查询词典 yield strength

FIGS. 1 and 2 show the influence of billet temperature and time on ultimate tensile strength and tensile yield strength.

图1和2示出了坯料温度和时间对极限拉伸强度和拉伸屈服强度的影响。

The results show that the mechanical properties of EVA/MH composites are improved by use of MCA, such as toughness, breaking strength and yield strength.

结果表明：MCA能够改善体系的力学性能，在提高韧性的同时，屈服强度和断裂强度也有所提高。

Results show that the actual location of the cooling curve of the steel can be adjusted by regulating the strength of the steel and the yield strength ratio of the steel can be adjusted by controlling the cooling rate o...

分析认为调节钢的实际冷却曲线位置可调节钢的强度，调节钢在铁素体相变区内的冷却速率来调节钢的屈强比。据此对控冷工艺进行优化，使产品力学性能和组织符合技术要求和用户的要求。

The simulation result of the enameling process at high temperature shows that with the increase of soaking temperature and holding time, the yield strength and tensile strength increase, and the total elongation decreases.

模拟高温搪烧时，随着温度的提高和保温时间的延长，屈服强度和抗拉强度下降，伸长率提高。

The simulation result of the enameling process at high temperature shows that with the increase of soaking temperature and holding time-the yield strength and tensile strength increase,and the total elongation decreases.

经857℃保温10 min后，钢板的屈服强度满足了不小于310 MPa的要求。预变形时的变形量对模拟高温搪烧后钢板的力学性能也会产生影响。

Experiments carried outby many investigators prove that the ultimate strength, the yield strength and hardness in-crease with the deformation, on the other hand, the elongation decreases, the impact valueand reduction of area also change.

很多研究工作者的结果都证明：极限强度、屈伏强度和硬度随着变形量而增加，但是延伸率则减小，冲击值和断面缩减率也产生了变化。

The results show that the grain size is refined by the addition of Nd or Dy, especially combined addition is better than single addition. With the addition of 0.2 % Nd and 0.6% Dy, the grain size is reduced from 150 μm to 60 μm. Combined addition with two rare earths elements makes the tensile strength, yield strength and elongation of ZK10 alloy increase to 191.0 MPa, 69.0 MPa, and 16.6%, increasing by 89%, 43%, 232% respectively, compared with ZK10 alloy without RE element.

结果表明：ZK10镁合金中分别加入Nd和Dy均能细化晶粒，且Nd和Dy同时加入的效果优于单一加入的效果，当同时加入质量分数为0.2% Nd和0.6% Dy时，合金的平均晶粒尺寸由原来的150 μm细化至60 μm，使ZK10合金的抗拉强度和屈服强度分别提高至191.0 MPa和69.0 MPa，伸长率达到16.6%，与未加入稀土的ZK10合金相比分别提高89%，43%和232%。

The indentation loading curve with a spherical diamond tip was employed to determine the yield strengths and hardening indices of Cu films which were prepared on silicon substrates by different ways with the same thickness of 1. 5μm. The result showed that the yield strength of the Cu film depends on the deposition technology, and is much higher than that of the bulk material.

结果表明，在薄膜厚度相同的条件下，铜膜的屈服强度与铜膜的制备方法有关，选择IBED法较MS法可获得更高的屈服强度〓此外，由两种方法所镀制铜膜的屈服强度均远高于其体材，这与铝膜的情况相一致，说明薄膜与整体材料在强度方面存在显著差异的结论具有普遍性。

Yield Strength Many materials do not have a yield point.

许多材料没有屈服点。

This paper makes the optimum autofrettage analysis of thick-walled cylinder of the material with different yield strength in tension and compression base on the Mohr's yield criterion.

本文运用莫尔屈服准则对承受内压的拉压屈服强度不同材料的厚壁圆筒进行了自增强分析，得到了依赖于材料拉压比的厚壁圆筒的最佳弹塑性界面半径、最佳自增强内压。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。