三叶的

Papaya leaf curl samples collected from Guangxi province and 1 from Guangdong province, and 5 ageratum yellow vein samples from Guangxi province were tested with triple antibody sandwich ELISA and PCR, Results showed all the virus samples were infected by whitefly-transmitted geminiviruses.

利用三抗体夹心ELISA及PCR检测的方法对采自广西的7个番木瓜曲叶病样品和广东1个番木瓜曲叶病样品，及采自广西胜红蓟的5个黄脉样品进行了检测，表明均为粉虱传双生病毒。

Study on the rapid Propagation Technique of Lycoris. Herb and get follow results: In the period found of axenic clone 0.1%HgCl2 is the best disinfector to deal with the Lycoris" bulb ,as to neat part, such as root, leave, and bulbil, is fit to use 0.1%HgCl2 antisepsis 7min. And found the best effect is the bulb scale with base. Root, leaf and bulb scale without base all were not inducement adventitious buds. Different position of bulb had different culture effect. 3-15 of middle part of bulb can be induced most adventitious buds but inner and outer of least it. Incised the bulb with three types (pieces of eight, pieces of six, piece of four), and found the type of pieces of six is best to Lycoris mass production. L.sprengeri is fit MS+BA5mg/l+NAA0.1mg/l and L.squamigera is fit MS+BA5mg/l+NAA0.5mg/l, but the medium fit to culture L.longituba haven"t be found.In the period of Subculture-Found of mass production, the most multiplication of adventitious buds in MS+BA5mg/l+NAA0.5mg/l during subculture of L.sprengeri, L.squamigera.

石蒜属植物快速繁殖技术研究中，在无菌无性系建立阶段：鳞茎以0.1％HgCl_2消毒10-12分钟效果最好，而叶、根尖、鳞芽等较干净部位选用0.1％HgCl_2消毒7分钟；用三种石蒜属植物的叶片、根尖、鳞芽及带基盘与不带基盘鳞片进行培养，以带基盘鳞片诱导分化效果最理想，鳞芽易培养出芽，但数量有限，而叶片、根尖与不带基盘鳞片均未诱导分化；带基盘鳞片为石蒜属植物快速繁殖最佳外植体，以鳞茎中部3-15层芽诱导率高，较外层稍次之，内部鳞片诱导率最低；选用八等分法、六等分法、四等分法切割鳞茎，六等分法综合效果最好；每外植体带三鳞片培养最为适宜；三种石蒜属植物各自适合的培养基成分不同，换锦花在MS+BA5mg／l+NAA0.1mg／l中培养效果最好，夏水仙为MS+BA5mg／l+NAA0.5mg／l，而白花长筒石蒜在各培养基组合中培养效果均不理想，其适合的培养条件有待于进一步研究。

Parabolized stability equation of 3D disturbance wave was deducted under orthogonal curvilinear coordinates. The static pressure distribution on blade surface was measured in wind tunnel test, and this result was used for analysis of blade's flow stability.

推导出正交曲线坐标系下三维扰动波的抛物化稳定性方程，在风洞实验中测量叶栅叶片表面的静压分布，并结合测量结果对设计叶栅的流动稳定性进行特征值分析。

Results As indican for the inspection targets, different areas indican was very different.In 6,7,8 three months,July was highest;In morning,noon and evening of a day,the evening was highest.

结果 以吲哚苷的含量为考察指标，不同产地吲哚苷含量差异显著；同一产地不同采收时期， 6、7、8三个月中7月份采收的大青叶吲哚苷含量最高；早、中、晚不同时间，晚上采摘的大青叶吲哚苷含量最高。

Three-dimensional contact stress of turbine between roots and rims are analyzed by the three-dimensional digital photoelasticity.

用三维数字光弹性法分析汽轮机叶根、轮缘的三维接触应力。

Communis, which is applied to utilized pathogenic fungi and G〓 bacteria; ginger oil, which is applied to utilized pathogenic fungi and leaf oil of L.

十六种挥发油中的地椒油、毛叶木姜子果油和川桂叶油等三种挥发油对所有供试真菌和细菌均具有很好的抗菌活性。

The above ground parts of Trilliums are scapes with three large, leafy bracts with the true leaves reduced to underground papery coverings around the rhizomes .

在Trilliums地上部分有三个大，与真正的叶苞片图景叶减少到周围的根茎地下纸质覆盖。

In addition, isozymes changes of SOD and POD were observed in groups treated with laser after seeds being soaked for 24 h and when embryonic buds emerged, while no change was observed in the group treated at the one-leaf stage.

SOD、POD同工酶的酶谱在浸种24小时和胚芽露头期经激光处理后改变，在一叶期处理后没有改变；CAT同工酶谱没有变化；在一叶期处理的三种同工酶谱都没有改变。

The theoretical development of internal flow of turbomachinery is then summarized in terms of separation theory, vortex dynamics and flow pattern.

然后分别从分离流动理论、涡动力学和叶轮机械流型三个层次介绍叶轮机械内部流动理论的发展；从平面叶栅、环形叶栅、动态试验和试验技术等方面回顾叶轮机械试验研究进展；从控制方程、数值方法、网格生成等方面综述叶轮机械数值计算研究方法、研究内容及成果等，并概括改善叶轮机械气动性能的方法和现状。最后对叶轮机械内部流动研究进行展望。

The traditional wind turbines using two-bladed wind rotors are being replaced with larger more modern turbines using 3 bladed rotors.

最传统的两扇叶风车，现已被较先进的三扇叶风车所取替。

This one mode pays close attention to network credence foundation of the businessman very much.

这一模式非常关注商人的网络信用基础。

Cell morphology of bacterial ghost of Pasteurella multocida was observed by scanning electron microscopy and inactivation ratio was estimated by CFU analysi.

扫描电镜观察多杀性巴氏杆菌细菌幽灵和菌落形成单位评价遗传灭活率。