查询词典 welded joint

The welding dislodgement machine is changes the welded joint position the important equipment, obtained the wide spread application in the robot welding.

焊接变位机是改变焊缝位置的重要设备，在机器人焊接中得到了广泛应用。

The microstructure and properties of steel SUS304 MAG welded joint was studied through metallograph observation and property tests.

通过金相观察、力学性能和耐晶间腐蚀性能试验，研究了SUS304不锈钢MAG焊接头组织与性能。

Properties of pearlitic steel and austenitic stainless steel compound pipes TIG welded joint are studied in this paper.

研究了珠光体钢和奥氏体不锈钢复合管钨极氩弧焊接头的性能。

Through large amount of knowledge acquisition from actual engineering, expert systems for welding procedure planning and precalculation of welded joint properties have been successfully developed in several types of knowledge indication methods such as production rules and processes.

因此，本文研究的主要目的就是探索应用电子计算机技术改造传统产业的理论模式和方法，研制出实用的焊接工程应用软件，改变锅炉及压力容器制造业目前编制工艺流程手工准备的落后状态。

Experiment results show that though the grains of the heat-affected zone are seriously coarsened due to the effect of welding thermal cycle, there is no softened zone and the strength of the welded joint doesn′t decrease because the transformed microstructure is different from the original one.

结果表明：经过焊接热循环的作用，虽然热影响区的晶粒明显粗化，但由于所获得的二次组织形态与钢筋原始组织不同，热影响区未发生软化，也不存在焊接接头强度下降的问题。

Experiment results show that though the grains of the heat-affected zone were seriously coarsened due to the effect of welding thermal cycle, there is no softened zone and the strength of the welded joint doesn't decrease because the transformed microstructure is different from the original microstructure of the rebar.

结果表明：经过焊接热循环的作用，虽然热影响区晶粒明显粗化，但由于所获得的二次组织形态与钢筋原始组织不同，热影响区不发生软化，也不存在焊接接头强度下降问题。

The result shows that the equalmatching characteristic of 10Ni5CrMoV steel welded joint is prominent.The probability of equalmatching is 48.11%,as well as,that of undermatching and overmatching are 47.55% and 4.34%,respectively.The mean-value of strength matching coefficient is nearly higher than its lower ...

计算结果表明，10N i5CrMoV钢焊接接头的等强匹配特征明显，等强匹配概率为48.11%，低强失配和超强失配概率分别为47.55%和4.34%；强度匹配系数均值偏下限，为0.955；由于母材强度数据的标准差比焊缝要大，约为1.54倍，从而使得强度匹配系数离散度较大；此外，焊接接头强度匹配系数小于0.86的概率为2.96%，可能会导致焊接接头产生冷裂纹。

In the condition of big practical extruded 6005A alloy welded joint, the softing degree of mentioned above soft zone obviously decreases, attributed to that there is a reinforce rib which have obvious heat scatting action, and then decreases the temperature increasing during welding.

对进口的6005A大型多孔铝型材焊接接头进行分析，发现焊接接头上软化区硬度降低的程度明显较小，这是由于实际的多孔型材在该部位设置有加强筋，加强筋有显著的散热作用，降低了焊接过程中该部位的温升。

Compared with arc welding, gas welding flame temperature is low, heat dispersion, heat slowly, so productivity is low, the workpiece deformation of serious, large welding heat affected zone of welded joint quality.

它与电弧焊相比，气焊火焰的温度低，热量分散，加热速度缓慢，故生产率低，工件变形严重，焊接的热影响区大，焊接接头质量不高。

The results indicate that the CTOD values of welded joint are lower than those of all base plate of identical crack length.

结果表明，焊接接头的CTOD值均低於同裂纹尺寸的全母材。

On the other hand, the more important thing is because the urban housing is a kind of heterogeneity products.

另一方面，更重要的是由于城市住房是一种异质性产品。

Climate histogram is the fall that collects place measure calm value, cent serves as cross axle for a few equal interval, the area that the frequency that the value appears according to place is accumulated and becomes will be determined inside each interval, discharge the graph that rise with post, also be called histogram.

气候直方图是将所收集的降水量测定值，分为几个相等的区间作为横轴，并将各区间内所测定值依所出现的次数累积而成的面积，用柱子排起来的图形，也叫做柱状图。