查询词典 wave

As the foundation of ultrasonic testing of composite materials, this thesis is intended to explore in detail a number of features of wave propagation in anisotropic plates, and the following essential problems will be considered:(1) Propagation of plane bulk waves in homogeneous and orthotropic anisotropic media;(2) Lamb wave propagation in multilayered anisotropic plates;(3) Influence of isotropic solid or liquid loading on Lamb wave propagation in anisotropic solid media;(4) Influence of interface layers on Lamb wave propagation in layered anisotropic composite laminates;(5) Dispersion characteristic analysis of attenuation Lamb wave while existing an thin viscous layer which is used for simulating the poor curing in adhesively bonded joints.

作为复合材料超声检测的基础，本文研究了如下国际前沿性的课题：（1）平面体波在正交均匀各向异性媒质中的传播；（2）多层各向异性媒质中Lamb波的传播；（3）各向同性固体或液体负载对各向异性固体媒质中Lamb波传播的影响；（4）界面层对层状各向异性复合媒质中Lamb波传播的影响；（5）胶粘剂未固化而呈现粘弹性时粘接结构中衰减Lamb波的频散特性分析。

The paper presents a linear transient solution for the solitary wave generated by a piston-type paddle in a finite flume based on the boundary condition derived by Dean and Dalrymple (1991). The wavemaker problem is simplified by decomposing the wave potential into two parts. One is the evanescent wave and the other is progressive wave. The possible solution for the evanescent wave is expressed in form of the Fourier series.

本文根据Dean与Dalrymple（1991）描述造波水槽内部之线性边界条件，将水槽内部之流速势分为振荡波与前进波以简化问题，再以Fourier级数展开，可将问题化为二非齐次常微分方程式，在给定造波初始条件的情况下即可解析有限长度造波水槽自静止开始造波一段时间后停止之线性暂态解。

Compared with the initial value problems of scalar conservation laws with smooth flux function, the global weak entropy solutions for the initial-boundary value problems of scalar conservation laws with weak discontinuous flux function include the following new interaction types: a rarefaction wave collides with the boundary and is absorbed compltetely or partially by the boundary; a rarefaction wave collides with the boundary and the boundary will reflect a contact or non-contact shock wave; a contact or non-contact shock wave collides with the boundary and is absorbed by the boundary; a contact or non-contact shock wave collides with the boundary and a new non-contact shock will rebound from the boundary simultaneously or later.

与具有光滑流函数的单个守恒律的初始值问题相比，具有弱间断流函数的单个守恒律初边值问题的整体弱熵解中包括下列新的相互作用类型：稀疏波碰到边界并被边界部分或全部吸收；稀疏波与边界相撞，边界反射出一个接触或非接触激波；接触或非接触激波碰到边界并被边界吸收；接触或非接触激波与边界相撞，边界同时或稍后反射出一个新的非接触激波。

Results: Objective hearing loss were at different levels, with the main wave (including wave ⅠⅢ and Ⅴ) having 4 kinds: with each wave peak latencies and interpeak latencies at normal range; with each wave PL prolonged but IPL at normal range; with IPL prolonged; and main wave being absent dissimilarly.

结果 客观听力不同程度损失，主波分化有4种情况：①Ⅰ、Ⅲ、Ⅴ波都能引出，各主波峰潜伏期、峰间潜伏期在正常范围；②Ⅰ、Ⅲ、Ⅴ波都能引出，IPL均延长，IPL正常；③Ⅰ、Ⅲ、Ⅴ波都能引出，IPL延长；④各主波有不等缺失。

We develop and apply the Hirota bilinear-θfunction method,Jacobi elliptic function expansion method,linear superposition method and F-expansion method respectively to solve many 2+1 dimensional nonlinear wave models including 2+1 dimensional 2DsG equation,the coupled ZK equation,2+1 dimensional KdV equation,2+1 dimensional long wave short wave resonance interaction equation and 2+1 dimensional dispersive long wave equation,abundant Jacobi elliptic function doubly periodic solutions are derived.These solutions show various periodic wave shapes and special periodic characters.

发展和应用Hirota双线性-θ函数方法，雅克比椭圆函数展开法，线性叠加法，F-函数展开法等分别求解2+1维2DsG方程，耦合ZK方程，2+1维KdV方程，2+1维长波短波共振相互作用方程，2+1维色散长波方程，获得丰富的雅克比椭圆函数双周期波解，描述了一些周期波形态及周期特性。

Based on the item of national high technology development project, the thesis studies the reasonable construction pattern of the tunnel portal, incidence of the micro-pressure wave and the the effect of bell-mouthed hood, lacunaris hood and expansile hood on alleviating the micro-pressure wave in the situations of single line and double line, obtains the relationship between the max micro-pressure wave and the velocity of the train as well as the relationship between the max micro-pressure wave and distance of measuring point at the velocity of 100km/h-550km/h, compares the different alleviative effect of the three different hood to max micro-pressure wave and finally proposes the reasonable construction pattern of the tunnel portal.

