三的

Jiangsu Anpon Electrical Chemistry Co., Ltd., Huaian 223002, Jiangsu, China Abstract: 2-Amino-4,6-dimethoxy-1,3,5-triazine, an important intermediate for preparing cinosulfuron, was synthesized utilizing 2,4,6-trichloro-1,3,5-triazine as raw material via ammonization, methoxylation. The purity was 96.0% and the average yield was 90.4%.

江苏安邦电化有限公司，江苏淮安 223002 摘要：2-氨基-4，6-二甲氧基-1，3，5-三嗪是合成醚磺隆的重要中间体，以三聚氯氰为起始原料，经氨化、甲氧基化中试反应得到2-氨基-4，6-二甲氧基-1，3，5-三嗪，纯度为96.0%，平均收率90.4%。

Tri--1,3,5-triazin, an ashless and phosphorus free water-soluble compound, was synthesized and its structure was analyzed by infrared spectroscopy.

对摩擦性能优良的三嗪杂环进行水溶性改良，合成了一种无灰无磷水基润滑添加剂2 ，4 ，6-三(N，N-二羟乙基氨基亚甲基硫代)-均三嗪，并用红外光谱仪对其结构进行了分析。

Mallory trichrism staining exhibited light blue samples. Eight weeks following repair, CT showed round blunt defect edges in the coronal position, which had bony pustute connection with gel materials. Density at the defect region significantly increased. 3D reconstruction suggested that defects became small. After hematoxylin-eosin staining, abundant fibrous connective tissue appeared in defect regions, with bony tissues. Mallory trichrism staining revealed that maroon mature bone tissues were found, surrounded by light blue chondroid tissues. Twelve weeks following repair, coronal defect regions were filled with callus. 3D reconstruction showed that defects were repaired. Defect region and surrounding bony tissues had bony connection, with thick bone trabecula and mature Haversian system.

修复后8周，冠状位CT显示缺损边缘圆钝，与凝胶材料有骨性突起连接，缺损处密度增高明显，三维重建显示缺损范围较之前有所减小；标本苏木精－伊红染色后缺损部可见大量含血管成分的纤维结缔组织，有骨样组织结构形成，Mallory三色染色显示有褐红色成熟骨组织形成，其旁边有淡蓝色软骨样组织修复后12周，冠状位CT显示缺损区基本被骨痂填满，三维重建示缺损基本修复；缺损区域和周围骨组织形成骨性结合，骨小梁粗大，哈弗氏系统成熟。

The mechanical characteristics of the foam filled 3-D spacer fabric composites under flatwise compressive , shear and three point s flexural loads were compared with 3-D spacer fabric composites and foamsandwich composites , and the effect s of pile height and foam density on the mechanical properties were investigated.

将三维间隔连体织物泡沫夹层结构平压、剪切和三点弯曲载荷作用下的力学特性与三维间隔连体织物复合材料、传统泡沫夹层结构复合材料进行了对比分析，在此基础上，考察了芯柱高度、泡沫密度对复合材料平压、剪切、三点弯曲性能的影响。

Bringing forth new ideas in me chanism of the Party in power should t akethree represent thought as guidance legal systemization as direction,guara...

执政党运行机制创新，应以&三个代表&思想为指导，以法制化为取向，以从制度上保证&三个代表&思想落实为目标，努力做到把&三个代表&思想贯穿于机制创新的全过程。

Novel phosphazene cyclomatrix network polymers were synthesized via nucleophilic displacement of activated nitro groups of tri (4-nitrophenoxy)tri cyclotriphosphazene and hexa cyclotriphosphazene with the hydroxyls of bisphenol A.

以三对硝基苯氧基三苯氧基环三膦腈和六对硝基苯氧基环三膦腈为主要单体，采用活性硝基亲核取代的方法，合成了一类新的环簇膦腈聚合物。

Novel phosphazene cyclomatrix network polymers were synthesized via nucleophilic displacement of activated nitro groups of tri (4-nitrophenoxy) tri cyclotriphosphazene and hexa (p-nitrophenoxy) cyclotriphosphazene with the hydroxyls of bisphenol A.

以三对硝基苯氧基三苯氧基环三膦腈和六对硝基苯氧基环三膦腈为主要单体，采用活性硝基亲核取代的方法，合成了一类新的环簇膦腈聚合物。

This paper uses cubic spline interpolation function, setting up a mapping between control inputs and control outputs directly based on the data of control input-output, and receives the control algorithm of cubic spline interpolative control for single variable and two variables to separately control the first order system and second order system.

本文利用三次样条插值函数，直接由控制输入输出数据对建立了控制输入与控制输出之间的映射关系，得到了一元三次样条插值控制算法和二元双三次样条插值控制算法，二者可以分别对单输入单输出系统和双输入单输出系统进行控制。

The company has two production¨×biopsy device, the three modified PTT and PTT fibers,¨×fiber production line, a set of three monomers (isophthalic acid, 5 - sodium) production unit, a four-monomer production line with annual production of 15,000 tons slice¨×composite and PTT fibers, staple¨×compound, PTT modified fiber 15,000 tons and 1,000 tons of the four monomers, three monomers 1200 tons, brominated flame retardants EPS with the capacity of 3000 tons .

公司拥有两套波斯伦切片生产装置，三条PTT及改性PTT纤维、波斯伦纤维生产线，一套三单体（间苯二甲酸，5-磺酸钠）生产装置，一套四单体生产线，具有年生产波斯伦复合切片15000吨和PTT纤维、波斯伦复合短纤、PTT改性纤维15000吨及四单体1000吨，三单体1200吨、溴系EPS用阻燃剂3000吨的能力。

Now in China the primary method to produce manganic manganousoxide is using the electrolytic product of manganese as raw stuff,the product produced though this method is high-quality and can meet the electronic grade manganic manganous oxide standard.

目前，我国四氧化三锰主要是以电解金属锰为原料来生产，该法生产出来的四氧化三锰杂质含量低、质量好，能较好地达到电子级四氧化三锰标准要求。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。