查询词典 wet air

Results show that during the snowstorm disaster, under the large scale background with "trough in south and ridge in north", strong cold air caused by prevailing northerly wind in northern Asia wedged into low level atmosphere over Southeast China and formed a "clod cushion". At the same time, warm-wet air was also transported to Southeast China by southerly wind. The vertical shear of winds from cold to warm airflows produced strong upward motion and then, the warm-wet air over the cold air wedge was driven to rise. Finally, the structure of "warm cover" and "cold cushion", as well as corresponding vertical circulation over the converging frontal zone came into being.

研究结果表明，灾害发生期间，中国北方中低层大气盛行偏北气流，使较强的偏北冷空气"楔入"中国东南部低层大气，构成低层"冷垫"，同时偏南暖湿气流源源不断地将大量水汽输送到中国东南部，冷暖气流交汇及其垂直切变导致强烈的上升运动，构成了"冷垫"上空的"暖盖"及"南槽北脊"反位相环流汇合锋区的垂直环流结构。

The solutions were found to be good agrees with experimental results. The transfer characteristic of air dry/wet bulb temperature and spraying water temperature were discussed. The LMTD method based on this mathematical model is applicable to design and verify for the plate wet air cooler. The ratio of the wet bulb heat transfer coefficient to the heat transfer coefficient under air-cooled conditions was investigated theoretically and experimentally. The relative errors of the ratio between theoretical and experimental valves are small than 7 percent.

分别得到了平行流型式微分方程组的解析解与交叉流型式的近似解析解，实验验证了该解析解具有较高的计算精度；探讨了空气干湿球温度与喷淋水温的迁移特性；分析得到基于湿球温度迁移模型的对数平均温差法在湿式空冷器的设计与校核计算中是适用的，给出了空气湿球换热系数与空冷时空气对流换热系数比值的理论与实验确定方法，比值系数理论值与实验值比较最大相对误差小于7％。

Introducing the wet bulb specific heat capacity and the wet bulb heat transfer coefficient, a new mathematical model for the plate wet air cooler was developed based on the wet bulb temperature transfer characteristic.

分析结果表明壁面润湿率对冷却性能具有显著影响，而夹杂在空气中的液滴对传递过程的影响相对较小，工程计算可忽略夹杂液滴对传递模型的影响。

The method to determine the limited temperature for dry/wet running conditions was presented. Multi-object frame optimization model were developed. Combined with the thermal and hydraulic correlations for dry/wet conditions of plate wet air cooler, the optimization model can be used to optimize the dry/wet limited temperature and frame parameters.

提出了湿式空冷器干湿工况运行界限温度的确定方法，建立了板式湿式空冷器多目标结构优化模型，结合实验得到的干湿工况下板束内外侧阻力、传热传质关联式以及喷淋水膜对流换热关联式，该优化模型可用于干湿工况运行界限温度与结构参数的优化。

Deep grand of far water shade drop in temperature principle: Water shade and fan install the two sides wall in workshop respectively, when fan convulsions, make the air of workshop forms negative pressure, the not saturated air outside forcing workshop sheds the surface with classics water poriferous and wet shade, cause moisture to evaporate absorb a large number of latent heat, drop the temperature of air oneself thereby, below the action of fan, the humid air of these temperature that be redu

深弘远水帘的降冷元理：水帘微风机分别装在车间的双面墙头，风机抽风时，使车间的空气air产生负压，强使车间外未饱满的空气air流经水帘多孔湿滑的外面，引发水份辉发吸收非常多潜热，进而下降空气air本身的温度，在风机的作用以及影晌下，这一些被下降温度的湿滑空气air就涛涛不停的步入车间。

In 500—1000 ℃, electronic hole conduction is dominant in dry and wet oxygen, air or nitrogen. Protonic conduction is dominant in wet hydrogen and it is about two orders of magnitude higher than that in hydrogen-free atmospheres.

