下料

Analyzed the structure characteristics of the perfume cover outer shell plastics piece, described the piece's structure and work principle which model a craft and inject a mold, its principle :adopt and certainly be apart from bolt and spring coil and carry on two cents type, use inclined lead a side outside the pillar and take out heart, type the heart crest spare parts, while entering and anticipating adoption incubate the type sprinkle into anticipate a form, while opening a mold, with the ball head pull and anticipate a pole sprinkle and note system and anticipate, then make use of and take out and push plank and release a plastics piece inside a heart,use spring coil and reset first while matching a mold, then carry on willing model a beginning next time.

摘要分析了香水盖外壳塑件的结构特点，叙述了该塑件成型工艺、注射模的结构和工作原理，其原理是：采用定距螺钉和弹簧进行二次分型，用斜导柱外侧抽芯，型芯顶出零件，进料时采用潜伏式浇口进料形式，当开模的时候，用球头拉料杆把浇注系统凝料顶出，然后利用型芯内抽推板推出塑件，合模时用弹簧先复位，然后进行下一次成型开始。

Clay and gypsum will be transported into plant by trucks and unloaded into different bins in the crushing station, and then fed onto crusher by speed-governable apron feeder. Crushed materials will be fed onto auxiliary materials stockyard by belt conveyor.

由汽车运入厂区的粘土、石膏等生产辅助原料，分别卸入破碎站料仓内，经料仓下可调速的板式喂料机喂入破碎机进行破碎，破碎后的物料由出料带式输送机转运至辅助原料堆场。

Thick liquid material and bleaching the liquid to enter and bleach the tower after the high enriched mixing device is fully mixed, through bleach thick liquid material person who is distribute , tower of top drop from top of the tower , thick liquid material take to undergo 2 hours from top of the tower to the bottom of the tower, discharged by the spiral tripper of the bottom, enter and store the thick liquid pool.

浆料与漂液经高浓混合器充分混合后进入漂白塔，经过漂白塔顶部的浆料分布器从塔顶落下，浆料从塔顶到塔底需经过二小时，由底部的螺旋卸料装置排出，进入贮浆池。

This type of sprue puller works on the principle of withdrawing the sprue puller through a plate, such as a stripper plate or an underfeed floating cavity plate, in order to eject the feed system.

这种类型的主流道拉料是根据主流道拉料杆从一块模板上抽出的原理来顶出浇注系统的。这块模板可以是卸料板或是一块下进料式浮动型腔板。

Injection molding feed of Fe-Ni-Cu-C alloy coarse powder with particle size of 60um was prepared, effect of rate of shear, temperature and proportion of powder and binder to rheological behavior of feed was studied, viscosity number of three kinds of feed in different temperature was measured by capillary viscosimeter strain sensitivity factor three kinds of feed with different component were compared.

制备了平均粒度为60m的Fe-Ni-Cu-C合金粗粉汁射成形喂料，研究了剪切速率、温度、粉末和粘结剂比例对喂料流变行为的影响，应用毛细管粘度计测量了三种喂料在不同温度下的粘度值，比较了三种不同成分喂料的应变敏感性因子的大小。

Totally 60 semi-circular bending specimens cored from superpave gyratory compactor with three groups of notch depths are tested at the temperature of-10 and 20℃ The experimental results reveal good repeatability in EAM characterization. The tensile strength ratio of SCB to the indirect tensile test is at a range of 1.4 to 1.7, and the ultimate strength of EAM is exponentially dependent on the notch depths. At the test temperatures, the critical J-integral value of EAM is much higher than that of hot mix asphalt with thermoplastic asphalt binder. The response mode of EAM changes from ductile mode to brittle mode and the fracture energy increases 30% when temperature decreases from 20 to-10℃, while its critical J-integral value decreases only 15%.

结果表明，环氧沥青混合料的半圆弯曲试验结果复现性好；由非切口试件的半圆弯曲试验与标准间接拉伸试验所测得的环氧沥青混合料的抗拉强度，其比值在1.4~1.7之间，且SCB抗拉强度与切缝深度指数相关；在20℃与－10℃试验条件下，环氧沥青混合料具有比热塑性HMA高得多的临界J-积只分值；当温度由20℃降至－10℃时，环氧沥青混合料的响应模式由延性变为脆性，断裂能增加30%，而临界J-积分值下降15%。

Tests on road performance of SMA mixture with terylene long fiber and xylon fiber were conducted at both high temperature and low temperature. It was found that the resistances of lignin fiber to asphalt run-off, deflection at high temperature, and water damage were higher than those of terylene long fiber, while the effects of lignin fiber and terylene long fiber on anti-dispersion loss performance and anti-cracking performance at low temperature were basically similar.

