英语人>网络例句>wire-cut 相关的网络例句
wire-cut相关的网络例句

查询词典 wire-cut

与 wire-cut 相关的网络例句 [注:此内容来源于网络,仅供参考]

By placing the reflector near the short circuited end of the two wire line, it was achieved that the wire that short circuited the two wire lines acts with the close reflector as a transmission line, with an impedance of about 150 Ohms.

调整反射板和短路线间的距离,短路线和反射板就等效为阻抗大约 150 欧姆的传输线。

The pre-tensile stress in wire layer of new type wire wound super high pressure vessel was analyzed,and yielding stress calculation of the wire layer was been formularized.

对新型绕丝式超高压容器的缠绕钢丝层进行了预应力分析,推导出了钢丝层在预紧状态下的屈服压力计算公式,对进一步探讨和研究超高压容器的性能具有一定参考价值。

This welding wire not only has the inherent properties of metal powder-cored wire, such as with better welding quality, without slag, highly efficiency and conveniently adjusting the alloying elements etc., but also has the advantage of low hardness in as-welded (less than HRC45), good machinability, high hardness in as-aged (more than HRC55) and better wear resistance with customary working procedure on making or repairing equipments such as rollers when reasonable designing the alloys content. The author adequately makes use of the high-tempering in the required stress relieving working procedure. During this working procedure, which causes the hardness of overlaying metal increased by the reason of austenite changes into tempered martensite and more chiefly what is the precipitation of a lot of carbide by secondary hardening simultaneously. This wire can solve the hard rolled problems of some solid wires with higher alloys while it can get over the conflict of existing overlaying materials what are always possesed high hardness with poor machinability or low hardness, good machinability with poor wear resistance. Further, it also can overcome the intenerating phenomena between welding beads and make the external hardness of overlaying metal uniform. Be sure it could be found important meaning in the overlaying of wear-resistant equipments, such as the precise roller.

该焊丝除了具有金属粉型药芯焊丝焊接质量好、无渣、高效率和合金成分可方便调节等固有的优点外,合理的设计粉芯中的合金成分,按通常工序制造与修复轧辊等设备,充分利用必需的消除应力工序的高温回火,堆焊层金属在奥氏体转变为回火马氏体的同时更主要是通过二次硬化析出了大量碳化物导致硬度增加,使得该焊丝还具有焊态硬度低(小于HRC45)、机加工性能好和时效态硬度高(大于HRC55)、耐磨性能好等优点,解决了某些高合金实芯焊丝轧制困难的问题,同时克服了现行堆焊材料硬度高、加工性能差或者硬度低、加工性能好、耐磨性差的矛盾,并能克服焊道之间的软化现象,使堆焊表面硬度较为均匀,对耐磨件,譬如精轧辊的堆焊具有重要意义。

METHODS: Eight fresh patellae specimens were divided into two groups at random, AO steel wire group (n = 2) and absorbable tension band group (n = 6) to create models of transverse fractures, which were separately fixed by absorbable tension band, steel wire tension band + Kirschner wire to measure their biomechanics function. If fracture gap reached 1.0 mm, the fixation failed.

随机分成AO钢丝组2个和可吸收张力带组6个,制成横断骨折模型,分别用可吸收张力带、钢丝张力带加克氏针进行内固定,测定它们的生物力学性能,骨折端分离1.0 mm为固定失效。

There are two methods are often used. A method is constructing some separate polyhedrons from vertex and edges of 3D wire-frame and combine the polyhedrons with each other one by one. Another is extracting wire-frame to some candidate faces and joining them up according to the nature of 3D object.In this paper, an algorithm of reconstructing 3D object from wire-frame was put forward.

