上水泵

And the pump mounting height should be allowed to deduct a high vacuum suction on the suction pipe head loss, the remaining portion of the value, it is to overcome the actual water height of the terrain.

而水泵安装高度应该是允许吸上真空高度扣除了吸水管道损失扬程以后，所剩下的那部分数值，它要克服实际地形吸水高度。

Pumps installed in the rolling bearing for the motor, bearings should be removed outside the cover, and then release the fastening screw cover and base shell and cover the seams to do a good job marking (both before and after the end of tag should not be covered the same), will cover the unloading of the fastening screw screwed into the expertise of the Motor Cover Screw in the two settings will be the top cover.

水泵中对于装有滚动轴承的电机，应先拆下轴承外盖，再松开端盖的紧固螺钉，并在端盖与机座外壳的接缝处做好标记（前后两个端盖的标记不应相同），将卸下的紧固端盖的螺钉拧入电机端盖上专门设置的两个螺孔中，将端盖顶出。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。