上部位

As indicated by the cross-hatching in Figure 6B, the center-most PDL has one nearest neighbor PDS above it along the vertical dimension, one nearest neighbor PDS below it along the vertical dimension, one nearest neighbor PDS to the right in the horizontal dimension, and one to the left along the horizontal dimension.

如图六B中交叉区块所描绘者，最中间的光电二极体PDL部位的垂直方向上有一最靠近的光电二极体PDS部位位於其上方，一个最靠近的光电二极体PDS部位位於其下方，以及一个最靠近的光电二极体PDS部位位於水平方向上的左方，一个最靠近的光电二极体PDS部位位於水平方向上的右方。

It was suggest that the yield of tobacco in unit area was significant increasing and the quality was improved along with the altitude increase in Liuyang tobacco area. The tobacco leaves production at the place where the altitude from 400 meter and 900 meter was propitious to postpone the bearing period and growth and development of tobacco plants. It was the base of maturation endurance and could advance the tobacco leave maturation degree of all parts of tobacco plant. And it could hasten the orange tobacco leave ratio of the whole tobacco plant. It was boosted leaves unwrapping of top tobacco plant and the statuses of tobacco leaves, especially the top leaves, were significantly improved. The tissue structure of all parts leaves on tobacco plant were more loosen and the colour and luster of tobacco leaves was more vivid. The nicotinamide content in top leaves were digressive at a certain extent, on the contrary, the contents of the reductive sugar and kalium were increased at different extent. At the same time, it was benefit to play down the pesticide rudimentai of tobacco leaves and increased security of tobacco leaves.

结果表明：在浏阳烟区随着海拔高度的增加，单位面积烟叶的产量有着明显的增加，烟叶质量也有一定程度的改善；在海拔400—900m的地方进行烟叶生产，有利于延长烟株大田生育期，有效缓解浏阳烟区7、8月份的高温逼熟现象，有利于烟株的生长发育，为养好烟株的耐熟性打下良好的基础、促进各部位烟叶成熟度的提高；同时可以有效的促进烟株各部位橘黄烟叶比例的上升，对上部烟叶的开片也有着明显的促进作用，烟叶身份特别是上部烟叶的身份得到明显的改善，各部位烟叶组织结构更加疏松，烟叶色泽更加鲜亮；上部烟叶烟碱含量在一定程度上有所降低，各部位烟叶还原糖、钾含量有着不同程度的增加烟叶香气特征更加明显；香气量有一定程度的增加，吸位更加醇和、余味舒适；同时也有利于减少烟叶的农药残留量，提高烟叶的安全性。

Therefore, for to QL treatment prostate gland disease effective component screening, first uses 95% ethyl alcohol backflow to raise Takes, the recycling ethyl alcohol, the watering dissolves, divides into the water-soluble spot and the water does not dissolve the spot, on Shui Jianye the pocket resin divides into the laundering spot and mellowly washes the spot.

因此，为了对QL治疗前列腺疾病有效成分的筛选，首先用95%乙醇回流提取，回收乙醇，加水溶解，分成水溶部位和水不溶部位，水煎液上大孔树脂分成水洗部位和醇洗部位。

If you bend down, you can reduce this bending parts of teeth pad and nano-imprint lithography drum of gaps can be reduced by this bending parts of clishion and siowal paper teeth to feed of the top of the gap; if the multiplicable this bending parts of teeth pad and nano-imprint lithography drum of gaps could be increased by the curved parts of clishion and siowal paper teeth to feed the gap.

如果往下笔直，可裁减此笔直部位的递纸牙垫与压印滚筒的间隙，也可裁减此笔直部位递纸牙垫与给纸台的间隙；如果往上笔直，可补充此笔直部位的递纸牙垫与压印滚筒的间隙，也可补充此笔直部位递纸牙垫与给纸台的间隙。

For each subject, the buccolingual bone thickness was measured by postulating that the miniscrews would be inserted at 16 positions (10, 12, 14 and 16 mm above the median sagittal planes of the interradicular spaces between the first molars and the second premolars in the maxilla, and 30°, 45°, 60°, 90° from the cortical bone surface).

在重建后的锥形线束CT影像上测量上颌第二前磨牙与第一磨牙牙根间矢状面上距离参考平面10，12，14，16 mm的4个植入高度上，以与骨皮质表面成30°，45°，60°，90°的4个方向共16个部位的颊舌侧骨质厚度，计算各植入部位触及上颌窦的危险率，在骨厚度大于6 mm的植入部位模拟植入微螺钉种植体并测量其周围骨质密度。

The abdominal wall in the left lower quadrant, 2 finger breadths (3 cm) cephalad and 2 finger breadths medial to the anterior superior iliac spine, has been shown to be thinner and with a larger pool of fluid than the midline and is usually a good choice for needle insertion for performance of a therapeutic paracentesis.27 The right lower quadrant may be a suboptimal choice in the setting of a dilated cecum or an appendectomy scar.