目前有两种方法:一种是把三维实体看成由多个多面体组成的,相应的方法是将线框模型拆分成多个多面体,然后进行多面体的拼接组合重构三维实体;另一种方法是把三维实体看作由多个面组成的,相应方法是搜索可行面并根据三维实体的特点来重构。

Edge Clip/ Swaged Hardware/ Wire/lead Preparation-tining/Lead Forming-Stress Relief/Service loops/ Terminals-stress Relief lead/Wire Bend/ Lead/Wire Placement/Insulation/Conductor/Terminals-Solder/Conductor-Damage-Posrt-Solder

夹簧铆接端、铆接件、导线/引脚准备上锡、引脚成型-应力释放、维修环、应力释放引脚/导线弯曲、引脚/导线的安放、绝缘皮、导体、端子焊接、导体-损伤-焊后的情形等。

Based on the analysis of the feature for the fly-by-wire of aircraft, the mathematical models of the aircraft and the fly-by-wire are established; the probability model of contingency in the fly-by-wire and pilot tamper probability model are also established; by the application of Markov Chains the flight security model is upbuilt.

在分析飞机电传操纵系统特点的基础上,建立了飞行器和电传操纵系统的数学模型,建立了电传操纵系统故障及飞行员干预的概率模型。应用马尔可夫链建立了人-机系统飞行安全可靠性的数学模型。

To introduce cause for different weight of flat wire rope between new standard GB/T 20119-2006 flat steel wire rope for balance and GB/T 8918-1996 wire rope.

介绍新制订的GB/T 20119-2006《平衡用扁钢丝绳》和GB/T 8918-1996《钢丝绳》2个标准中扁钢丝绳重量不同的原因,指出选择平衡用扁钢丝绳重量的方法,保证扁钢丝绳的重量,以便满足用户使用要求。

Disassemble the lead wire from generator "+" binding post if the marks of "+" and "-" polarities is dimness during battery replacement, and serial connects one lamp between the lead wire and "+" binding post, and then connects with two pieces of power supply wire of the battery; it indicates the connection is correct if the lamp is lit, otherwise it indicates the connection of battery polarities is wrong.

在更换蓄电池时,若其&+&、&-&极性标记不清楚,可拆下发电机&+&接柱上的引线,在其引线与&+&接柱之间串联一试灯,然后再接上蓄电池两根电源线,若该试灯不亮,表明接线正确,否则说明蓄电池&+&、&-&极接错。

Main products or services: Box cutter, drawing large, copper wire drawing machines, ultra-fine line drawing, drawing Baolv copper, copper clad steel wire drawing machine, cutting line drawing machine, the line of stainless steel, brass line drawing machine, copper wire cutter, Annealing, annealing line, copper copper, aluminum copper, pulley-drawing machine, drawing machine-Straight

主营产品或服务:框绞机,大拉机,铜线拉丝机,超细线拉丝机,铜包铝拉丝机,铜包钢拉丝机,切割线拉丝机,不锈钢线,黄铜线拉丝机,铜线绞机,退火机,在线退火机,铜镀铜机,铝镀铜机,滑轮式拉丝机,直进式拉丝机。

第23/100页 首页 < ... 19 20 21 22 23 24 25 26 27 ... > 尾页
相关中文对照歌词
Live Wire
Dancing On A High Wire
Live Wire
Blackbird On The Wire
Drilled A Wire Through My Cheek
On The Wire
Bird On A Wire
Mummified In Barbed Wire
Under The Wire
Wire To Wire
推荐网络例句

I am accused of being overreligious," she said in her quiet, frank manner,"but that does not prevent me thinking the children very cruel who obstinately commit such suicide.""

客人们在卡罗利娜·埃凯家里,举止就文雅一些,因为卡罗利娜的母亲治家很严厉。

Designed by French fashion house Herm è s, this elegant uniform was manufactured in our home, Hong Kong, and was the first without a hat.

由著名品牌 Herm è s 设计,这件高贵的制服是香港本土制造,是我们第一套不配帽子的制服。

Do not 'inflate' your achievements and/or qualifications or skills .

不要 '夸大' 你的业绩或成果,条件或者技能。