In basic medium the corrosion behavior of 〓 BG coating showed uniformity corrosion, the corrosion mostly occurred at rich boron phase area, therefore batch formula design of BGshould avoid the occurring of split phase. The corrosion appearance of plasma spray coatingappeared a non-uniform corrosion, mostly occurred at the edge of the laminated HA moltendrops, and emerged an accelerated corrosion tendency, which will easyly lead to corrosioncrackles extending to the interface and the happening of osmotic interfacial corrosion, thatmay be one of the major reasons leading to the coating cracking-off in the later period. Thetesting results of thermal expansion coefficient of 〓 and 〓BG showed the thermalexpansion coefficient of 〓 BG matched with that of titanium alloy better, and 〓 BG couldsinter with titanium alloy into densification enamel layer at low temperature (720℃).

将Ti6Al4V合金在1000℃下进行真空热处理会降低其力学性能，且合金内的V元素会向表面富集，因此，钛合金真空热处理和表面涂层的烧结温度不能过高，即应低于其相转变点；通过对生物活性梯度涂层的组成和结构的设计，分析和计算了梯度涂层内的应力大小和分布，结果表明：对于本研究，当成分分布系数n=1.5时，可以获得较合理的涂层力学性能，即在沉积开始时，采用富含BG颗粒的悬浮液，以便在钛合金侧获得同底层BG有良好过渡的富BG涂层；梯度涂层界面和表面的应力大小、性质由材料组成本身的性质决定，改变成分分布系数，只能改变涂层内应力变化的趋势；涂层的厚薄不影响涂层内的应力分布规律，但涂层越薄，涂层内的应力变化越快，但这并不意味着涂层越厚越好，因为涂层越厚，涂层允许的变形越小，对于应用于弯曲受力部位的涂层而言，涂层应薄一点为好(50μm)；而对于仅纯受剪切应力的部位，如牙根种植体，涂层可适当加厚(80～100μm)；通过对HA和BG颗粒在水溶液体系和非水溶液体系中的带电特性和电泳沉积的研究发现，它们在水溶液体系中很难发生电沉积；在无水乙醇溶液中，HA颗粒带正电，可在阴极钛合金片上发生均匀的电泳沉积，而BG颗粒则带负电荷；利用复分解反应法，可以制得100～300nm的HA，通过诱导HA在BG颗粒表面结晶，可对BG颗粒进行表面包覆，获得了被HA包覆的BG颗粒，改变了BG颗粒表面的带电特性，使BG和HA颗粒在无水乙醇中均带上正电荷，从而实现了HA和BG颗粒在阴极上的共沉积。

In this study, based on the Rnl, extinction coefficient k, transition coefficient of canopy layer stomatic resistance K', aerodynamics resistance ra and rc calculated with the data of Rn, LAI, rsi, the daily transpiration variation of Picea purpurea, Larix principisrupprechtii, Hippophae rhamnoides ,Betula platyphylla and Populus cathayana were studied in Datong County, Qinghai Province. Comparing with the practical transpiration variation measured by Li1600 Steady Porometer, the relative error of this model was less than ±15%, and the results were stabilized and tested by precision analysis.

本研究通过对Rn、LAI、rsi的实地观测，确定了林冠截流净辐射、消光系数、冠层阻力转换系数、空气动力学阻力和冠层整体气孔阻力，对青海大通地区紫果云杉、华北落叶松、沙棘、白桦和青杨的日蒸腾过程进行了模拟，与用快速称重法订正的Li1600稳态气孔仪实测蒸腾结果对比，模拟的相对误差在±15%以内；模型敏感性分析发现，温度、LAI以及rsi是决定模拟结果的主要参数，模型对各参数变化反应不敏感。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。