查询词典 water pressure

It would not be influenced by the vibration,fluctuating steam pressure,and the water hammer.

不受震动、蒸汽压力波动和水锤的影响。

Water hammer resistant and no effect from abrupt change of pressure.

抗水击，对压力突然变化没有影响。

No flow of water occurs through the pipe unless there is a difference in pressure.

若没有不同的压力给管道的话，那么就不可能有流动的水通过管道。

The water will freeze and plug the pressure-relief vent, which may result in container failure.

水会结冰并堵塞减压装置的出口，这会造成容器故障。

And the variations of pore pressure with the wave height and wave period and water depth have also been discussed.

本文还分析了立波作用下，防波堤周围的孔隙水压力变化规律。

The products certifying censor for domestic gas water-heater, domestic pressure regulators for liquefied petroleum gas, and domestic gas appliances are set in CGAC.

意大利著名休闲品牌gas，新潮的流行元素，高质量的面料和大规模的生产设备都是grotto s.p.a。

The illuminance in row of cold type wheat "Shaan 229" in row is 0.5~7.0 klx lower than that of warm type wheat "NR9405" in during milk-filling and burliness stage, the water-vapour pressure and the relative humidity are 30~l80Pa and 1%~10%higher than those of "NR9405", also the air temperature and soil temperature are higher while the upgrowth delay.

结果表明，在一定范围内，与暖型小麦"NR9405"相比，冷型小麦"陕229"灌浆结实期间的株间气温偏低0.5~2.3℃，0~0.2m土层温度偏低0.3~4.0℃，株间水汽压和相对湿度分别偏高 30~180 Pa和1%~10%，株间光照度偏小0.52~7.08 klx，且株间气温差及土壤温差随生育期推迟增大。

You try and use the pressure every 4 hours watering can poured in the trunk water, to Jiaotou.

您尝试使用压力每4小时浇水可以在树干倒在水中，以藠头。

A garment's waterproofness is determined by its ability to resist water entry pressure encountered.

何谓防水？衣服是否防水，其实是透过计算水压能否令水分穿透布料，造成渗漏。

It is confirmed by laboratory test and field test that both of them have good effect on unplugging in oil well, decreasing pressure and increasing injection rate in water well, profile control at well group, reservoir sweep, and so on.

室内实验和矿场应用结果表明，在油井解堵、水井降压增注及井组调剖驱油等方面都见到良好效果。

I can not make it blossom and suits me

我不能让树为我开花

When temperatures are above approximately 80 °C discolouration of the raceways or rolling elements is a frequent feature.

当温度高于 80 °C 左右时，滚道或滚动元件褪色是很常见的特征。