上模

Based on the principle analysis,this paper compares the integrated absolute error value of two kinds of controllers,and this reflects the superiority of internal model controller in some way.

该文分析和比较了内模控制器和PI控制器在克服时间滞后方面原理的不同；并在分析原理的基础上，通过仿真实现了两者在绝对误差积分方面的比较，在一定程度上反映了内模控制器比PI控制器优

Among those; studies, Liu and Bek have obtained many important results for the theory and applications of Banach spaces and their geometry on complex number,(see [3],[41])Here, we have investigated the TP modulus of convexity and TP modulus of smoothness, on the one hand, we have defined a class of new spaces called uniformly TP convex ,on the other hand, we have extended martingale inequalities and the martingale spaces.This article is divided into four parts, in the first part, we define the TP modulus of convexity and TP modulus of smoothness of Banach space, and prove that the space which is characterized by uniform convexity is same as the space which is characterized by TP uniform convexity. Then we give TP q-uniformly convex and TP p-uniformly smoothable characterization of the Banach space. At the same time, we prove the famous renormed theorem.

本文分为四部分，第一部分在Banach空间上定义了一个新的TP凸性模和TP光滑模并证明了在Banach空间上它分别和一致凸性和一致光滑性刻划的空间是同构的，即如果Banach空间X是一致TP凸的充分必要条件是存在一个等价范数，使得在此范数下，它是一致凸的；Banach空间X是一致TP光滑的充分必要条件是存在一个等价范数，使得在此范数下，它是一致光滑的，我们还分别得出了判定一致TP凸和一致TP光滑的一些充分必要条件，同时还证明了箸名的重赋范定理。

In chapter 4, we retroduce monoial category and center over it. moreover, we introduce weak center over weak hopf π coalgebra. After studying of the relationship between it and Yetter-Drinfeld moduels, we could found they are isomophic.

第五章主要讨论了弱Hopf群余代数上的弱相对Hop(来源：Ab9BC论文网www.abclunwen.com)f群余模，引入了迹运算，中心等，在此基础上对弱相对Hopf群余模的研究。

Besides covering the low, middle, and high end in regard to price, Unicom, with the introduction and more types of dual mode and standby cell phones, is making groundbreaking adjustment to its sales mode as well, as it included Coolpad 288, a dual mode and dual standby cell phone, into the GSM channels for sales.

除了价格上对高、中、低端的全面覆盖，随着双模双待机型的不断增加，联通在销售模式上也做了突破性调整：首次将双模双待机酷派288纳入到GSM的渠道加以销售。

And with reference to Figure 1, the treatment line (18) on the plug (10) inserted into the output jack (9), the other side of the two output electrodes, respectively, to insert ear plug mold, patches, foot molds and correct placement in the body or body parts protruding point on.

并参照图1，将诊疗线（18）上的插塞（10）插入输出插口（9），另一端两个输出电极插塞分别插入耳模、贴片、脚模等，并将其正确安置在人体凸出部位或体穴上。

By replacing pseudo-Mersenne numbers with generalized Mersenne numbers, we propose a new notion-Generalized Optimal Extension Fields, and study the fast arithmetic about multiplication and modular arithmetic in GOEFs.

利用广义Mersenne数代替伪Mersenne数，提出了广义最优扩域的概念，并研究其上的快速乘法运算和取模运算，为乘法运算给出了通用的复杂度公式，为取模运算给出了具体的运算公式，推广了Bailey，Mihailescu和Woodbury等在最优扩域上的相应结果。

For detail,we studied the Incidence Algebra I defined by finite Partially Ordered Set X,and sheaf F based on the topology T_x defined by the partial order;By studying the relation between finite module category mod I and the sheaf category Sh_x A,we proved that they are equivalent.

特别的，对给定的有限偏序集X确定的Incidence代数Ⅰ，及由X的序关系定义的拓扑结构T_X上的层F，通过考查有限模范畴modⅠ与层范畴Sh_XA之间的关系，证明了Incidence代数上的模范畴与层范畴的等价性。

According to the theory of wavelet transformation, the singularities of the ECG signal are corresponding to the series of maximum-minimum pairs. The algorithm detects the onsets of Q wave at the scale 3 detail and offsets of T wave at the scale 4 detail. So the duration of QT is calculated by onset of Q wave and offset of T wave.

根据小波变换的原理，心电中的奇异点在变换后将产生一个模极大值和模极小值对，在小波变换3尺度上检测出QRS波群的起点，在小波变换4尺度上检测出T波终点，从而确定QT间期。

Some of the mode frequencies can be explained by the formula deduced from the eigenmode theory of resonant cavity.

这些现象，有些可利用在谐振腔本征模理论基础上导出的公式来解释，另外一些可能是由于像散和畸变引起腔的横模分裂，从而导致复杂的模拍效应。

On the base of the concept, we give the Schanual Lemma about weak injective modules and discuss the properties of the homomorphisms which can be extended in weak injective modules.

Kerβ的β∈Hom_R，都存在γ∈Hom_R使得β=γα成立，则称T为N-弱内射R-模，且称α为T与M的相伴同态。在此定义的基础上我们给出了弱内射模的Schanuel引理，讨论了弱内射模中能进行开拓的同态的性质。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。