三维

The comparison of the simulations of the same perturbation in 2D and 3D shows that both are similar before the perturbation arrives at 7 solar radii, and that both have the observed three parts of the classical CMEs. However, the reflecting effect of the adopted boundary conditions at both poles in the 3D simulation has a significant effect on the simulation of more hours, and causes unphysical changes in the polar region, such as the enhancement of density and the change of the magnetic field topology.

从对相同扰动的二维和三维模拟结果的对比来看，在扰动到达7个太阳半径之前，模拟结果相似，都可以模拟出CMEs事件的三部分观测特征，但是三维模拟采用的两极边界条件存在的反射效应，对更长时间的模拟有明显的影响，在两极产生密度增强和磁场位形发生较大变化两个非物理扰动。

Methods: We collected 121 of clinical isolates of Enterobacter, including 87 isolates Enterobacter cloacae, 34 isolates Enterobacter aerogenes, all of the isolates were detected by cefoxitin three-dimension test, drug resistance phenotypes estimation, cloxacillin disc synergy test and cloxacillin-potentiated disc diffusion test respectively to find high-level AmpC β-lactamase isolates, drug resistance phenotypes estimation were also used to detected high induction producing AmpC β-lactamases isolates, meanwhile, we took three-dimension test as standard method, and compared to other methods, then calculated the coincidence rates, sensitivities and specificities of them.

采用头孢西丁三维实验、纸片耐药表型推断法、邻氯西林纸片协同法、双纸片邻氯西林增效试验分别检测高产AmpCβ-内酰胺酶株，获得高产AmpC酶在肠杆菌属细菌中的表达状况。采用纸片耐药表型推断法检测诱导和高产AmpC酶，同时以头孢西丁三维实验为标准，其他三种方法与之相比较，分析它们检测高产AmpC酶的符合率、灵敏度和特异性。

Mallory trichrism staining exhibited light blue samples. Eight weeks following repair, CT showed round blunt defect edges in the coronal position, which had bony pustute connection with gel materials. Density at the defect region significantly increased. 3D reconstruction suggested that defects became small. After hematoxylin-eosin staining, abundant fibrous connective tissue appeared in defect regions, with bony tissues. Mallory trichrism staining revealed that maroon mature bone tissues were found, surrounded by light blue chondroid tissues. Twelve weeks following repair, coronal defect regions were filled with callus. 3D reconstruction showed that defects were repaired. Defect region and surrounding bony tissues had bony connection, with thick bone trabecula and mature Haversian system.

修复后8周，冠状位CT显示缺损边缘圆钝，与凝胶材料有骨性突起连接，缺损处密度增高明显，三维重建显示缺损范围较之前有所减小；标本苏木精－伊红染色后缺损部可见大量含血管成分的纤维结缔组织，有骨样组织结构形成，Mallory三色染色显示有褐红色成熟骨组织形成，其旁边有淡蓝色软骨样组织修复后12周，冠状位CT显示缺损区基本被骨痂填满，三维重建示缺损基本修复；缺损区域和周围骨组织形成骨性结合，骨小梁粗大，哈弗氏系统成熟。

In order to get the 'three parameters changeable' formulaof the nonlinear spring design engineering, spring diameter, spring wirediameter and helix angle changed coinstantaneous based on spring designtheory that wildly used before is considered, the model results is showedsuccessfully in Unigraphics Solutions software by using Ugopen/APItechnology.

本文中通过考虑弹簧螺旋角的影响，在原有弹簧设计理论的基础上，通过同时改变弹簧中径、簧丝直径和螺旋角三个螺旋弹簧设计参数的方法，得到了满足刚度性能要求的&三变&螺旋弹簧的设计方法，并在三维CAD软件UGII中成功的实现了这种弹簧的三维实体数据模型的建立工作。

On this basis, using the same theories and methods, we set up the three-dimensional steady-state models of ideal well productivity about a reverse double-branch horizontal wells, the three branches of radial horizontal wells, fish-bone shape three branches horizontal wells and two-dimensional four branches horizontal wells In five reservoirs respectively.

