查询词典 wall bearing

On the basis of a study and elaboration of data, some important conclusions are presented:(1) ruby deposits in marbles occur in the plutonic metamorphic zones of orogens where deep fault structure is developed;(2) ruby-bearing rocks are calcic crystalline marbles, rather than magnesian marbles;(3) amphiboles in ruby-bearing rocks are not tremolites, but silica-poor, alumina-rich and chrome-bearing calcic amphiboles, such as chrome-bearing magnesio-sadanagaites; and (4) the deposits are genetically of thermodynamical metamorphism type, rather than of pneumatolito-hydrothermal type or skarn type.

目前，对于与此类型矿床找矿相关的若干成因问题的认识，还相当模糊，主要表现在以下几方面：①对此类型矿床的产出构造背景认识不清；②认为含矿岩石为镁质大理岩或镁质夕卡岩；③认为含矿岩石中与红宝石共生的角闪石为透闪石；④认为此类矿床的成因类型为&气成一热液型&或&夕卡岩型&。本文在实际研究(王礼胜，1996)和文献资料整理的基础上，分别对这些问题给予了澄

Directed against the problem on confirming vertical bearing capacity of large diameter cast-in-place pile in the west of coteau area of Yunnan province, the paper, analyses the influence degree of the variety of soil physics and mechanics property in area geology condition on bearing capacity of pile foundation, through 5 piles' loading test; the influence degree of construction technics on bearing capacity of pile foundation under the influence of every exterior factors; the influence degree of grouting injection around the pile shaft on bearing capacity of pile foundation.

本文针对滇西山区大直径灌注桩竖向承载力确定存在的问题，进行了5根试桩的静载荷试验，分析了区域地质条件下土的物理、力学性质的变化对桥梁桩基承载力的影响程度；地下水对桩承载力的影响程度；各种外部因素影响下，桩的施工工艺对桩承载力的影响程度；通过在桩体周围土中注浆对桩承载力的影响程度。

Is the circular parts, for the two bearing rings, or bearing washer, or between two and a half or two and a half between the bearing ring between the bearing washer in order to maintain between them under the axial distance.

是环形零件，用于两个轴承套圈或轴承垫圈之间或两半轴承套圈之间或两半轴承垫圈之间以使它们之间保持所规定的轴向距离。

The effect of the friction moment of bearings on performance is researched. The forming mechanic and influence factors of the friction moment of ball bearing are analyzed. Suitable clearness and groove radius of ball bearings are obtained by experiment and calculation. The relationship between starting moment of ball bearing and various lubricants is analyzed. The measure for reducing the starting moment of ball bearing is put forward, it is the theory basis and reference for ball bearing design of small power unit system.The system is an unstable system when the 24-station ball pen tip production machine is running because of various interferences. It is too hard to describe the system by linear method, so the nonlinear formulation must be used.

研究了小动力头系统轴承摩擦力矩对运转性能的影响，分析了球轴承摩擦力矩的产生机理及影响因素，采用实验和计算的方法得到了动力头球轴承的合理间隙及球轴承沟曲率半径，分析了各种润滑剂与球轴承启动力矩的关系，并提出了减小轴承启动力矩的措施，为小动力头系统的轴承设计提供了理论依据及实践参考。24工位笔头加工机械在笔头的生产加工过程中，由于受到各种因素的干扰是一个不稳定系统，其稳定性会发生一定变化，而且很难用线性方法表述。

Japan IKO needle-type needle-like shell to maintain needle-type Rotary cut type needle roller bearing composite thrust bearing inner wheel sliding bearing rod end spherical bearings spherical joint bearing L-shaped linear bearings.

日本 IKO 针状保持型针状薄壳型针状旋削型针状复合型滚子轴承推力轴承内轮球面滑动轴承杆端轴承球状L形关节轴承直线轴承。

The company owns an advanced numerically controlled production line, and could provide several standard products such as single-row ball slewing bearing, cross roller slewing bearing, double-row ball slewing bearing, three-row roller slewing bearing, according to Standard "JG/T66-1999","JG/T67-1999","JG/T68-1999" and "JB/T2300-1999", and also could provide non-standard products according to the requirements of customers.

