下料

Since its inertial vibration feeder allows synchronization with the full voltage directly under the conditions of launch and parking, in order to stop stable and fast through the resonance, allowing parking brake, and adapt to various electrical braking, if Consumption brake, Fan Jie, such as braking.

其自同步惯性振动给料机允许在满符合电压条件下直接启动和停车，为了停车稳定且快速通过共振区，允许制动停车，且适应各种电器制动方式，如能耗制动、反接制动等。

Machine Tool for automatic, manual-type dual purpose, manually type on the basis of automatic but removal the automatic feeding devices and installed the carding device (this device is mainly applied to plants and animals hair) and manual output parts in the same machine tool, the specifications of iron sheet brushes within 2.2 mm ~15mm can be done, the shearing height can be controlled within 13 mm ~ 260mm (suitable for plants and animals hair), automatic feed, 16 gear speed settings, the length of products can be set at will, automatic punching shear, the tolerance can be controlled within ± 0.2mm, with the characteristics of broad applicability, disassembling convenient, flexible, and a multipurpose.

机床为全自动、手动型两用，手动型在自动的基础上拆除自动下毛毛箱装置，安装随机的梳毛装置（此装置主要适用于动植物毛）和手动排毛部件可在同一机床上生产底宽2.2mm～15mm规格的铁皮刷，剪毛高度可自由控制在总高13mm～260mm之间，自动进料，16档速设置，产品长度任意设置，自动冲剪，冲剪长度能保证在±0.2mm以内。具有适用性广、拆装方便、灵活、一机多用的特点。

The working principle of this machine: manual on the tree branches into the hopper, automatic feed the branches will be chopped to the cavity, in the high-speed rotary cutter, the knife and knife set interaction, will cut off the branches, will be cut by the broken debris labeled by the marker from outside agencies.

本机器的工作原理：由人工将树枝放在入料斗，自动送料机构将树枝送到切碎腔内，在切刀的高速旋转下，动刀和定刀相互作用，将树枝切断，并由捣碎机构将切块打成碎屑，经排料机构排出机外。

Dedicated to metallurgy, coal, thermal power, chemical, cement and other industries slag ditch, mine shafts, coal unloading slot, under the hopper, feed silo lining wear layers and water utilities, ports, etc. works sluice, Discharge hopper anti-wear layer for protection-based concrete role.

专用于冶金、煤炭、火电、化工、水泥等行业的冲渣沟、矿槽、卸煤槽、下料斗、料筒仓的内衬抗磨层和水利水电、港口码头等工程的泄洪闸、卸料斗的抗磨层，起到保护基础混凝土的作用。

The material enters from the feed pipe and is scattering in the rising airflow. Under the influence of gravity, the powder medium fragments fall by conquering the airflow resistance and is discharged from the discharging port.

物料由进料管进入，经分散板撒到上升的气流中，物料中的粉磨介质碎片在重力作用下，克服上升气流的阻力下落，由排渣口排出。

It was found that the stability of the melt was seriously affected by the diameter, the density and the homogeneity of the feed rod. The dense and uniform feed rods with pure phase were prepared by complete mixing and repeated sintering at a suitable temperature.

在适当温度下多次预烧结和反复混料，并通过最后的烧结可获得纯相、均匀和致密的原料棒；原料棒直径一般控制在10 mm以内； 3～5 mm/h的生长速度适合晶体生长；生长结束时缓慢降温和退火处理可抑制YFeO3晶体的开裂。

The key components such as drive device, feed equipment and combination roll of coal briquetting machine were improved. The bridge-type synchronous gear-drive device was designed to implement the concession of driven shaft in order to protect the costly roll. The helixes feed equipment was used to improve the plasticity of material to ensure the strength of products.

采用过桥齿轮传动实现从动型轮轴的退让，以保护价格较高的型轮部件；采用螺旋强制给料机构提高成型前物料的密度和可塑性，以保证型煤成品的强度；采用型槽与型齿对应配置的型窝，在获得同样强度的型球条件下降低成型压力，减小动力消耗。

Except the lower IB,the MOR,MOE and nail-holding power can achieve the National Standard GBT 4897. 3-2003, which includes the requirements for boards for interior fitments for use in dry condition.

在施胶量16％，热压压力3.4MPa，对碎料进行球磨处理后制板，除内结合力较低外，板的静曲强度、弹性模量和握钉力都可以达到GBT 4897.3-2003对在干燥状态下使用的家具及室内装修用板的性能要求。

Flange, and stainless steel tubing and other materials under Kok.

法兰、管材及不锈钢下角料等。

In most cases, foods require additional flavorings during or after processing to make them more palatable.

许多情况下，食物需要外加调味料以使它们更加美味。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。