不值

Results show that amplitude of displacement excited by vertical incidence wave is larger than that excited by inclined incidence wave and not influenced greatly by the incidence angle. In vertical incidence, amplitudes of displacement of two points at the same altitude along each cavern are basically identical and maximum relative displacement occurs between top and bottom point of the cavern. While in the case of inclined incidence, displacement amplitude on sides meeting the wave is larger than that on leed sides, and maximum relative displacement occurs on left skewback and bottom of the cavern.

结果表明，位移幅值受入射角度的影响不敏感，竖直入射比斜入射情况要大；竖直入射时，各洞室两侧同一高程处的位移幅值基本相同，相对位移差最大部位为洞顶与洞底，而斜入射时迎波面比背波面一侧位移大，且相对位移差最大部位为洞室迎波面的左拱座与洞底。

Main job is to guarantee the scraping interaction and equipment on both sides of the friction surface or can obtain higher precision and accuracy, precision and shape accuracy, precision and contact transmission because of good lubrication, manual and repeatedly is worthy, large amounts of wind, time-consuming, scraping the time needed for different devices vary, such as boring slider and slide block wind profiling, between the match before measuring clearance between the original value, and then according to the technical requirement to measure the value of time and scraping scraping, then apply DanFen red on the slider, manual let slip on the slide seat back and forth, they do straight-line movement between full contact and friction, reoccupy scraper scraping friction creates the contact point, so repeatedly, until the technical requirements for the match, single within 2 days, must blow to the boring if all the time to work with wind, a half month is required.

刮削过程。刮削工作主要是为了保证设备相互接触并摩擦的两面间能获得较高的尺寸精度、形状精度、位置精度、接触精度、传动精度和良好的润滑，因是手工操作且需反复配刮，故工作量大，耗时较长，设备不同，刮削所需时间也各不相同，例如镗床上滑座与下滑座间的配刮，刮削前先测量出二者之间原有的间隙值，然后根据工艺要求测算出需刮削值及每次的刮削量，再将红丹粉涂于上滑座之上，手工让上滑座在下滑座上来回做直线运动，使它们之间充分接触和摩擦，再用刮刀刮削摩擦产生出的接触点，如此反复多次，直至技术要求范围之内，单此项配刮需2天左右，若对于整个镗床所有配刮工作的时间总和，则需半个月左右。

This function can be used to sort an array by key, instead of by value. It's used like so

这个函数的作用是可以让数组按键值进行排序而不是值，使用方法如下

The most versatile is the list, which can be written as a list of comma-separated values between square brackets.

最通用的是链表，它写为中括之间用逗号分隔的一列值，链表的子项不一定是同一类型的值。

According to this algorithm, it is shown that the bifurcated periodic solutions through Hopf bifurcations at the first critical value of delay are orbitally asymptotically stable on the center manifold and the bifurcated periodic solutions through Hopf bifurcations at other critical values of delay are unstable.

根据这一算法，发现在时滞的第一个临界值处通过Hopf分支产生的周期解在中心流形上是轨道渐近稳定的，而在其它临界值处通过Hopf分支产生的周期解在中心流形上是不稳定的。

In the middle later period of diagenesis, the starting resistance increases, the fluid is not able to flow, the viscous resistance is equal to zero, the ultra-pressure value is equal to starting resistance.

在成岩作用的早期阶段，泥质岩层启动阻力较小，流体可以流动，流体超压由粘滞阻力和启动阻力两部分组成，当成岩作用进入到中－晚期以后，泥质岩层启动阻力增大，流体不能流动，粘滞阻力近似等于零，超压值等于启动阻力值。

In each period, without the knowledge of the distribution function of the time between failures and the repair time, the PA estimate of gradient of performance function is put into the stochastic approximation algorithm which recursively optimize the threshold value of the flow control model in a manufacturing system.

在分析过程中，对故障时间和工作时间的分布不做任何假设，利用自适应控制的思想，将整个样本路径依据一定的规则分成有限长的时间段，在每一段时间内用扰动分析估计目标函数的样本导数，然后用随机逼近算法渐进地估计流程控制问题中的最优阈值，从而实现了阈值的自适应控制。

After pretreatment with TFP, although the conductance of cultivate solution of strawberry seedling under NaCl stress was not increased, growth was inhibited obviously by TFP, while the leaf relative electric conductivity in strawberry increased, leaf holding ability was reduced. The inhibiting response increased with the concentration of TFP increasing. On the contrary, conductance in cultivate solution was increased by Ca(NC?3)2 treatment, but the leaf relative electric condu

用Ca(NO_3)_2和TFP培养处理NaCl胁迫的草莓幼苗，发现TFP培养处理虽然不增加培养液的电导值，但明显抑制盐胁迫草莓幼苗的生长，增加了叶片膜透性，降低了叶片保水力，抑制作用随TFP浓度的增加而增大；而Ca(NO_3)_2处理虽然增加了培养液的电导值，但降低了幼苗叶片膜透性，提高了叶片保水力，因而减轻了NaCl

The length of the sunward merging line between the two peaks of reconnection potential shows a non-monotonic variation in response toθ_,peaked atθ_=90°,so it is also not justified to take electric fields along the merging line to characterize the the total reconnection rate and the coupling strength between the solar wind and the magnetosphere.

3向阳侧磁合并线电势的最大值和最小值之间的合并线长度与θ_IMF的关系是非单调的，在θ_=90°时最长，因此用合并线上的电场来取代重联电压来表征总的重联率和太阳风一磁层耦合程度也不合理。

The mechanism of the reaction was studiedin detail,in which excited state avaliable to carryout the excited state intramolecular proton transferreaction was recognized.The INDO/S-CI semiempiricalMO method was used to calculate transition energiesand oscillator strength,and assign spectra theore-tically,the calculated spectra values were basicallyconsistent with the experimental values.Themolecular orbital properties for the adjacent HOMO-LUMO of various kinds of conformersand anion species,thetransition properties and symmetry for thetransition from ground state to lower excited stateswere analysed,especially,no much study on theanion species all of the world.

位能曲线的求法满足反应坐标是反应过程中能量最小途径的定义，较详细地研究了各类反应的质子转移历程，认定在哪个激发态有利于发生激发态分子内质子转移反应，用INDO/S-CI半经验MO方法进行跃迁能和振子强度计算及光谱的理论指认，计算的光谱值和实验值基本吻合，并分析了各种异构体和阴离子的HOMO-LUMO附近的轨道性质，各跃迁态的跃迁性质和对称性，尤其是对阴离子的研究国内外尚不多见。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。