本文针对国家高技术研究发展计划(863计划)课题"磁浮交通沪杭线越黄浦江隧道的工程技术问题研究"，在单洞单线和单洞双线两种工况下，对隧道洞口的合理结构形式和影响范围，以及洞口喇叭形入口缓冲段、多孔壁入口缓冲段以及隧道出口膨胀室对减缓微压波的作用进行了研究，得到了磁浮列车速度在100km/h～550km/h时隧道出口微压波最大值与速度的关系以及微压波最大值与测点距离的关系，比较了三种不同形式缓冲结构对微压波最大值的减缓效果，提出了隧道洞口的合理结构形式。

Derives the formulae for calculating the distortion and stress on the acting surface of flexspline load in the drive process of the harmonic gear drive with three-wave wavegenerator;(2) analyzes and compares the performance of plastic and steel products under light load drive and calculates the probably reached limit of drive ratio for both types of flexsplines under the same load;(3) applies the harmonic gear drive with three-wave wavegenerator to the small-sized multiple-revolution electric device of valves by taking into consideration of the low limit of the drive ratio for the harmonic gear drive with three-wave wavegenerator made of plastics, improves the design on the main drive mechanism of the traditional small-sized multiple-revolution electric device of valves, and validates through examples the feasibility for the harmonic gear drive with three-wave wavegenerator made of plastics to be applied to the small-sized multiple-revolution electric device of valves. Finally the author performs calculations on the two types of the flexsplines of the harmonic gear with three-wave wavegenerator by using the finite element method and analyzes the causes for the errors.

本文根据三波谐波齿轮传动的运动变形特点，采用弹性薄壳的力矩理论，推导了三波谐波齿轮传动柔轮载荷作用面上的变形及应力计算公式；分析比较了轻载传动情况下塑料和钢材的性能，计算了塑料制谐波柔轮和钢制谐波柔轮在相同载荷情况下可能达到的传动比极限；对塑料制及钢制三波谐波齿轮柔轮进行了有限元计算，分析了产生误差的原因；针对三波塑料谐波齿轮传动比极限低的特点，将之运用于小转矩多回转阀门电动装置中，对传统的小型多回转阀门电动装置的主传动机构进行了改良设计，并通过实例验证了三波塑料谐波齿轮传动在小转矩多回转阀门电动装置中应用的可行性。

The solitary wave can be generated considering Goring and Raichlen's movement of a paddle. The proposed original linear solution for the solitary wave generation is expressed in the hypergeometric function. Two disadvantages of the original solution with large trailing wave and skewed wave profile are found by comparing with the theory of solitary wave derived from Boussinesq's equation.

本文并以弱非线性的孤立波造波问题做为解析之对象，由於孤立波造波板速度为一超越函数，造成解析上的困难；本文以 hypergeometric 函数推求常微分方程式之全解，并与理论波形解比较后，发现由於未考虑非线性及分散性过强等问题，使得线性暂态解较理论波形拉长与歪斜，可能无法有效描述孤立波造波问题，故针对线性之分散关系做出修正。

Wave after succeeding in escaping make track for of seal shot once the wave met to compare his shape short and small emperor penguin, they were brave, optimism, love help other people and solidify again very intelligent, they all appreciated a wave very much of dance, they decided to help a wave after knowing wave the career of the wave.

有一次在逃脱海豹的追击后波波遇到了比他身材矮小的帝企鹅，它们勇敢、乐观、爱帮助别人并且团结又很聪明，它们都很欣赏波波的舞蹈，在知道了波波的经历后它们决定帮助波波。

In section one, by using FICE scheme and TIME-GCM, a model of trace gases and OH airglow affected by gravity wave is set up, then the propagation of nonlinear gravity wave and the effect on trace gases and OH airglow are analyzed. The result shows gravity wave excited by tropospause forcing can propagate stably to the mesosphere through the stratosphere so that energy and momentum can be transferred from one region to another. In this process, gravity wave undergoes growth, overturning, convection and breaking. And the no-isothermal structure can accelerate the breaking of gravity wave in mesospause, and the breaking of gravity wave is an important source of convection and small-scale waves.

在第一部分的工作中，利用全隐欧拉格式和全球热层-电离层-中间层-电动力学环流耦合模式，对重力波的非线性传播及其在传播过程中对中高层大气中氧族和氢族成分和与之密切相关的OH气辉辐射的影响进行了数值模拟，结果表明，从对流层向上传播的重力波经历了产生、发展、饱和、对流产生直至破碎的非线性演化，大气的非等温结构加速了重力波在中层顶区的破碎，重力波的非线性传播是小尺度对流和湍流产生的一个重要的源。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