下筒

Corolla white, yellow, or purple-red, 2-lipped; tube dilated in front near base, long exserted, not hairy annulate inside; upper lip short, straight, margin entire or emarginate; lower lip longer, subpatent, 3-lobed; middle lobe largest, emarginate, margin undulate to dentate.

花冠白色，黄，或紫色红色，二唇形；在前面扩大的筒部近基部，长，不有毛有环在里面；上唇短，直，边缘全缘或微缺；下唇长，subpatent，3浅裂；大，微缺的中部裂片，边缘波状对具牙齿。

The barrel part of XLP/A Cyclone dust collector assume bicone. Among these, the upper of the dust insulator is orthostyle and the lower is spiral line style.

XLP/A型旋风除尘器的筒体部分为双锥体，灰尘隔离室的上段为直线型，下段为螺旋线型。

Corolla bilabiate, tube long and narrow, upper lip 2-lobed, lower lip 3-lobed; lobes valvate, ovate-lanceolate, densely pubescent adaxially along margin.

二唇形的花冠，筒部长和狭窄，2裂的上唇，3浅裂的下唇；镊合状，卵状披针形，密被短柔毛的裂片正面沿边缘。

Perianth tube slightly curved; limb segments clavate, free, recurved at anthesis.

花被筒稍弯曲；冠檐裂片棍棒状，离生，在花期下弯。

Aim at protecting moulding introduced by small square billet via columniform nozzle,therefore the condition was researched in this paper by means of simulation, which willhelp productivity with improving the casting speed.

针对目前小方坯普遍采用保护浇注，使用直筒型水口，模拟了这种情况下结晶器内的流场以及传热凝固现象，为高效方坯连铸提供理论依据。

Filaments inserted at lower part of corolla tube, decurrent part oblong, not pubescent.

在花冠筒，下延的深裂的长圆形的下半部分着生的花丝，并非短柔毛。

Finally heat the starch to 80℃dextrinize 2h,keep warm 0.5h,then cooled to 40℃,add 2.8%CAN initiator,7.5%MMA monomer,sealed and stir 3.3hours of the nitrogen atmosphere,using the screw rod center distance is 32mm,expects the tube diameter phi300mm major axis compared to L/D is 12.5 double screw rods extruding machines,controls the screw rod rotational speed 100rpm sample water content when 20%squeezes out,and the results indictated that the sample may bear 302℃within the high temperature,the water resistance is 14.7%,buried in the simple earth passes through about 180 day to be allowed to achieve the nearly 60%weightlessness rate, and can be basically completely degrades.

因此将淀粉80℃糊化2h，保温0.5h，40℃添加2.8%引发剂，7.5%MMA单体，通氮气密封搅拌反应3.3小时后的接枝产物，利用螺杆中心距为32mm，料筒直径f300mm长径比L/D为12.5的双螺杆挤出机，控制螺杆转速100rpm样品含水量20%时挤出，测定知道样品可以耐302℃以内的高温，耐水性为14.7%，在简单土埋的情况下，经过180天左右可以达到近60%的失重率，可以说基本上完全降解。

The leaves were transported to the laboratory where densities of Phytoseiidae and of the most common mite families (e.g., Tetranychidae, Tenuipalpidae, Eriophyidae, Tydeidae, Winterschmidtiidae) were evaluated under a binocular microscope.

每次取样，每两个相同的样品需要收集10片叶子，采样得到的叶子将被送往实验室，在双筒显微镜下，可以对植缨螨科，以及最常见的螨科（如叶螨科，细须螨科，瘿螨科）的密度进行评估。

The leaves were transported to the laboratory where densities of Phytoseiidae and of the most common mite families (e.g., Tetranychidae, Tenuipalpidae, Eriophyidae, Tydeidae, Winterschmidtiidae) were evaluated under a binocular microscope.

每次取样，每两个相同的样品需要收集10片叶子，采样得到的叶子将被送往实验室，在双筒显微镜下，能对植缨螨科，以及最常见的螨科（如叶螨科，细须螨科，瘿螨科）的密度进行评估。

Collapse breccias in the superficial parts or topside of the hypabyssal pipe are related with the gold-copper mineralization.

角砾岩筒上段的塌陷角砾岩与矿化关系密切，中段的流化角砾岩、边部的水压角砾岩和下段的爆发角砾岩还未出露。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。