查询词典 weaver's beam

In order to satisfy the equipment of physical experiment, it developed beam pulse technology research on ns-200 accelerator. It uses sine-wave beam adjustment pipe focused beam match design research beam pulse system、high frequency power supply system, pulse measure system and distance auto-control system.

在ns-200中子发生器上开展了束流脉冲化技术研究工作，采用正弦波速调管聚束方法设计了束流脉冲化系统，研制了高频电源系统、脉冲测量系统和远程自动控制系统。

Finally, based on the theory of Timoshenko beam, a beam model of this crankshaft is built, which is compared with solid model. The results indicate that this beam model can meet the needs of calculation precision and calculation efficiency. With this beam model, the condition in which real loads are put on the crankshaft is simulated. The displacement curves、velocity curves、acceleration curves of the main journals and the pulley of this crankshaft and torsion vibration curve of the pulley are then gained. With these curves, the dynamic characteristic of the crankshaft is analyzed. The conclusion indicates that this crankshaft has good dynamic characteristic.

最后利用Timoshenko梁理论建立了曲轴的梁单元模型，将此梁单元模型与体单元模型进行了比较，结果表明梁单元模型能够满足精确度和计算效率的要求；利用该梁单元模型，模拟了实际条件下的载荷作用时曲轴的响应，得到了曲轴各主轴颈和皮带轮端的位移、速度、加速度曲线以及皮带轮端的扭转振动曲线，分析了曲轴的动态特性，结论表明该型曲轴具有良好的动态特性。

Experiment 1. Observation of electron beam deflection in the electric field Will voltage electron beam deflection plate to tie the direction switch "is" location, rotating clockwise direction deflection plate voltage Potentiometers (RP2), the electron beam is deflected upward, the greater the voltage between the deflection plate, the electron beam deflection angle the bigger.

实验一。观察电子束在电场中的偏转将电子束偏转板电压方向开关扳到&上正&位置，顺时针方向旋转偏转板电压电位器(RP2)，电子束则向上偏转，偏转板之间电压越大，则电子束偏转的角度越大。

Then after closure, taking steel perimeter beam and perimeter beam rail as slip base, in order of symmetrical balance, hoisting each steel "leaf" respectively up to the installation platforming of steel leaf, again by utilizing the steel perimeter beam, perimeter beam rail and hydraulic thrusting slip equipment, performing the installation for the eight steel leaves until they are closed together.

施工中采用了&一点吊装、平面滑移&的技术进行安装，即采取同一固定点吊装，先将分段钢环梁利用环梁轨道和液压顶推设备滑移，分段逐步滑移和顶推、逐步拼接，直至钢环梁合拢。将合拢后的钢环梁和环梁轨道作为滑移底座，按对称、平衡的顺序将每片钢叶瓣分别吊装至安装平台上，再次利用钢环梁、环梁轨道和液压顶推滑移设备，将8片钢叶瓣逐步安装到位。

In reference to Figure 10.6a,when the beam width is less than the column width ,the effective joint width is the average of the beam width and column width ,but it should not exceed the beam width plus one-half the column depth h on each side of the beam .

在谈到图10.6a ，当光束宽度小于栏宽，有效地联合宽度平均束宽度和栏宽，但它不应超过束宽加一半栏深度h每边的梁。

When a plane wave illuminates the bottom of axicon with ring obstacle, a bottle beam is generated within the maximum non-diffractional distance, and the beam keeps non-diffractional Bessel beam in front and at the back of the Bottle beam.

平面波入射到带有环形障碍物的轴棱锥底面时，将在轴棱锥产生的最大无衍射距离内形成Bottle beam，而在Bottle beam的前后仍然保持无衍射贝塞尔光。

Another battle also was fought against the Philistines, in which Adeodatus the son of Saltus a Bethlehemite slew the brother of Goliath the Gethite, the staff of whose spear was like a weaver's beam.

以后，又与培肋舍特交战，雅依尔的儿子厄耳哈难击杀了加特人哥肋雅的兄弟拉赫米。这人的长矛粗如织布机的横轴。

And there was a third battle in Gob against the Philistines, in which Adeodatus the son of the Forrest an embroiderer of Bethlehem slew Goliath the Gethite, the shaft of whose spear was like a weaver's beam.

以后，在哥布又与培肋舍特人交战，白冷人雅依尔的儿子厄耳哈难，杀了加特城人哥肋雅的兄弟拉赫米；这人的长矛粗如织布机的横轴。

And there was again a battle in Gob with the Philistines, where Elhanan the son of Jaareoregim, a Bethlehemite, slew the brother of Goliath the Gittite, the staff of whose spear was like a weaver's beam.

21：19 又在歌伯与非利士人打仗，伯利恒人雅雷俄珥金的儿子伊勒哈难杀了迦特人歌利亚。这人的枪杆粗如织布的机轴。

And there was again a battle in Gob with the Philistines, where Elhanan the son of Jaareoregim, a Bethlehemite, slew the brother of Goliath the Gittite, the staff of whose ear was like a weaver's beam.

21：19 又在歌伯与非利士人打仗，伯利恒人雅雷俄珥金的儿子伊勒哈难杀了迦特人歌利亚。这人的枪杆粗如织布的机轴。

Finally it offers the analysis of the fault-tolerance system as well as its test verification.

这样，运行于空间环境中的系统的设计目标就是在保证系统实时性

However, it is still difficult to find out the real reason of the increase of the keratinized gingiva during the orthodontic extrusion whether it is due to the proliferation of the gingival tissue or to its elastic nature, that is because the proliferation of the fibroblasts as well as the connective tissue changes in volume and the intra-fibers spaces were all immeasurable in most of the studies.

然而，仍然难以找到真正的原因增加的角化牙龈在正畸挤压它是否是由于扩散的牙龈组织或其弹性性质，这是因为增殖的成纤维细胞以及作为结缔组织的变化量和内部纤维空格都是不可估量的，大多数的研究。