在500~1000℃下，在干燥和潮湿的氧气、空气和氮气气氛中，样品以电子空穴导电为主；在潮湿的氢气气氛中，以质子导电为主，其电导率比不含氢气气氛（O2，air，N2）中的电导率约高两个数量级。

The results show that wet air reduces both fatigue life and strength with the influence-factor of 0.6059 and 0.8722, respectively. Wet air environment enlarges the dispersivity of fatigue life, therefore using the corrosion-influence-factor obtained by eigenvalue or mean value to predict the fatigue life with high reliability will cause an unconservative conclusion.

结果表明，潮湿空气环境显著降低了2024-T3铝合金的疲劳性能，潮湿空气环境对其疲劳寿命特征值和疲劳强度均值的影响系数分别为0.6059和0.8722；在潮湿空气环境中疲劳寿命的分散性变大，用疲劳寿命的中值或特征值得到的腐蚀影响系数进行可靠度95%的腐蚀环境下的寿命修正，将得到偏危险的结果。

S:Dye intermediate—Hacid could be treated effectively by Wet Air Oxidation process and Catalytic Wet Air Oxidation process,all the Hacid was decompounded in 5 minutes and some intermediate products,sueh as NH+ 4,SO 2- 4,HCOOH,CH 3COOH and so on,were formed.

湿式氧化和催化湿式氧化都能有效地处理染料中间体—— H-酸。所有的 H-酸在 5 min内均被去除和形成一些中间产物。在不同反应时间段测定了 p H值及阴、阳离子和小分子有机酸等中间产物。

The results indicated that BaCe0.8Ho0.2O(subscript 3-α) sinters are of single-phase structures of orthorhombic perovskite. In the temperature range of 600~1000℃, the nonstoichiometric materials (x=1.03 and 0.97) have higher conductivities in wet hydrogen and wet air and better performances of hydrogen-air fuel cells than the stoichiometric one (x=1). In this series, BaCe0.8Ho0.2O(subscript 3-α) has the highest conductivities 2.10×10^(-2Scm^(-1) in wet hydrogen, 3.46×10^(-2) Scm^(-1) in wet air, at 1000℃ and the maximum power output density 122 mWcm^(-2 at 1000℃.

结果表明，在600~1000℃温度范围内、湿润氢气和湿润空气气氛中，该系列材料的电导率随温度和钡离子含量的变化均与以该系列材料为固体电解质的氢－空气燃料电池性能随温度和钡离子含量变化的次序一致，即：非化学计量组成材料BaCe0.8Ho0.2O(下标 3-α)(x=1.03， 0.97)具有较化学计量组成材料BaCe0.8Ho0.2O(下标 3-α)(x=1)高的电导率和氢－空气燃料电池输出功率密度，其中BaCe0.8Ho0.2O(下标 3-α)有最高的电导率（1000℃时、在湿润的氢气气氛中：2.10×10^(-2)Scm^(-1)；在湿润的空气气氛中：3.46×l0^(-2)Scm^(-1)）和最大的氢－空气燃料电池输出功率密度（1000℃时：122mWcm^(-2)）。

Air-conditioner of environmental protection of refrigeration of water of " of " Yu Feng is main characteristic: Invest small, efficiency big; Power consumption is small, horary use 1 degree of phone only; Need not compressor, without freon, free from contamination; Use 5090 efficient evaporate wet shade, drop in temperature capability is especially strong; Air screen pack increases outside wet shade, make indoor air cleaner, fresh; Overall full automatic electronic control system cle

宇风水制冷环境保护空调机重要特征：注资小、效率大；耗电量小、每钟头仅用1度电；不需要缩小机、无氟利昂、无污染；使用5090有效辉发湿帘，降冷本事特强；湿帘外增多空气air筛选网，使房内空气air更清爽、清爽；整机全自行电子信息掌控体系自行冲冼效能；液晶表明带遥感，毛病少，保护容易；一切零件使用YF准则化岀产，体系兼容质量较好。

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。