通过沥青混合料路用性能试验，研究了涤纶长纤维与木质素纤维对SMA混合料高、低温等路用性质影响，发现同等掺量情况下，木质素纤维对SMA混合料抗析漏性能、抗高温变形性能和抗水损害的贡献好于涤纶长纤维；而二者对混合料的抗飞散损失性能和低温抗裂性能的影响基本相同。

Authors designed four mixtures of dense-graded asphalt stabilized macadam base with the method recommended by Technical Specifications for Construction of Highway Asphalt Pavement, Superpave design method, coarse aggregate voids filling method and Bailey method separately, and determined the pavement performances of asphalt stabilized macadam base mixture under the optimal oil-stone rate which include resistance capacity to vertical deformation and fatigue. Then, four design methods were compared and appraised. Based on the above study, a new asphalt-stabilized macadam base mixture gradation design method-five control sieve design method was put forward.

分别采用现行规范推荐法、Superpave法、主骨架空隙体积填充法和贝雷法设计了4种密级配沥青稳定碎石基层混合料，然后采用力学指标设计法确定了所设计的4种级配沥青稳定碎石基层混合料的最佳油石比，并对最佳油石比下的沥青稳定碎石基层混合料进行了抗永久变形性能和抗疲劳性能等路用性能的研究；根据设计过程和设计结果对4种级配设计方法进行了比较评价，在此基础上提出了新的密级配沥青稳定碎石基层混合料的级配设计方法－五控制点级配设计方法。

Authors designed four mixtures of dense-graded asphalt stabilized macadam base with the method recommended by Technical Specifications for Construction of Highway Asphalt Pavement,Superpave design method,coarse aggregate voids-filling method and Bailey method separately,and determined the pavement performances of asphalt stabilized macadam base mixture under the optimal oil-stone rate which include resistance capacity to vertical deformation and fatigue.

分别采用现行规范推荐法、Superpave法、主骨架空隙体积填充法和贝雷法设计了4种密级配沥青稳定碎石基层混合料，然后采用力学指标设计法确定了所设计的4种级配沥青稳定碎石基层混合料的最佳油石比，并对最佳油石比下的沥青稳定碎石基层混合料进行了抗永久变形性能和抗疲劳性能等路用性能的研究；根据设计过程和设计结果对4种级配设计方法进行了比较评价，在此基础上提出了新的密级配沥青稳定碎石基层混合料的级配设计方法——五控制点级配设计方法。

Based on the volume relationship of aggregate, asphalt, air voids V(subscript a and voids in mineral aggregate V(subscript MA in stone mastic asphalt, the relationship between V and asphalt content is discussed and an optimum asphalt content O(subscript AC equation is deduced.

根据沥青马蹄脂碎石混合料中集料、沥青、空隙率与矿料间隙率V(下标 MA之间的体积关系，推导了V与沥青用量之间的关系；论证了V对SMA混合料级配的影响；讨论了V与级配之间的关系。

We have no common name for a mime of Sophron or Xenarchus and a Socratic Conversation; and we should still be without one even if the imitation in the two instances were in trimeters or elegiacs or some other kind of verse--though it is the way with people to tack on 'poet' to the name of a metre, and talk of elegiac-poets and epic-poets, thinking that they call them poets not by reason of the imitative nature of their work, but indiscriminately by reason of the metre they write in.

索夫农 、森那库斯和苏格拉底式的对话采用的模仿没有一个公共的名称；三音步诗、挽歌体或其他类型的诗的模仿也没有——人们把&诗人&这一名词和格律名称结合到一起，称之为挽歌体诗人或者史诗诗人，他们被称为诗人，似乎只是因为遵守格律写作，而非他们作品的模仿本质。

The relationship between communicative competence and grammar teaching should be that of the ends and the means.

交际能力和语法的关系应该是目标与途径的关系。