在过去，常常将腹部正中线耻骨与肚脐中间定为穿刺点，现在，由于腹腔穿刺引流大量液体以及腹中部脂肪厚度增加，左下腹成为腹腔穿刺部位（表1），在左下腹部中线至髂前上棘连线上2指宽（3cm）与距髂前上棘2指宽，已经显示较中部脂肪少及腹水较多是治疗性腹腔穿刺好的首选部位27，在盲肠有扩张或阑尾切除术后瘢痕时右下腹是次选的穿刺部位，应避开腹壁下动脉，这些血管走行在耻骨与髂前上棘之间的中线然后在腹直肌中向上行走，，腹壁可见的侧支循环亦应该避开，腹腔镜检查发现侧支循环可出现在中线并且在腹腔穿刺时有导致血管破裂的风险28。

When the parameter matching of the wheel location is improper, namely, the matching between the wheel toe-in and the wheel camber angle is ill-suited, abrasion of the two wheels of the same steering axle is inside or outside simultaneously, because of wheels sideslip. However, when double-front-axle steering system failure take place, abrasion of the two wheels of the same steering axle is in the same side, and that, tyre abrasion direction of front and back steering axles is rightabout. That is to say, if tyre abrasion of front steering axle lie in the left side, tyre abrasion of back steering axle lie in the right side to a certainty, which is the rule of tyre abrasion of double-front-axle steering automobile.

当定位参数匹配不当时，同一转向轴上左右车轮的磨损部位都在内侧或外侧，原因是左右车轮在滚动的同时还要产生相向或反向侧滑；而双前轴转向汽车前、后转向轴引导汽车转向方向不一致时，同一转向轴左、右车轮的磨损部位都在同一侧，而且前、后转向轴上的车轮偏磨损方向正好相反，即如果前转向轴左、右车轮磨损部位在左侧或右侧，那么后转向轴左、右车轮磨损部位就在右侧或左侧，这是双前轴转向汽车特有的轮胎磨损规律。

After the drum on the treatment is the key to a new after the paper in a zhangba unwatering of copy paper, print this screen you will pass a carbon into drum in a white, then remove the copy paper, so that the screen is clearly see what parts should be single pad and which parts do not pad, and which part should be dredged, dredged area must have a slope should be completed on the knife, which lost network and wrapped a drum after proofing effect, when you are satisfied you can open mechanism cards and membership cards.

版上好后滚筒的办理不离是盖脚换上陈的滚筒纸后本质不收一张八开的复写纸，不收空印一次这样网版不离会堵住复写纸印到滚筒边的白纸上，然后把复写纸掏出，这样网版不离澄辉不天看出哪些部位不该独垫，哪些部位不垫，哪些部位不该挖去，挖去的部位必定用不该小刀修成有坡度，这样不会失网点，包好滚筒后打样一张看成果，如果不满即可开机制卡和会员卡制作。

Under the microenvironments of fruit bagging,Alternaria had always been the major fungi in different bags,sites of fruit and weather conditions during the whole growing season. As the secondary major fungi,Penicillium had always been after July and emerged later in inner bag and cortical pore than other sites.In the bag with which the inner bag was red and waxing,Trichoderma was isolated first in pericarp without cortical pore and inner bag as well as later in cortical pore after August.In \'Kobayashi\' bag which inner bag was red and waxing, Aspergillus and Fusarium were isolated in pericarp without cortical pore and cortical pore after bag removed.Alternaria and Penicillium were isolated in unbagging fruit and \'Qianwei\' bag which inner bag was red and unwaxing and the date Penicillium was isolated in CK was 45d later than bagging treatment.Under high temperature weather condition,there were no differences in the fungi population structure on fruit surface among all treatments.And the fungi population structure on fruit surface in bagging apple was more than that of unbagging ones under overcast and rainy condition.

在苹果套袋微域环境下，不同育果袋、果实不同部位、不同时期、不同气象条件下的真菌主要是链格孢霉，且在套袋后的整个生长季均可分离到；青霉为第二大真菌，在7月份后均可分离到，在非皮孔部位的出现要早于内果袋和皮孔部位；8月份后在内袋红色涂蜡的育果袋上分离出了木霉，其先出现在非皮孔处和内果袋，然后出现在皮孔处；曲霉和镰刀菌仅在内袋红色涂蜡的&小林&袋的非皮孔部位和皮孔部位于摘袋后分离出；在内袋为黑色且未涂蜡的育果袋和未套袋果上仅仅分离出链格孢霉和青霉，且青霉分离出的时期要比套袋果晚45d。

The result of rooting experiment in the phytotron indicated that 25/20℃ resulted in more roots and 30/25℃ resulted in longer roots with higher dry weight.

在变叶木插穗的取穗标准试验中，试验结果显示，取穗时应取枝条上部位且较长，至少带有4片叶的插穗。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