查询词典 vortex

Experiments exposed that the inner flow of tooth space in the micro-channels was proved to be cycled flow after fully development. For the more, low velocity vortex cavities existed in the vertex angle and inner side of bend angle of straight angle micro-channel, while back flow only appeared in the internal side of bend angle of round angle micro-channel. It's easy to take place deposition in the low velocity vortex cavities, which is the main cause of blocking.

试验发现各类微通道齿间内流充分发展后是一种重复性流动，平角微通道顶角和转角内侧存在低速涡旋区，圆角微通道只在转角内侧出现回流，颗粒在低速涡旋区易发生沉积，是造成堵塞的主要原因。

To simulation of weather patterns, the capability of stimulation to 850hPa is not as good as the one to 500hPa, which may be caused by underlying surface. In addition, the capability of stimulation to 48h is also not as good as the one to 36h. By analysis of result of stimulation to heavy rainfall happened on 8 July, 2003, we have found that rain belt location and its heavy rain core amounts in sensitivity run are preferably displayed by MM5V3. Analyses indicate this event was in close relationship with the southwest low vortex moving to east from the Tibetan Plateau and low-level jet in front of vortex and shear line.

模拟结果总体的TS评分、大雨以上准确率及暴雨以上准确率较MAPS模式都普遍更高；在对天气形势场的模拟能力方面，模式对850hPa上天气形势场的模拟效果不如500hPa上的模拟效果好，其可能原因是受下垫面的影响所致，并且总的看来，36小时的模拟效果优于48小时的模拟效果。

The kernel of the problems stressed are the two: the link path of saddle point to saddle point on the topological structure is instable, so it will break easily with the changing of main control coefficient, and nonlinear bifurcation of the vortex structure along the vortex axis line.

强调了不稳定拓扑结构中的鞍—鞍连接轨线随主控参数变化而"撕裂"、以及旋涡沿轴线的非线性分叉是非对称形成与多涡系演化的途径。

Fierce wind vortex that can not stand woorimalin 'waterspout' quoted in the concept map, iconic pinwheel shape of the vortex in the middle of a battlefield maepyida.

暴风涡——引入了不能站在风眼的"龙卷风"概念的地图，在战场的中间有标志性的风车形态的涡流。

Despite differences in wing shape and wing loading, both species shifted from a vortex-ring to a continuous-vortex gait at a speed of 7 meters/sec.

尽管有分歧，在机翼形状和翼载荷，无论是物种的转移，从涡环一个连续涡步态在速度7米/秒。

Next the discussion in this study, about an ellipse with an angle of attack and two circular cylinders with different diameters in the flow, the aim of this study is investigated for the ability of the present numerical method by solving the suppression of the vortex shedding flow behind the two-cylinder system which was kind of difficult to reach by a Cartesian grid method. In this study, the suppression of the vortex shedding flow is tested to solve a uniform flow past through two different diameter cylindrical in the flow field with Fractional Step Method and Immersed Boundary Method.The numerical method which we investigated is showed that the results of the problem is appropriable in other literatures.

接著探讨流过具攻角之椭圆柱体流场及流过圆柱抑制涡漩逸出之流场，目的是要研究利用控制圆柱来抑制下游涡流的流场行为，本文采用分步法配合内嵌边界法数值解析一均匀流流经两不同直径的圆柱流场，来测试抑制涡流逸出的问题，根据现有的数值结果发现试验运用了合适的方法且得到令人满意的结果。

An oil supply structure for vortex-type compressor is composed of oil lifter, rotary shaft and its oil channel, and the eccentrical part inserting slot and pin slot on movable vortex disk, and features that said two slots are communicated with each other via through oil hole for decreasing the abrasion between steel pin and pin slot.

通过涡旋式压缩机的供油结构，压缩机运转中通过旋转轴的油路提升喷出的油经过机油通孔向动涡盘的销槽与钢销的销之间供给充分的机油，使动涡盘的销槽与插入在销槽内的钢销的销之间进行顺利的移动，同时降低它们之间的磨损。

The induced effects of vortex tubes and belts in the process of vortex reconnection are important.

强调了诱导作用在涡重联中的重要性。

The longitudinal vortex generator is a new technique of enhanced heat transfer,this paper presents the effects of the longitudinal vortex in horizontal rectangled duct on the heat transfer coefficient and pressure drop.

纵向涡是一种新型的传热强化技术，其传热性能好，安装方便，使用可靠。以数值计算方法分析了在常壁温条件下纵向涡对换热器的传热性能以及流动阻力的影响。

In order to improve the refrigerating efficiency of the micro-vortex-tube, we have proposed a cooling system of a micro-vortex-tube with humidifying at the hot end.

为了提高微型涡流管的制冷效率，提出了涡流管热端加湿制冷系统，通过对热端气体加湿降温，获得低于环境温度的气体，同冷端气体一起制冷。

It has been put forward that there exists single Ball point and double Ball points on the symmetrical connecting-rod curves of equilateral mechanisms.

从鲍尔点的形成原理出发，分析对称连杆曲线上鲍尔点的产生条件，提出等边机构的对称连杆曲线上有单鲍尔点和双鲍尔点。

The factory affiliated to the Group primarily manufactures multiple-purpose pincers, baking kits, knives, scissors, kitchenware, gardening tools and beauty care kits as well as other hardware tools, the annual production value of which reaches US$ 30 million dollars.

集团所属工厂主要生产多用钳、烤具、刀具、剪刀、厨具、花园工具、美容套等五金产品，年生产总值3000万美元，产品价廉物美、选料上乘、质量保证，深受国内外客户的青睐