下料

In this paper, the chemical equilibrium constants of the reactions in the reaction system of toluene disproportionation and trimethylbenzene transalkylation reaction system were carefully calculated , and the equilibrium compositions of the components at different temperatures and different feed mole ratios were analysed .

对甲苯歧化与三甲苯烷基转移反应体系中反应的化学平衡常数进行了详细计算，并对不同温度、不同进料组成下的平衡组成进行了分析。结果表明，随温度升高，甲苯与三甲苯的芳烃平衡转化率降低，二甲苯的平衡组成亦降低；降低进料中甲苯和三甲苯的摩尔比，甲苯和三甲苯的总芳烃平衡转化率降低，而二甲苯的平衡组成明显上升。

Considering the characteristics of multi-variables and multi-objectives in the burnup calculation process of nuclear system, the optimization control method based on GA is presented as a functional module of the multi-functional transport/bu...

利用FDS课题组开发的多功能中子学程序系统VisualBUS1.0，针对该系统燃耗计算过程具有多变量和多目标函数复杂关系的特点，应用遗传算法对嬗变包层的锕系废料嬗变区的初装料量进行了优化处理，使其在一定的物理和工程参数约束下，指导嬗变区的装料份额取值，分析嬗变区的装料份额对锕系废料的年燃耗深度等参数的影响。

The working process of set is as follows; the liquid of raw material is pumped in through diaphragm pump. The liquid of raw material atomizes into tiny droplets. Then it gathers with hot air and fall off. Most parts of powder material will be collected through the outlet of discharge at the bottom. The wasted air and fine power will be separated through cyclone.

本机组工作过程为料液通过隔膜高压输入，喷出雾状液滴，然后同热空气并流下降，大部分粉粒由塔底排料口收集，废气及其微小粉末经旋风分离器分离，废气由抽风机排出，粉末由设在旋风分离器下端的收粉筒收集，风机出口处还可以装备二级除尘装置，回收率在96-98%以上。

Cold smelting charge ratio was respectively 20%,25%,28%, by optimizing slag making and oxygen blowing process of dephosphorizing pretreatment period and decarburizing period,oxygen consumption rate increased from 20～30% to 40～50% than conventional process in dephosphorizing pretreatment period and slag charge was controlled at 8～15kg.t-1 in decarburizing pretreatment period.

在冷料比为20%、25%、28%条件下，通过优化脱磷、脱碳期供氧和造渣工艺，脱磷期耗氧比从传统工艺的20%～30%提高到30%～50%，脱碳期渣料加入量控制在8～15 kg.t-1.50炉工业试验结果表明，脱碳期一倒温度达到常规冶炼控制水平，一倒、控制水平明显好于常规冶炼工艺。

With the freeway volumes and natural environment, property of flexible pavements deteriorates gradually owing to asphalt aging and aggregate finning and structure changing of asphalt pavement.

硕士毕业设计道路沥青的老化与再生研究（共69页，34156字）摘要在交通载荷和自然因素的作用下，由于沥青逐渐老化、混合料集料细化以及路面受力结构层的变化，沥青路用性能逐渐恶化，甚至严重影响行车安全。

As the inner and outsider baskets rotate at the same speed, the inner one, pushed by the piston, reciprocates axially and repeatedly. As a result, pusher plate pushes the cake layer in the inner basket to move out of it and then into the outside basket for further separation , a ring layer of cake being formed,while the outside section of the inner basket pushes the cake layer in the outside basket to move continuously out of the outside basket and then discharge it through the slot for scraper.

内、外转鼓同速旋转的同时，在活塞推动下，内转鼓连续轴向往复运动，因而推料盘推动内转鼓滤饼层间歇不断地向外移动排出内转鼓，进入外转鼓进一步分离并形成环形滤饼层，内转鼓外端面则推动外转鼓滤饼层间歇不断地向外移动排出外转鼓，经刮料槽排出机外。

Several factors influence the tendency of an asphalt concrete to rut; those related to the mixture itself include asphalt cement content, filler content, and shape of the aggregate particles, with higher cement and/or filler contents and rounded coarse and/or fine aggregate particles resulting in an increased rutting tendency.

沥青混凝土发生车辙之倾向受到多个因素的影响。与混合物本身相关之因素包括沥青膏含量、填料含量及集料形状，具体而言，在沥青膏和／或填料含量高以及圆形粗和／或细集料条件下，沥青混凝土更易发生车辙。

Good mixing with air is necessary for high DRE of hazardous wastes with high heat value.Experiments on mean residence time in rotary kiln were executed and model of axial transport in rotating drum was built. Feed rate was firstly introduced into the practical equation for MRT when the holdup is less than 10%.

对影响回转窑内物料颗粒运动特性的因素进行了试验研究，发现在较低的回转窑填充率工况下，给料速率F对固体物料平均停留时间MRT有着较大的影响，首次在现有的回转窑内固体物料平均停留时间NRT计算经验公式中加入了影响因子给料速率F的影响关系。

Material is put into the drum from the feed end, then transported by blades from bottom to top of the drum, during which it is firstly separated, then combined, which continuously and repeatedly happen in a compound cycle.

物料在搅拌筒进料端起，在搅拌叶片的作用下随着搅拌筒从下部传递到上部，连续反复交替分散、合并形成复合循环的均匀混合并不断往出料端推进，达到快速连续混合

Feed aprons and stock guide plates with different angles and spacing are being equipped inside the cylinder, the structure can ensure that the material being dried runes along the direction of screwing under the impact of gravitation and keeps for a sufficient maintaining times and dispersity in the cylinder to make the material has sufficient heat exchange with the heat airflow from air heating furnace inside of the cylinder.

三筒烘干机是引进欧洲先进技术，由三个不同直径的同心圆筒彼此相嵌组合而成的。筒内装有不同角度和间距的扬料板和导料板，这种结构能够保证被烘干物料在重力作用下沿着螺旋的运动方向运动，在筒内保持足够的停留时间和充分的分散度，使被烘干物料在筒内与来自热风炉内的热气流进行充分的热交换。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。