三比二

A novel layout of IC transformer is proposed to achieve both high turn ratio and coupling coefficient in this paper. In order to discuss the coupling coefficient, the layouts are designed with different turn ratio. The thesis is mainly includes of three experiment topics. The multi-stack structure is proposed to achieve prior goal in first topic. Two groups of proposed devices are designed to maintain identical self- inductances in transformer's primary and secondary coils. Total six devices are fabricated in foundry 90-nm CMOS technology. Using the 9 and 5 metal layers in primary and secondary coils in a specific layout, measurement results show that the transformer has the largest benefit using the bottommost return layer in layout design. In one word, the adoption of more metal layers to construct different turn ratio transformer shows not only improving the N value but also saving the chip area in this experiment.

中文摘要本文是针对不同圈数比变压器探讨其耦合量的变化，并且期望其变压器能同时达到高圈数比及高耦合系数的特性，本论文主要可分为三个实验主题，首先第一个主题提出以90nm CMOS制程技术实现的多层金属层的布局方式，并以相同的一、二次侧自感值分为两组，利用不同返回层来达到不同的圈数比，且从量测结果可以得知，在变压器布局设计上使用最底金属层来作返回层会得到较好的特性，最后从此实验得知一结论，利用合适的多层金属架构达到不同的圈数比，不仅可以改善圈数比，还可以缩小晶片面积。

Second order incident boundary condition on fixed incident boundary is derived for numerical simulations, based on the cnoidal or sinusoidal motions of wave maker paddle, which shows that the prediction with second order incident boundary condition is more accurate than the prediction with first order incident boundary condition. 2 The analytical solution for higher-order Boussinesq equations is derived and its applicable range is discussed. 3 A 2-D fully non-linear numerical model using boundary element method is developed to obtain wave forces acting on rectangular obstacle. 4 The three-dimensional fully non-linear waves are studied in a numerical wave tank using finite element method.The studies on the coupled numerical model combined Boussinesq equations with Laplace equation are following.

非耦合非线性波浪计算模型：1 根据造波板做椭圆余弦运动或正弦运动速度，推导出数值模拟波浪水槽时固定入射边界上的二阶波浪入射边界条件，数值计算结果和实验结果的对比表明采用二阶入射边界条件对波面升高的预报比采用一阶入射边界条件对波面升高的预报更为精确；2 推导了波浪水槽造波板做正弦运动所产生波浪的高阶Boussinesq方程摄动展开解析解，讨论了该解析解的适用范围；3 对整个波浪水槽应用边界元方法数值模拟了波浪对物体的非线性作用；4 用有限元法求解三维Laplace方程模拟了三维完全非线性波浪水槽。

Through mechanism analyzing on the process of producing HMT , it was known that because the resistance of isobutylene was small ,the yield of outgrowth in such a reaction system was little and the yield of reaction was as high as 86%. 2,3-dimethyI-butene-2 had the biggest resistance and lowest yield of reaction of 18%. 2,3-dimethyl-butene-l had bigger resistance than isobutylene and more outgrowth than isobutyles but its yield of reaction could reach 70%.

通过对上述三种烯烃合成HMT的研究可知，由于新己烯位阻小，反应中副反应少，收率高达86％：而2，3—二甲基—丁烯—2的位阻最大，反应中副反应最多，反应收率最高仅为18％；2，3—二甲基—丁烯—1的位阻比新己烯大，反应副产物比新己烯多，但反应收率仍可达70％。

The experimental results show that the yield of the maleic anhydride is maximum when the molar ra_tio of vanadium pentoxide to molybdenum trioxide is equal to about two and the quantities of vanadium are nearly five times more than those of phosphorus.

实验表明：以氧化铝为载体用于苯氧化制顺酐的五氧化二钒催化剂，当五氧化二钒与三氧化铝的摩尔比为2左右和钒磷比约为5时，顺酐的收率最大，并根据催化剂的半导体电子理论和酸碱理论进行了解释。

During the manufacturing of the critical intermediate cephalosporin nucleus --7-amino-3-chloro-cephalosporanic acid diphenylmethyl ester hydrochloride salt, first the feasibility of the one-pot synthetic route of open loop, closed loop and ozonization when chlorine is passed over is qualified by experiments. Then the critical factors that will influence this reaction are studied as follows: the mol ratio of triphenyl phosphite and Diphenylmethyl 3-hydroxy-7-phenylacetaminoceph-3-em-4-carboxylate-l-oxide is four to one; the quantity of the stablizer should be at least more than two to one. The temperature of the system must be 25℃ when chlorine is passed over so that the hydrochloride can be precipitated to obtain cephalosporin nucleus of cefaclor--7-amino-3-chloro-cephalosporanic acid diphenylmethyl ester hydrochloride salt.

