三度法

This method was applied to the dimensionality reduction of multidimensional time series via projection pursuit technique for fuzzy clustering. According to the results of the classification and the extraction of fuzzy rules through best value projection, three types of fuzzy membership function were generated using trapezoid distribution method. Then the sample's credit level was determined according to the fuzzy approximability in computation.

该方法利用投影寻踪技术对多维时间序列数据进行降维处理并进行模糊分类；根据分类结果和最佳投影值提取模糊规则，采用梯形分布法生成三个模糊隶属函数；最后根据计算模糊贴近度确定样本的信用级别。

Thus, evaluation of the minimum zone circle could be solved effectively.Three methods of assessment of roundness error were proposed in this dissertation. Based on the criteria of the minimum zone circle, minimum circumscribed circle and maximum inscribed circle and convex hull, a unified approach was proposed to evaluate roundness error of the minimum zone circle, minimum circumscribed circle and maximum inscribed circle. Evaluation of the minimum zone circle, minimum circumscribed circle and maximum inscribed circle was fulfilled with rotation based the contact pattern. The minimum circumscribed circle and maximum inscribed circle were evaluated with curvature and the curvature circle.

本文提出了三种圆度误差评定的方法：根据最小区域圆、最小外接圆、最大内接圆在极坐标系下的判别准则，利用计算几何中的凸壳理论，提出了一种统一的评定方法，实现了对最小区域圆、最小外接圆、最大内接圆的误差评定；基于接触斑点的检验原理，利用旋转法，实现了最小区域圆、最小外接圆和最大内接圆的误差评定；利用曲率和曲率圆，实现了对最小外接圆和最大内接圆的误差评定。

Speckle is also the fundamental uncertainty factor in this kind of sensors. The analytic expression of centroid uncertainty limit is derived from the statistic of laser speckle, and it is shown that the uncertainty limit in RST, and also in anamorphic triangulation, is dependent on the solid angle subtended by entrance pupil as seen from the illuminated laser spot, the triangulation angle, as well as the laser wavelength. The influence of aberration of optical system and surface roughness are also discussed.(4) A method of getting the 3D edge characters based on the integrated vision system is studied.

重点研究了RST中的激光散斑现象，从散斑统计学的角度，首次推导了激光散斑引起的旋转对称三角法位移测量不确定度的极限，结果表明在光学粗糙表面上，该极限由投射激光波长，光学系统入瞳对投射光斑所张的立体角，以及光学系统主光轴与旋转轴的夹角确定；这一结论同样适用于其他变形成像的激光三角法。4基于RST的工作方式，研究了利用集成视觉系统的扫描移动来获得被测物体的低分辨率三维信息的方法。

In this paper, the 3D finite element method (3D-FEM) is employed to calculate the responses of the dual-laterolog in the high angle deviated wells. Moreover, under the consideration of the impracticability of the strict 3D inversion of the electrical logging, one method named the fast deconvolution, is given to correct the electrical logs which is calibrated by the forward method, 3D-FEM.

在考虑常规双侧向测井和正演数值模拟计算的基础上，利用三维有限元素法（3D-FEM）进行大斜度井中双侧向测井响应的数值模拟求解，并以不同倾角为条件验证了方法的有效性；进一步针对目前严格的电测井三维反演处理的不现实性，应用严格正演刻度下的快速反褶积处理方法进行定向井的电测井曲线校正。

The problem of the error accumulation ,three different kinds of linear size marking form is analysed here.

分析了尺寸公差法标注尺寸的三种形式，它们都存在不同程度的误差积累，在一定条件下采用位置度注法，可以解决尺寸标注中的误差积累问

In the new method for two-dimensional problems the line integrals onboundary elements are converted into the evaluation of potentialfunctions at the ends of these elements.For three-dimensional cases,thesurface integrals on the usual boundary elements are transformed,through an application of Stokes'theorem,into line integrals on thebounding contours of these elements.

边界轮廓法是刚刚出现的一种新型的边界元法，该方法的核心是利用边界积分方程被积函数散度为零的特性，对二维问题，原积分方程中沿边界单元的线积分被化为单元两端点势函数之差计算，对三维问题，将边界单元上的面积分转变为沿单元轮廓的线积分，它是一种十分简便有效的边界元新技术。

The obtained results a re compared with analytic solution and those from integral equation and other me ans. It is shown that the staggered grid finite difference method combined with the Biconjugate gradient iterative solver processed with divergence correction and incomplete Cholesky decomposition procedures can efficiently improve the three dimensional electromagnetic calculation with high accuracy and stability.

