上侧

Must ensure that the car has concentric outer circle with the machine tool spindle (Micrometer can be measured on the surface of the workpiece has been processed on the side of the bus and bus).

必须保证已车外圆与机床主轴同心（可用千分表测工件已加工表面的侧母线和上母线）。

Study of the changes of mandibular condyle position before and after fixed bridges in heavy abrison and TMD patients

方法在40侧成人下肢标本上，解剖观测股骨外侧髁和股骨下段前面的血管来源、走行、分支和吻合情况。

Because the effects of static electricity, and some will make the paper in the paper tape on the position to turn aside, the side or front edge of the regulation cannot, the base was taken into the arrival and departure of the calibration paper is also easy to normal; because dual-Zhang conglutinate, double sheet of fault arising out of the auto-stop, affecting efficiency.

因为静电的感化，有的会使纸弛在负纸带上爆不收场所垂直，侧规或后规无法举行基准边校准，不退到不收纸台时也易变态下落；因为独弛的粘连，还会呈现独弛障碍而爆不收被迫停机，感化了不败果。

HCN in sidestream smoke was captured by sodium hydroxide solution and determined by continuous flow analyzer.

建立了一种用稀氢氧化钠溶液吸收、应用异烟酸与1，3-二甲基巴比妥酸显色体系在连续流动分析仪上检测卷烟侧流烟气中HCN的方法。

Through esterification of functionality —COOM on side chains of xanthan gum by 1-bromooctane,water soluble hydrophobically modified xanthan gums of octyl substitution 11 and 21 per 100 structural units,HMXG-C8-11 and-21,are prepared.

用1-溴代辛烷使黄原胶XG侧链上的—COOM基团酯化，得到以100结构单元计取代度为11和21的水溶性疏水改性黄原胶HMXG-C8-11和-21。

To image plane coordinate An ipsilateral total tangent algorithm is proposed in the paper, and the algorithm is proved to be effective for solving the coordinate transformation matrix by an example.

为了解决数码相机定位问题，利用双目定位法，在确定物平面坐标系与像平面坐标系的坐标变换矩阵的基础上，提出了一种同侧共切线算法，结合算例证明了这种算法可以有效地求解此坐标变换矩阵。

Sepals 3(or 5); lateral sepals free or connate, margins entire or serrate; lower sepal large, petaloid, usually navicular, funnelform, saccate, or cornute, tapering or abruptly constricted into a nectariferous spur broadly or narrowly filiform, straight, curved, incurved, or ± coiled, swollen at tip, or pointed, rarely 2-lobed, rarely without spur. Petals 5, free, upper petal flat or cucullate, small or large, often crested abaxially, lateral petals free or united in pairs. Stamens 5, alternating with petals, connate or nearly so into a ring surrounding ovary and stigma, falling off in one piece before stigma ripens; filaments short, flat with a scalelike appendage inside; anthers 2-celled, connivent, opening by a slit or pore.

萼片3(或5)；侧萼片离生或者合生，边缘全缘或者有锯齿；更低的萼片大，瓣状，通常舟形，漏斗状，囊状，或具角状突起，渐减突然或缢缩进一分泌蜜汁具距或宽狭丝状，花瓣5，离生，上面的花瓣平坦的或者兜状，雄蕊5，与花瓣互生，合生或者近合生成环而围绕子房和柱头，在柱头成熟之前完整地从上面落下；花丝短，扁平，在里面的有一鳞片状附属物；花药2室，靠合，通过一条裂缝或者孔开裂。

New more aerodynamic upper and side exhaust vent cowling, sculpted to enhance stability while increasing exhaust efficiency.

新的空气动力学上和侧排气口罩，雕刻，以增强稳定性，同时提高排气效率。

The results show, it have not so much difference of aerodynamic characteristic between titling train negotiating curve and traveling on level track under the conditions of no crosswind.

结果表明，在无侧向风作用的情况下，列车过曲线的空气动力学特征和直线上相似。

By considering torque characteristics of variable-frequency motors and mesh stiffness as well as backlash nonlinearity in gear transmission,a dynamics model for the cutting system of shield tunneling machine with redundant drives was established. The fluctuation characteristics of torque loads and dynamic cutterhead driving torque in composite strata were analyzed.

复合地层掘进扭矩载荷突变是造成盾构机掘进过程中堵转停机的直接原因，考虑盾构机刀盘驱动变频调速电机特性、转矩传递过程中齿轮啮合刚度及齿侧间隙等非线性因素，建立冗余驱动的盾构机刀盘切削系统机电耦合动力学模型；针对典型复合地层地质条件，对盾构机在上软下硬地层掘进过程中刀盘驱动转矩动态特性进行仿真分析。

In the negative and interrogative forms, of course, this is identical to the non-emphatic forms.

。但是，在否定句或疑问句里，这种带有"do"的方法表达的效果却没有什么强调的意思。

Go down on one's knees;kneel down

屈膝跪下。。。下跪祈祷