项目介绍（简介、技术特点、应用范围、市场前景、效益分析及对投资者要求。500字以内）回转支承产品结构有单排球式、双排球式、三排柱式、交叉滚柱式四大系列，可以按国家建筑机械行业标准《JG／T66—1999》、《JG／T67—1999》、《JG／T68-—1999》和机械行业标准《JB／T2300—1999》提供系列产品，同时也可以按照客户的要求来设计、制造非标准回转支承产品。

The application of the prior three-dimensional composite shock-proof bearing into the large span mesh roof structure has the following problems:(1) the level shock-proof bearing is series-connected with the vertical shock-proof device, the height of the bearing is large, so it is lack of stability ;(2) the horizontal displacement of the structure under earthquake is large,(3) it is lack of vertical pulling-proof ability, the bearing rotational capacity is insufficient.

现有的三维复合隔震支座要将其应用于大跨网格屋盖结构存在以下问题：(1)水平隔震支座与竖向隔震装置串连，支座的高度大，缺乏稳定性；(2)在地震作用下结构的水平位移较大；(3)缺乏竖向抗拔能力，支座转动能力不足。

The bearing inner ring and the axis tight fit, the outer ring bearing hole is a more loose with the non-separation-type bearings installed, press the bearings can be installed on the shaft, then shaft with bearings packed together into the bearing hole inside, if the bearing is small, can also be lighter than the soft metal hammer blow set

对无油轴承内圈与轴时紧配合、外圈轴承座孔是较松配合的非分离型轴承进行安装时，可用压力机将轴承先安装在轴上，然后将轴连同轴承一起装到轴承座孔内，若轴承较小时，也可用较软的金属锤轻击套

The dynamic analysis of bearing capacity reveals that the Northeast region in China, in comparison with other regions, has been rich in its bearing capacity of relative resources. Comparatively the bearing capacity of natural resources has increased its contribution to the comprehensive bearing capacity of the region while its economic resources are in decline so long its contribution is concerned.

以全国为参照区，通过对东北地区相对资源承载力的动态分析结果表明，东北地区的相对资源综合承载力一直呈富余状态，其中相对自然资源承载力对综合承载力的贡献率不断上升，经济资源对综合承载力的贡献率则不断下降。

The anatomical study deepens the knowledge of G-type conducting cells: 1 It proves the theory of two depositional process for secondary wall (Bierhorst, 1960): the discontinuous cellulose layer is laid down before the continuous lignified layer; the former layer is prone to be broken down, while the latter is highly decay-resistant; 2 It suggests that the cellulose primary and secondary walls of tracheids are not perforated. Instead of longitudinal pits (Li, 1992), the lignified tracheid secondary wall of Hsüa possesses irregular simple perforations; 3 In Hsüa reflexa and Huia gracilis, the perforation casts may represent the thickness of lignified secondary wall; 4 The wall structure of G-type tracheid is diversified. At the genus level, the secondary wall structure differs in the distribution, internal shape and structure of the perforations; 5 Perforations of some G-type tracheids combine the characters of S-type tracheids in their distribution, density and diameter.

解剖学的研究加深了对G-型输水管胞的认识 1）验证了管胞次生壁分两个阶段形成的理论（Bierhorst，1960），即先后形成不连续的纤维质层和连续的木质化层，前者易被分解，后者抗侵蚀性强；2）证明管胞纤维质的初生壁和次生壁不具穿孔，Hsüa管胞的木质化次生壁具有不规则的简单穿孔，而不是纵列的纹孔（Li，1992）；3）Hsüa reflexa和Huia gracilis的穿孔铸体可代表木质化次生壁的厚度；4）G-型管胞壁层结构具多样性，植物属一级的分异主要表现在次生壁穿孔的分布、孔腔形状和结构的不同；5）某些G-型管胞的穿孔在其分布、密度和孔径方面可兼有S-型管胞的特征。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"