经与解析方法、积分方程等其他方法的计算结果对比表明，交错网格有限差分法结合散度校正和不完全乔累斯基分解预处理的双共轭梯度迭代方法进行正演计算，速度快、精度高、结果稳定，能适应三维复杂介质的数值模拟，为三维电磁反演奠定了基础。

The UV and IR spectroscopic studies of the monomer films showed that the photoreaction ratio of monomer (about 50%) was higher than the corresponding photosensitive polymer (about 10%, PVCi). The polarized IR spectra proved that obvious anisotropic absorption was displayed in the irradiated photosensitive film. With polarizing microscopy method, we found that these kinds of photoalignment films exhibited good alignment ability, and the stability of the photoalignment film could reach about 100℃. 2 A photosensitive self-assembled monolayer was fabricated that contained photo-cycloadditable groups, such as, coumarin and cinnamate. The reaction process were detected by contact angle method because the IR absorption of monolayer was very weak. The photosensitive self-assembled monolayer promote uniform alignment of nematic liquid crystals by LPUV, and it thermal stability could reach about 130℃. 3 A cationic bolaform amphiphiles was synthesized that had two photosensitive double bonds, and can be polymerized by ultraviolet. A layer-by-layer self-assembled deposition film was prepared in aqueous solution by using this material and poly (sodium 4-styrenesulfonate). The UV-Vis. spectra proved that the multilayers film was uniform and layer-by-layer. When LPUV irradiated the film, the photopolymerizable double bond underwent [2+2] cycloaddition, and the production of the reaction distributed along the polarized direction of incident LPUV. Polarized UV-Vis. spectra indicated that the irradiated self-assembled multiplayer film was anisotropic, and the dichromic ration is about 0.09, it is higher than the spin-coating method of photosensitive polymer or monomer. We used this anisotropic film as alignment layer of nematic liquid crystals, and obtained a uniform and stability alignment result, the static contrast ratio is about 100, which is very close to application of liquid crystal device. This thesis is an instance that the photochemical material was used in the physics region of liquid crystals, the route that was from photosensitive monomer, self-assembled monolayer film to self-assembled multiplayer film was undergone, by this logical research method photoailgnment of liquid crystal was extended and consummated.

围绕上述思路开展了如下工作：1合成了三种可进行光二聚反应的光敏小分子单体，LPUV 辐照制作了光控取向膜；用紫外-可见光谱法和红外光谱法分析了薄膜中的光化学反应，发现小分子的光反应程度可达到50%以上，至少比光敏高分子高出5倍；薄膜的偏振红外光谱证实，经过LPUV 辐照后薄膜出现了明显的各向异性；将小分子光控取向膜制成液晶器件，在偏光显微镜下观察看到均匀一致的液晶取向；并且热稳定性达到100℃左右，接近实用化要求。2制备了含肉桂酸、香豆素基团的自组装单层膜；采用接触角的方法监测自组装反应的动力学过程；紫外-可见光谱证实了自组装单层膜在石英基板表面形成；自组装单层膜经LPUV 辐照后能诱导液晶均匀取向，而且热稳定性可达130℃，热稳定性进一步提高。3合成了含有光敏双键的双季铵盐，在水溶液状态下将它和聚乙烯基苯磺酸钠沉积生成layer-by-layer 自组装多层膜，紫外-可见光谱证实这是一个逐层均匀的沉积；在LPUV 照射下，自组装膜中的光敏双键按照偏振方向发生[2+2]环加成反应，形成取向膜，用二向色性值评价的分子取向度高于高分子及小分子光控取向膜的水平；实验证明用自组装多层膜制成的液晶器件亮暗态均匀，静态对比度约为100，达到实用化器件的水平。

It is also more trifling on hardware design as well. If we can reach the same quality after interpolating but with easier operation, it is also a great improvement on Interpolation Algorithm.

在第三章除了介绍我们的补插方法并与第二章所介绍的演算法一起比较，并针对运算复杂度和补插后的影像品质去分析比较，让大家更能够了解我们的演算法与其他方法之间的优、缺点。

Results The recombinant plasmid pSNAV2.0-TK was verified byPCR and restricton endonuclease. The coat protein of AAV was detectedby SDS-PAGE method, the purity of rAAV2/HSV-TK was＞98% byHPLC method and the titre of rAAV2/HSV-TK was 1×10~(12)v.g./ml byDNA dot blot hybridization.

结果：重组质粒pSNAV2.0-TK PCR扩增的片段大小和酶切鉴定所切下的片段与预计结果一致；SDS-PAGE法检测到三条特征性的AAV外壳蛋白条带，HPLC法检测rAAV2／HSV-TK的纯度＞98％；用DNA斑点杂交方法检测rAAV2／HSV-TK的滴度为1×10~(12)v.g。

As she looked at Warrington's manly face, and dark, melancholy eyes, she had settled in her mind that he must have been the victim of an unhappy attachment.

每逢看到沃林顿那刚毅的脸，那乌黑、忧郁的眼睛，她便会相信，他一定作过不幸的爱情的受害者。

Maybe they'll disappear into a pothole.

也许他们将在壶穴里消失