查询词典 walled-up

At the same time, is also the stainless steel industry earlier through ISO9001 (2000) international quality system certification of enterprises, with advanced equipment, scientific management and operation of a very modern concept, products awarded as "China Famous" designation, and the Ministry of Construction in China Building Decoration Association of Architectural Ironmongery identified by the Commission as "project selected products", all products comply with CJ; T 151-2001 "thin-walled stainless steel pipes" GB12771 "fluid steel pipe welded stainless steel" GB; T 18705-2002 "decorative soldering Stainless Steel Pipe ", GB; T19228.2-2003" stainless steel compression-type pipe fittings to connect with thin-walled stainless steel tube "and other standards.

同时，也是不锈钢行业较早通过ISO9001（2000）国际质量体系认证的企业，凭着先进的设备、科学的管理和极具现代化的经营理念，产品荣获《中国名优产品》称号，并被建设部中国建筑装饰协会建筑五金委员会确认为"工程建设选用产品"，所有产品符合CJ；T 151—2001《薄壁不锈钢水管》 GB12771《流体输送用不锈钢焊接钢管》GB；T 18705-2002《装饰用焊接不锈钢管》、GB；T19228.2—2003《不锈钢卡压式管件连接用薄壁不锈钢管》等标准要求。

In Laplace space, the exact element stiffness matrix of the axial, torsional and bending vibrations of cone-shaped and symmetrical closed thin-walled bars are derived. By use of variation principle, the element stiffness matrix of the coupling vibrations of an asymmetrical closed thin-walled bar is also given.

在拉氏空间中导出了锥形杆件和对称闭口薄壁杆件的轴向、扭转和弯曲振动的精确单元刚度矩阵，应用变分原理也给出了非对称闭口薄壁杆件耦联振动的单元刚度矩阵。

Results (1)Findings characteristics:small vacuole sign,pleural retraction sign and obstructive pneamonia only oppeared in peripheral lung cancer,thin-walled cavity less than 3 cm in diameter should be seen peculiar sign of it,thick-walled inregular cavity could be found in inflammatory pseudotumor and tuberculoma,spiculate protuberance showed mostly in peripheral lung cancer,but appeared in inflammatory lesion too,air bronchogram,pleural tail sign and long spiculation appeared mostly in inflammatory pseudotumor,calcification,pleurae thckening appeared mostly in tuberculoma.

结果（1）征象特点：小泡征、胸膜凹陷征、阻塞性肺炎仅见于周围型肺癌；小于3cm薄壁空洞为周围型肺癌的少见征象之一；炎性假瘤、结核球可出现不规则厚壁偏心空洞；棘状突起除周围型肺癌多见外，炎性病变亦可出现；支气管充气征、长毛刺、胸膜尾征炎性假瘤出现率高；钙化、胸膜肥厚结核球多见。

The research mainly focuses upon the unique deformation mechanism, forming method, quality control and parameter optimization, and the key technologies in Finite Element Analysis for the 3D Non-Axisymmetric thin-walled tube spinning. A CNC spinning equipment for the 3D Non-Axisymmetric thin-walled tube has been designed and manufactured based on the experimental investigation of the forming method.

着重研究变形机理、成形方法、质量控制及优化成形工艺参数，解决三维非轴对称零件旋压成形过程数值模拟关键技术；通过对成形工艺方法的试验研究，研制出能够旋压成形三维非轴对称薄壁空心零件的工艺装备。

The structure and morphology of CNTs which have been purified and not yet, were characterized by TEM, SEM, XRD, Raman, TG-DTA, BET, IR. The results indicated that when the stokehole reaction temperature was 1170℃,the decompose temperature of Ferrocene was 150℃,he volatilize temperature of Benzene was 50 ℃, hydric flow rate was 270ml/min, the concentration of thiophene was l% and the reaction time was 20 minutes, the CNTs with single-walled and multi-walled were prepared.

结果表明：炉膛反应温度1170℃、二茂铁的分解温度150℃、苯的挥发温度50℃、氢气的流量270ml／min、噻吩体积分数1.00／100ml苯、反应时间20min时，可以得到碳纳米管，既有单壁管又有多壁管，单壁管的内径分布在0.88～1.15nm之间，多壁管的直径分布在40～120nm之间；纯化后的碳纳米管比表面积增加，管壁光滑，而且产生了大量的含氧官能团，有利于在水溶液中的分散。

He modeling is the thin walled column model in which the shear walls connected each other in horizontal are regarded as a thin walled column, and the part between openings in vertical are regarded as a tie beam. The programs based on this kind of model is TAT. Two kinds of super element generalized- wall-element and elastic-slab-element are defined, which are condensed from shell element based on the theory of sub-structure, SATWE is based on the model.

AT采用薄壁柱模型，将同一层彼此相连的剪力墙墙肢作为一个薄壁杆件单元，把上下层剪力墙洞口间的部分作为连系梁单元；SATWE引入两种超单元：通用墙元和弹性楼板单元，采用子结构理论用在壳元基础上凝聚而成的墙元模拟剪力墙。

The mechanical autofrettage of thick-walled cylinders is a sort of practical and valuable technique used to enhance its elastic strength of thick-walled tube and increase its fatigue life.

厚壁圆筒机械自紧技术是一项有实用价值的工艺技术，它可提高厚壁圆筒的弹性强度和疲劳寿命。

The mechanical autofrettage of thick—walled cylinders is a sort of practical and valuable technique used to enhance its elastic strength of thick—walled tube and increase its fatigue life.

厚壁圆筒一次和二次机械自紧技术的理论与实验研究机械自紧

The mechanical autofrettage of thick—walled cylinders is a sort of practical and valuable technique used to enhance its elastic strength of thick—walled tube and increase its fatigue life.

厚壁圆筒机械自紧技术是一项有实用价值的工艺技术。

In view of mention above,a new spatial thin-walled beam element model considering forementioned those effects and available in the analysis of thin-walled structures is aimed to be established.

鉴于此，本文拟建立一能够考虑上述影响因素，且适用于薄壁杆系结构分析的空间薄壁截面梁单元模型。

We got alerted a couple of times while we were down south that HETs were on the way to bring us back up north because things were going to go hot again, but it was just rumors.

南下的途中我们不只一次得到警告说重型装备运输车将拉着我们重新北上，因为局势正在变得重新紧张起来，但这只是谣传。

It's the one where they find the ghost in the salt mine.

这一集是演他们在盐矿找到鬼