在制备关键中间体头孢母核7-氨基-3-氯头孢烷酸二苯甲酯盐酸盐时，先通过实验验证把开环、闭环、臭氧化三步在通入氯气时并为一锅煮的合成路线的可行性之外，又研究了影响该反应的几个重要因素：亚磷酸三苯酯与3-羟基-7-头孢烷-5-亚砜-2-甲酸二苯甲酯的摩尔比为4：1；稳定剂2-甲基-2-丁烯的用量至少大于2：1，通入氯化氢气体时体系温度在25℃时盐酸盐则能够顺利析出，获得头孢克洛的头孢母核—7-氨基-3-氯头孢烷酸二苯甲酯盐酸盐。

The Yankees could move their hard-hitting second baseman to third base. It is usually easier to find a new second baseman than a third baseman

洋基可以将他们强打的二垒手移到三垒，再找一个二垒手比找三垒手容易多了。

The computational complexity has been reduced about 5 times over against the original one. Moreover, the interpolation and quantization processing of CW is more reasonable; 2. A secondary power normalization algorithm is proposed in this dissertation. This normalization algorithm ensures that the energy sum of SEW and REW is 1. So, the energy ratio of SEW and REW can be achieved only by using SEW energy. This ratio is applied in REW quantization and CW composition; 3. For more efficient quantization for Slowly Evolving Waveform magnitude, Rapidly Evolving Waveform magnitude and power parameters, firstly, by applying the Equivalent Rectangular Bandwidth theory, classifiable multi-codebooks method, analysis-by-synthesis approach and so on, a predictive AbS multi-codebooks SEW magnitude quantization scheme is proposed. In the scheme, pitch information is exploited to determine which codebook is searched; secondly, for REW magnitude quantization, this dissertation proposed a DCT-matrix multi-codebooks quantization scheme. The classification in muti-codebooks is based on pitch and quantized SEW power. The multi-codebooks structure may offer more the information in quantization and solve the problem of the bit requirement limits in quantization by consuming some extra storage space; Furthermore, for the switch quantization of CW gain, a new classified parameter is proposed.

本文的主要贡献体现为如下几方面：一、为了减少WI模型的计算复杂度，提出了基于快速傅立叶变换、三次B样条插值和周期延拓技术的特征波形(Characteristic Waveform，CW)表示和对齐的快速算法，与原方法相比，计算量下降到原方法的1/5，同时也使得CW在插值和量化时更合理；二、为了严格保证SEW与REW的能量和为1，提出了一种特征波形的二次功率归一化算法，仅需要SEW能量就可以算出二者的能量比，并可应用到后续的REW的分类量化和CW合成中；三、为了对慢渐变波形(Slowly Evolving Waveform，SEW)幅度、快渐变波形(Rapidly Evolving Waveform，REW)幅度和特征波形功率进行有效量化，本文首先采用临界频带理论、分析合成技术、感觉加权技术以及预测式矢量量化技术，提出了一种基于基音周期分类的SEW分析合成预测式多码书量化方法；其次，本文根据基音和量化后SEW的功率信息对REW幅度进行分类，提出了一种基于离散余弦变换的REW矩阵多码书量化方法。

Trifluoromethyl-3-heptadfluoroisopropyl-2-perfluoropentene-4-(N',N'-dimethylamino propyl) imino was prepared by the reaction of hexafluoropropene timer with N,N-dimethyl propanediamine in the molar ratio 1:1.0 at room temperature for 8h, and the structures of VIII were identified by IR and NMR spectra.

以六氟丙烯三聚体与N，N-二甲基丙二胺为原料合成叔胺2-三氟甲基-3-七氟异丙基-2-全氟戊烯-4-(N'，N'-二甲胺丙基)亚胺，利用红外光谱和核磁共振确定其结构，并通过对合成条件的考察得其最佳合成条件：乙醚为溶剂，碳酸钠为缚酸剂，摩尔投料比为1：1.0，在室温下反应8小时。

Seven years later, in 1675, the three volumes for April appeared, preceded by preliminary treatises, the subjects of which were respective: in the first volume, the two most ancient collections of notices on the popes (catalogues of Liberius, and Felix) and the date of St. Ambrose's death, both by Henschen; in the second, the attempt at a diplomatical treatise by Papebroch,"whose chief merit", as the author himself was fond of saying with as much sincerity as modesty,"was that it inspired Mabillon to write his excellent work:"De re diplomatica"; in the third, a new revised edition of the new revised edition of the "Diatribi de tribus Dagobertis, which had made the name of Henschen celebrated twenty years previously.

七年之后，在1675年，共三册，为4月出现，在此之前的初步论文，课题，其中分别有：首先是体积，这两个最古老的收藏告示教宗（目录的利比里奥，和Felix ）当日圣刘汉铨之死，无论是由亨申，在二，图谋在diplomatical伤寒由papebroch &，其主要好处&，如作者自己喜欢说的，与作为有多少诚意，因为谦虚，&就是它灵感mabillon写他出色的工作：&去重新diplomatica &，在第三，一个新的修订版的新修订版的& diatribi德tribus dagobertis ，其中已作出的名义亨申庆祝二十年以前。

The results showed that there was a more better effect of filmformation and absorbency to use poly 1788 as an adhesive and polyvinyl pyrrolidone(K:90) as a hydrophilic polymer. The silicon dioxide with particle size 0.3-1 μm as a inorganic pigment had a better absorbency. The polyethylene glycol modified with ethylenediamine had a more better characteristic of dye immobilization, absorbency and definition than the polyethylene glycol modified with diethylenetriamine, of which the polyethylene glycol of molecular weight of 400 modifiedwith ethylenediamine had more best performance.

研究结果表明：采用聚乙烯醇1788作黏合剂、聚乙烯吡咯烷酮(K值为90)作亲水性高分子可得到比较理想的成膜效果和吸墨效果；粒径分布范围在0.3-1 μm的二氧化硅作为无机颜料具有较好的吸墨性能；用乙二胺改性的聚乙二醇比用二乙三胺改性的聚乙二醇具有更好的固墨性、吸墨效果以及清晰度，其中乙二胺改性的分子量为400的聚乙二醇所得到的烷基多胺的效果为最好。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。