查询词典 welded

Subject Matter and Scope This standard specifies the flange and welded steel gate valves of the structure type, technology requirements.

正题内容与适用范围本标准划定了法兰和对于焊连接钢制闸阀的结构型式、技术要求等。

Control valve control valve to connect the connection with threaded connections, flanged and welded connections.

3控制阀连接控制阀的连接有螺纹连接、法兰连接和焊接连接等。

Valves should not be assembled to the flanges and then welded into the piping system.

不要把组装上法兰的阀门焊接到管道系统上。

Valves should not be assemble d to the flanges and then welded into the piping system.

不要把组装上法兰的阀门焊接到管道系统上。

For the large cross-section of welded steel, you can generally use electromagnetic induction welding, laser welding and flash butt welding, etc.

对于大截面钢材的焊接，通常可以采用电磁感应焊、激光焊和闪光对焊等。

Three types of SiCp/3003Al composites which was with the volume fraction of reinforcement of 0%,15% and 30% were welded by continuous flash butt welding under the same welding technology parameters.

用连续闪光对焊方法在同种焊接规范下分别对增强相含量为0%、15%、30%的SiCp/3003Al复合材料进行了连接，利用光学显微镜、SEM、AG-25TA型电子拉伸试验机对焊缝组织及性能进行分析，结果表明：含15%、30%SiCp的复合材料焊缝成型良好，含30%SiCp的复合材料接头强度最高。

Yun-strip method, the circle-shaped bath temperature higher than the crescent-shaped article transport transport of temperature, the temperature was higher than the crescent-shaped article transport serrated Article transported bath temperature, in the 12mm flat bottom welded seal, using serrated transport of , and with the magnitude and the swinging groove on both sides of the pause, effective control of the bath temperature, so that pore size of the melt is essentially consistent with the roots do not form a welding groove tumor and decrease the chances of burn-through, no penetration has The improvement of the peace panels of the single-sided welding butt welding flat-sided shape is no longer difficult.

运条方法，圆圈形运条熔池温度高于月牙形运条温度，月牙形运条温度又高于锯齿形运条的熔池温度，在12mm平焊封底层，采用锯齿形运条，并且用摆动的幅度和在坡口两侧的停顿，有效的控制了熔池温度，使熔孔大小基本一致，坡口根部未形成焊瘤和烧穿的机率有所下降，未焊透有所改善，使乎板对接平焊的单面焊接双面成形不再是难点。

Engine work, if crude oil filter was a serious blockage of impurities, or due to low temperatures when the oil viscosity changes, the main oil缺油Road will be the engine will lose lubrication, this is very dangerous, especially in the main bearings and connecting rod bearings, if there is no oil will be burned, bearing alloy heat due to friction loss and even journal welded together, eventually forcing the engine to stop working.

发动机工作时，若机油粗滤器被杂质严重淤塞，或者由于气温低而机油粘度变大时，主油道就会缺油，发动机就会失去润滑，这是很危险的，特别是主轴承和连杆轴承，如果没有润滑油会烧坏，轴承合金会因摩擦发热而流失，甚至和轴颈熔焊在一起，最终迫使发动机停止工作。

Meanwhile, the microstructures and mechanical properties of friction welded drill pipes have been compared with those of hot-upsetting drill pipes.

试验结果表明，采用摩擦焊接及焊后调质热处理工艺制造的DZ60地质钻杆焊接接头的常规力学性能指标均高于地矿部DZ60地质钻杆管材的技术标准规定的数值，并优于采用现行热墩粗工艺制造的钻杆管材的力学性能数值。

The mechanical properties and metallographic structures of the friction welded drill rod and the hot upset forged drill rod pipe are compared.

本文叙述了这种钻杆的焊接性，并与采用热镦粗工艺生产的钻杆管体金相组织和机械性能进行了对比。

Lugalbanda was a god and shepherd king of Uruk where he was worshipped for over a thousand years.

Lugalbanda 是神和被崇拜了一千年多 Uruk古埃及喜克索王朝国王。

I am coming just now,' and went on perfuming himself with Hunut, then he came and sat.

我来只是现在，'歼灭战perfuming自己与胡努特，那麼，他来到和SAT 。