查询词典 water rate

The results showed that, under the condition of soil water stress during the flowering stage of potato, the daily changes of net phoTo,synthetic rate, transpiration rate and stomatic conductance were parabola type.

结果表明，在马铃薯生育关键期土壤水分亏缺情况下，4种处理叶片净光合速率、蒸腾速率和气孔导度的日变化曲线均为开口向上的抛物线，而净光合速率日变化是气孔调节作用的结果。

Under high fertilizer condition,the soil water was consumed largely during the early period,therefore,the crop suffered severe drought stress during the procreation stage, and the net photosynthetic rate, transpiration rate and stomatic conductance of potato declined greatly.

高肥处理时，由于马铃薯植株生长旺盛，营养生长期水分消耗过大，生殖生长期土壤水分供应状况更差，作物受到严重的水分胁迫，导致气孔导度、净光合速率和蒸腾速率大幅下降。

The results of surface dose rate determined with lithium fluoride thermoluminescent dosimeter chips in water-organic glass phantom and air had no obvious difference and the surface dose rate and its uniformity,(3.46±0.011) and (0.178±0.15)nGy/h*107Bq were obtained.

用LiF热释光片在水-有机玻璃体模及空气中，分别作125I眼科巩膜敷贴器的表面剂量测定，结果在误差范围内无明显区别，得到的最终表面剂量及其均匀性分别为：(3.46±0.01)、(0.178±0.15)nGy/h*Bq。

The results showed that C. chinensis net photosynthetic rate, transpiratory rate, stomatal conductance were dereased with the increase of stress and the degress of the decrease were the least ones urder light water stress concentrations of intercellular CO2 decreased with the increase of stress. Seedlings of C.

结果表明：紫荆净光合速率、蒸腾速率、气孔导度随着胁迫强度增加呈现出降低的趋势，但在轻度水分胁迫时的降低最少；紫荆的细胞间隙CO2浓度随着胁迫强度的提高呈现出升高的趋势。

The results indicated that the utilization rate of raw materials increased by 2%, the utilization rate of waer increased by 50%, and the average economic benefits of cassava increased by 50RMB/t, on the other hands, the production cost and treatment cost of waste water decreased.

结果证明，原料利用率提高2%，水利用率提高50%，木薯平均提高经济效益50元／t，提高了原料、水、能源的利用效率，降低了生产和废水处理成本。

The rate of wetting front advance and infiltration rate under certain ponded infiltration was significantly reduced by Sodium Polyacrylate , and as a result effectively reduced water in a sandy soil leaking to a deeper layer under the plough layer.

砂土的饱和导水率随着高分子化合物聚丙烯酸钠用量增加而降低，在恒定水头入渗条件下，聚丙烯酸钠降低了水分向深层运移的速度，同时降低了砂土的入渗速率，可以有效降低砂土水分的深层渗漏。

The results showed that after the adding starch to the sheet, the viscosity of the PVA solution increased, the dissolution time of the sheet got longer, the rate of enlargement in water was smaller, the rate of moisture became smaller, stretch intensity enhanced and the change of shape diminished; also it could be seen from the surface of sheet that the starch existed in PVA sheet as the shape of conglomerating particle.

结果表明，加入淀粉后，PVA溶液的粘度增大，膜的溶解时间变长，水上伸长率变小，含水率变小，扯断强度增强，形变缩小；通过膜表面观察，发现淀粉在膜中以聚集颗粒状态存在。

This flocculating agent has good water solubility. Dissolving rate is quicker than traditional synthesized flocculating agent such as poly-propionamide. It overcomes flaws of slow dissolving rate and inconvenient field using of traditional poly-propionamide; because of copolymerizing with natural product Amorphophallus konjac, it has advantage of strong natural product biodegradation. After be used, it do not cause secondary pollution. It can be used in process of city domestic sewage and industrial sewage.

本发明絮凝剂具有良好的水溶性，溶解速度比传统的合成类絮凝剂如聚丙酰胺类更快，克服了传统聚丙酰胺溶解速度慢，现场使用不方便的缺点；而且由于与天然产物魔芋胶共聚，同时具有了天然产物可生物降解性强的优点，使用后不易造成二次污染，可以应用于城市生活污水和工业废水处理中。

The effect of decalcifying agent dosage, reaction temperature, water injection rate and sedimentation time on the calcium removal rate was investigated.

考察SF型脱钙剂加剂量、反应温度、注水率、沉降时间等因素对脱钙效果的影响。

Robinia for forage; Photosynthesizes rate; Transpiration rate; Water use efficiency

中南林业科技大学，湖南长沙 410004 饲料型刺槐；净光合速率；蒸腾速率；水分利用效率

However, as the name（read－only memory）implies, CD disks cannot be written onorchanged in any way.

然而，正如其名字所指出的那样，CD盘不能写，也不能用任何方式改变其内容。

Galvanizes steel pallet is mainly export which suits standard packing of European Union, the North America. galvanizes steel pallet is suitable to heavy rack. Pallet surface can design plate type, corrugated and the gap form, satisfies the different requirements.

镀锌钢托盘多用于出口，替代木托盘，免薰蒸，符合欧盟、北美各国对出口货物包装材料的法令要求；喷涂钢托盘适用于重载上货架之用，托盘表面根据需要制作成平板状、波纹状及间隔形式，满足不同的使用要求。