查询词典 wind vane

The paper analyzes the shortage of traditional roadway measuring wind method,and by theoritical calculation of measurement,the wind amount is tested,and the roadway fixed central point method of wind measurement and the roadway s average wind velocity fixed-point method of wind measurement are proposed,and which solve the problem of low wind velocity and low credibility well.

分析传统井巷测风方法的不足，并通过风量测定的理论计算和对现场风量进行实际验证，提出了井巷中心点定点测风法和井巷平均风速点定点测风法，较好地解决了当前测定风速慢、可靠性差的问题。

The authors discuss a new numerical simulation method of the downburst wind loads on the basis of the previous research. Firstly, the wind speed is expressed as the sum of an instantaneous mean wind speed and an amplitude-modulating non-stationary fluctuating wind speed. Secondly, a new method based on the modified Osegguera and Bowles/Vicroy model to simulate the mean wind is presented and the fluctuating wind is simulated by a modified spectral representation method.

在将下击暴流风速表达为时变的平均风速和调制的非平稳脉动风速之和的前提下，本文采用基于改进的OBV模型Oseguera and Bowles/Vi-croy(OBV的方法来模拟平均风速，其平均风速直接由改进的OBV模型表达，而不同于已往研究中将平均风速表达为竖向风剖面与时间函数的乘积，并采用结合快速傅里叶变化的谐波叠加法来模拟调制的非平稳脉动风速。

AR model in linear filter theory is adopted to simulate pulsant wind. Combined with some typical cable-membrane structures, research on self-vibration of the structure has been conducted. Based on the previous work, the influence caused by the vertical wind component on the membrane roofs has been analyzed in time domain. It includes the vibration laws of the structure under separate horizontal wind component, separate vertical wind component and the collective horizontal wind component and vertical wind component. Significant conclusions have been drawn from the analysis.

然后本文采用线性滤波器法中的AR模型对风速场进行了模拟；之后又结合典型的张拉索膜结构研究了膜结构的自振特性；在此基础上，本文研究了索膜结构在竖向脉动风影响下的风振响应特性，其中分别研究了张拉索膜结构在单独水平风，单独竖向风以及水平风和竖向风共同作用下的振动规律，得出了有关重要结论。

To get the biggest power coefficient at various of wind speed, put out the argument of controlling wind turbine according to the wind pressure which act on the wind wheel swept area. Design and make a wind turbine which can adjust pitch angle of oar leaves through various of wind speed, and make experiment of characteristic.

1引盲 传统的风力机优化设计方法是以桨叶各截面在设计风速处具有最大的功率系数为目标，设计是针对事先确定的一个设计风速进行的，风力机只能在设计风速点处获得最大功率系数。

The complete wind turbine speed control firstly proposed here also improves the tracking effect of wind turbine rotating speed to variable wind speed. Wind turbine rotating speed synchronized power observer compensates the power ripple of wind turbine resulted in inverter dead time. A low pass filter used at the output of MPPT controller smoothes the speed reference, which makes the rotating speed of wind turbine more stable.

本文首次提出的变转速扰动的MPPT控制提高了风车最大功率点追踪的快速性和稳定性，风车完全转速控制提高了风车转速对变动风速的跟踪效果，转速同步风车功率观测法消除了逆变器死区所造成的风车功率波动的影响，带有低通滤波器的MPPT控制器使得风车的转速更加趋于平稳。

And use the prior and more consummate ways to carry through vaneaccidence design, These ways have own technology points and disadvantage, In this paperstressly discuss the momentum-element theory way, this way was developed in the basic ofthe two ahead ways, and it overcome their defect. It also use element theory to deal withvane design. In the vane designing and aerodynamical characteristic calculating they bothrelate with intervene gene, so the keystone is to carry through the intervene gene in twocase, thereout to do the vane design and aerodynamical characteristic calculating.

运用翼型的基本概念和风力机叶片的基础外型参数进行叶片设计的预研讨论，并分别运用了Glauert和Schmitz叶片设计方法叶片进行初步设计，这两种方法有其各自技术特点和缺点，文中还着重研究了动量—叶素理论方法，这种方法在前两种设计方法的基础上发展而成，并采用两者的叶素研究方法进行叶片设计，动量叶素理论方法在进行叶片外型设计和叶片气动特性计算都涉及到干涉因子，文中重点对设计和计算情况下的干涉因子进行处理，并由此来设计叶片的外型和进行气动特性的计算。

The designs of the gap and the orifice vane MRF dampers for the vehicle are introduced. According to one of the primary gappy one s deficiencies compared with the orifice one that the magnetic flux density in the gap isn t strong enough,the design of three phases vane MRF damper with tangent magnetic core is proposed.

介绍了车用缝隙式阻尼型和孔式阻尼型叶片MRF减振器的磁路设计方案，并针对缝隙式阻尼型相对于孔式阻尼型间隙处磁感应强度小的不足，提出了采取切向放置铁芯的三阶段叶片式MRF减振器的设计。

The outside vane of the double layered shutter inlet port or the vane of the single shutter inlet port can be parallel either to the long edge or to the short edge, which is being to adjusted to the needs of customers.

双层百叶风口的外层叶片或单层百叶风口的叶片可以平行于长边，也可以平行于短边，可以根据客户的要求来选择。

CASCADE VANE, A vane for turning the engine airflow during operation of thrust reverser.

叶栅叶片，在反推工作时，使发动机气流向相反方向流动的叶片。

ASCADE VANE, A vane for turning the engine airflowuring operation of thrust reverser.

叶栅叶片，在反推工作时，使发动机气流向相反方向流动的叶片。

More direct, directer ; most direct, directest

径直的，笔直的

Do you know how to use a chain saw?

你知道如何使用链锯吗？