上侧

Middle tooth of upper lip of calyx wider than lateral teeth, circular-ovate; lateral teeth broadly lanceolate to narrowly triangular.

中间齿的上唇的花萼宽比侧齿，圆卵形；侧的齿宽披针形的到狭三角形。

Or take that black silhouette again, enliven with shadow the thousand acute angles of the spires and gables, and make it start out more toothed than a shark's jaw against a copper-colored western sky,--and then compare.

要不，您就再现那黑黝黝的侧影，用阴影复活尖塔和山墙的无数尖角，并使乌黑的侧影突现在落日时分赤铜色的天幕上，其齿形的边缘胜似鲨鱼的颔额。——然后，您就比较一下吧。

In comparison with bugle shaped nozzle, bifurcated nozzle downward jet angle 45°, cow-nose nozzle and three-hole nozzle, in all, the last two are better than the former and bifurcated nozzle downward jet angle 45 is better than bugle shaped nozzle; Cow-nose nozzle is helpful for guaranteeing the product's quality, in order to protect jet flow from eroding the strand at narrow face, gain uniform temperature distribution at cross section and decrease heat flux, adding the block's width to 100 mm. Three-hole nozzle is advantageous to increase flux and casting speed, but should avoid weak shell thickness in the center broad. In the real production, setting the SEN's immersed depth or plugging the hole at the bottom can adjust the flow and temperature distribution in the mold.

对比喇叭形水口，双侧孔水口(45°)，牛鼻子水口和三孔水口，总的说来后两者优于前两者；而双侧孔水口(45°)又优于喇叭形水口；牛鼻子水口和三孔水口比较各有特点，前者对保证铸坯质量有利，为防止流股对窄面的冲击，增加挡块宽度到100 mm，可使结晶器横截面上温度分布更加均匀，降低窄面热负荷；后者对增加流量，提高拉速非常有利，但要防止中孔射流过强导致铸坯中心坯壳变薄，在实际生产中可通过控制水口浸入深度或塞住浸入式水口的底孔来调节结晶器中的流动与温度分布状态。

In comparison with bugle shaped nozzle, bifurcated nozzle downward jet angle 45°, cow-nose nozzle and three-hole nozzle, in all, the last two are better than the former and bifurcated nozzle downward jet angle 45 is better than bugle shaped nozzle; Cow-nose nozzle is helpful for guaranteeing the product"s quality, in order to protect jet flow from eroding the strand at narrow face, gain uniform temperature distribution at cross section and decrease heat flux, adding the block"s width to 100 mm. Three-hole nozzle is advantageous to increase flux and casting speed, but should avoid weak shell thickness in the center broad. In the real production, setting the SENs immersed depth or plugging the hole at the bottom can adjust the flow and temperature distribution in the mold.

对比喇叭形水口，双侧孔水口(45°)，牛鼻子水口和三孔水口，总的说来后两者优于前两者；而双侧孔水口(45°)又优于喇叭形水口；牛鼻子水口和三孔水口比较各有特点，前者对保证铸坯质量有利，为防止流股对窄面的冲击，增加挡块宽度到100 mm，可使结晶器横截面上温度分布更加均匀，降低窄面热负荷；后者对增加流量，提高拉速非常有利，但要防止中孔射流过强导致铸坯中心坯壳变薄，在实际生产中可通过控制水口浸入深度或塞住浸入式水口的底孔来调节结晶器中的流动与温度分布状态。

So I feel slightly pressured to attempt movements I normally would never do—handstands, flips, diving over a bamboo rod, rolling left and right on my shoulders, 11 cartwheels , and 12 somersaults , and a running handstand flip to land on my feet.

因此我稍微感到压力，试着做了我通常不做的动作：手倒立、翻筋斗、撑竹竿跳、侧滚翻、侧手翻、空翻，以及掌上翻筋斗并站立落地的连续动作。

The initial point of collateral ligament was drilled two holes, 2 to 3 mm in distance, and crossed by steel wire. Then the superficial flexor tendon of finger was crossed under the steel wire and sutured to the terminal point of superficial flexor tendon of finger by 5/0 to 7/0 nontraumatic suture thread to maintain suitable tension, and sutured to collateral ligament by 8/0 nontraumatic suture thread.

用细克氏针在侧副韧带起点处向健侧钻两个相距2～3 mm骨孔穿过钢丝，切开屈肌腱鞘，从指浅屈肌腱一侧近端切取所需长度肌腱束，此肌腱束穿过钢丝孔，保持肌腱束的合适张力，用5/0～7/0无创线缝合于浅腱止点，应用8/0针线将肌腱束缝合于韧带上。

Then the superficial flexor tendon of finger was crossed under the steel wire and sutured to the terminal point of superficial flexor tendon of finger by 5/0 to 7/0 nontraumatic suture thread to maintain suitable tension, and sutured to collateral ligament by 8/0 nontraumatic suture thread.

用细克氏针在侧副韧带起点处向健侧钻两个相距2～3 mm骨孔穿过钢丝，切开屈肌腱鞘，从指浅屈肌腱一侧近端切取所需长度肌腱束，此肌腱束穿过钢丝孔，保持肌腱束的合适张力，用5/0～7/0无创线缝合于浅腱止点，应用8/0针线将肌腱束缝合于韧带上。

Linear regression method was used to analyze the correlation between facial height index and inclination of palatal plane, occlusal plane and mandibular plane in normal occlusion, and to establish floating norm diagram.

选取青少年正常头影侧位片158张及安氏Ⅱ类1分类错头影侧位片246张，利用线性回归法分析正常不同生长型的面高指数与腭平面、平面及下颌平面倾斜度的相关性，建立浮动正常值表，分析正常及安氏Ⅱ类1分类错不同生长型的上下颌骨的旋转类型。

The lingual nerve and its neigh-bouring structures were investigatedon 33 sides of head-neck specimensand 61 mandibulae .

在33侧成人头颈部标本和61块下颌骨标本上对舌神经在下颌第三磨牙舌侧区的位置及其与周围结构的毗邻关系进行了观测。

The lingual nerve and its neigh-bouring structures were investigatedon 33 sides of head-neck specimensand 61 mandibulae.At median line ofthe third molar,the distance betweenthe lingual nerve and the gingive me-asures 11.7mm.

在33侧成人头颈部标本和61块下颌骨标本上对舌神经在下颌第三磨牙舌侧区的位置及其与周围结构的毗邻关系进行了观测。

Breath, muscle contraction of the buttocks; arch body, as far as possible to hold his head, right leg straight towards the ceiling (peg-leg knee in order to avoid muscle tension).

呼气，收缩臀部肌肉；拱起身体，尽量抬起头来，右腿伸直朝向天花板（膝微屈，以避免肌肉紧张）。

The cost of moving grain food products was unchanged from May, but year over year are up 8%.

粮食产品的运输费用与5月份相比没有变化，但却比去年同期高8％。