在此基础之上，运用同样的理论和方法，建立了反向双分支水平井、辐射状三分支水平井、鱼骨形三分支水平井和二维四分支水平井这四种分支水平井分别在以上五种油藏中的三维稳态理想井产能模型。

In order to study local scouring field near the pier with sediment control dam ,the 3-D velocity field of the pier in monomer model is subtly measured by ADV velocimeter of Sontek.

采用Sontek公司声学多普勒测速仪对有拦沙坝防护的模型桥墩附近流场进行了精细测量，对桥墩冲刷坑内三维流速分布进行了分析，给出了冲刷坑内三维紊动特征量的分布，分析研究了有拦沙防护坝时桥墩局部冲刷的三个新特点，提出了拦沙坝的适用条件。

In order to study local scouring field near the pier with sediment control dam, the 3-D velocity field of the pier in monomer model is subtly measured by ADV velocimeter of Sontek. This paper analyses the velocity distribution in the scouring pool of pier and takes turbulent strength distribution in different direction. Three new characters for the local scours of piers with the sediment control dam are analyzed and the dam's applicability is brought forward.

采用Sontek公司声学多普勒测速仪对有拦沙坝防护的模型桥墩附近流场进行了精细测量，对桥墩冲刷坑内三维流速分布进行了分析，给出了冲刷坑内三维紊动特征量的分布，分析研究了有拦沙防护坝时桥墩局部冲刷的三个新特点，提出了拦沙坝的适用条件。

In Chapter 3, the prior estimates about the 3-D difference solution and its difference quotients on time space and geometry space are made by means of discrete functional analysis, so that the stability and the convergence of the 3-D difference solution are obtained.

在第三章中，运用离散泛函分析的手段，对三维中子输运方程的差分解及其时间、空间差商进行了先验估计，从而得到了差分解的稳定性和收敛性，也为三维问题的应用研究打下了初步的理论基础。

In order to understand the swirl system deeply,the three-dimensional particle dynamic analyzer was used to measure the velocities of the steady turbulent cold flows in the swirl three-branched modular junction located at the end of the exhaust system,and three-dimensional numerical simulation of the flows was carried out by use of the ALE algorithm.

为了深入研究螺旋流排气系统的工作机理，作者利用三维粒子动态分析仪(3D-PDA)，对一始端螺旋流三分支模件的稳态湍流流场进行了测量，并用ALE法进行了三维流动数值模拟。

We obtained the nasal deformation with three-dimensional reconstruction images and adjusted to separate the images of nasal cartilage, defined the form and structure of nasal deformation. Then we measured 10 cases of adult cadavers nasal alar, lateral and septal cartilage through modern mechanical measuring instruments, to obtain the elastic modulus of above three part structure of nasal cartilage, then to obtain more accurate nasal cartilage elastic modulus data through statistical analysis. At the same time, according to the relevant literature, we obtained nasal soft tissue biomechanical properties, mainly were elastic modulus and Poisson\'s ratio. Finally we established three-dimensional finite element analysis model of unilateral cleft lip nasal deformation, defined the model\'s constraint conditions and carried out biomechanical measurement and analysis of unilateral cleft lip nasal deformation.

将唇裂鼻畸形患者鼻部进行三维重建并调校，分离出外鼻软骨的影像，并对鼻部组织进行分层和重建，确定畸形鼻的形态和组织结构；通过现代力学测量仪器，对10例成人尸体鼻部的大翼、侧鼻和中隔软骨进行弹性模量的测量，获得上述三部分鼻部软骨结构的弹性模量数据，并通过统计学分析来获得较为准确的鼻部软骨结构的弹性模量数据，同时查阅相关文献，得到鼻部软组织的相关生物力学性质，主要为弹性模量和泊松比；建立单侧唇裂鼻畸形的畸形鼻部三维有限元分析模型，确定有限元分析的边界条件等，进行单侧唇裂鼻畸形的鼻部生物力学的测量和分析。

Do you know, i need you to come back

你知道吗，我需要你回来

Yang yinshu、Wang xiangsheng、Li decang,The first discovery of haemaphysalis conicinna.

1〕 杨银书，王祥生，李德昌。安徽省首次发现嗜群血蜱。