查询词典 volumetric

The main factors affecting the soil-structure interface behaviors were found experimentally and theoretically, including: 1 the thickness of the interface that is five to six times the average grain size of the soil; 2 the aeolotropy of interface, which is responsible for anisotropic response of the stress-strain response of the interface; 3 two physical states, including crashing and compression of the soil near the structure surface, which govern the stress-strain response of the interface strongly; 4 two shear deformation components due to sliding and constraint of the structure surface relative to the soil respectively, which forms the deformation of the interface; 5 the volumetric strain due to dilatancy, which is found to be composed of a reversible dilatancy component and an irreversible dilatancy component. 4. A unified constitutive model of the interface, based on new elasto-plasticity damage theory, was developed. It was confirmed to be effective for the conditions considering monotonic and cyclic shearing, coupling effect of shear and volumetric strains, evolution of physical state, micro-structure aeolotropy of the soil and the resulting aeolotropy of the interface as well as the three normal boundary conditions stated above. 5. 2D and 3D finite element formulations of the present model were derived and incorporated into the FEM codes. They were applied to the evaluation of practical engineering problems with different typical interfaces between soil and structure. The new model was shown to be reasonable and effective.

确定了粗粒土与结构接触面厚度约为5～6倍的平均粒径，首次揭示了接触面的细观结构异向性以及由此所引起的宏观剪切异向性，发现了在单调和往返剪切荷载作用下土颗粒破碎和剪切压密两种物态变化机制共同支配着接触面力学性质的变化，通过细观分析证实了接触面的变形可分解为一般同时发生的土与结构交界面上的滑移变形以及结构面位移约束范围之内土体本身的剪切变形两部分，观测到接触面受剪时表现出明显的相对法向位移，并可分解为可逆性和不可逆性两个分量；(4)建立了第一个能够统一地描述单调与往返剪切特性、剪应变与体应变耦合特性、细观结构和宏观剪切异向性以及土颗粒破碎等物态变化特性的土与结构接触面弹塑性损伤本构数学模型，并采用多种法向边界条件复杂加载路径的试验成果验证了新模型的合理性和有效性；(5)提出了新模型的二、三维有限元格式并结合实际边值问题进行了应用计算分析，比较了不同接触面本构模型对计算结果的影响，证实了新模型及其有限元格式不仅能够合理地描述土与结构接触面的主要力学特性，还能够较好地反映土体与结构物在接触面处的滑移、脱开等不连续现象。

Volumetric reconstruction has been done with single mode images, then multi-mode images volumetric fusion depend on registration with coronal and arrowy mark of image pipeline in volumetric reconstruction.

图像融合时，先进行单模式的图像容积重建，再依据冠状和矢状显影标志管线进行配准容积融合。

New in version 9.0: Global Illumination using Photon Mapping, Caustics, Volumetric Fire and Area Lights, Volumetric Fog and more...

在新版本9.0 ：全球照明用光子测绘，焦散，体积消防和地区的灯，体积雾及更多。。。

As shown by the result, the biomass and astaxanthin content of oceanic red yeast was reduced due to the presence of β-ionone which inhibited the synthesis of carotenoids. The lethality rate of oceanic red yeast would attained 92.3% if 370 mg/L of the β-ionone concentration was contained in the plate medium. The oceanic red yeast mutated by ethyl methane sulfonate was cultured on plate medium containing 370 mg/L of the β-ionone. 200 mutants were randomly screened, positive mutants with increased the biomass, astaxanthin volumetric yield and astaxanthin specific yield accounted for 18% of the total strain, the mutants with higher biomass, astaxanthin volumetric yield and astaxanthin specific yield higher occupied 22.5%, 45% and 46%, respectively.

实验结果表明，在β-紫罗兰酮存在的情况下，由于类胡萝卜素合成受到抑制，海洋红酵母的生物量和虾青素合成量都减少；当平板培养基中β-紫罗兰酮浓度达到370 mg/L时，海洋红酵母的致死率为92.3%；在这种平板培养基上涂布经甲基磺酸乙酯诱变的海洋红酵母，随机筛选200个菌落，结果表明生物量、虾青素体积产率和细胞产率均有所提高的正突变株占18%，生物量、虾青素体积产率和细胞产率的单项指标有所提高的正突变株分别占22.5%、45%和46%。

According to the stress-strain complete process curve, the total volumetric strains and crack induced 1 volumetric strains is adopted as damage parameters for analyzing the five phases during the crack growth (crack closure , linear elastic, stable crack growth, unstable crack growth and post failure).

通过压缩试验获得的脆性岩石的全应力应变曲线，利用体积变量和裂纹体积变量等损伤变量分析得出裂纹发展的五个阶段即：压密、弹性、微裂纹稳定扩展、裂纹非稳定扩展和峰后失稳等。

The results show that the addition of surfactant shortens induction time and improves formation rate and volumetric proportion, and the volumetric proportion of synthetic hydrate samples can amount to 136~150; the existence of porous medium delays hydrate formation exiguously; the influence of memory effect on gas hydrate formation is notable, the induction time could be shortened by 10~20 times for the experimental system containing residual pentahedral ring structure.

结果表明：表面活性剂的加入缩短了水合物生成诱导时间，提高了生成速度和含气率，合成的水合物样品含气率达到136~150；多孔介质的存在对水合物的生成有较小的延缓；记忆效应对瓦斯水合物生成影响显著，在拥有水合物分解残余五面体环等结构的实验体系中，水合物生成诱导时间缩短10~20倍。

Result］ It could be concluded through analyzing the model that both the mass uncertainties of quinoline phosphomolybdate precipitates and tested samples were from the resolving power and precision of balance and its maximum tolerance in assay certificate; the uncertainty brought in by volumetric flask was from the permissible error of 250 ml volumetric flask, the operation of increasing the volume to scale of volumetric flask while diluting solution and the difference between experimental temperature and the temperature at the time when the volumetric flask was calibrated; the uncertainty brought in by pipette was from the permissible error of itself, the operation of increasing the volume to intake scale while taking solution and the difference between experimental temperature and the temperature at the time when the pipette was calibrated.

结果］磷钼酸喹啉沉淀和试样质量的不确定度均来自天平的分辨力、精确度、鉴定证书上天平的最大允差，容量瓶引入的不确定度来自250 ml容量瓶本身的允许误差、稀释溶液时将体积增加到容量瓶刻度的操作和试验温度与容量瓶校准时温度的差异，吸量管引入的不确定度来自于吸量管本身的允许误差、吸取溶液时将体积增加到吸取刻度时的操作和试验温度与吸量管校准时温度的差异。

The bulk modulus describes volumetric elasticity, or the tendency of an object's volume to deform when under pressure; it is defined as volumetric stress over volumetric strain, and is the inverse of compressibility.

体积模量，描述了测定体积的弹性，或者说一个物料在压力作用下的体积相对于变形的程度；它被定义为体积应应变下的体积应力，且是体积柔量的倒数。

Cool the solution, cautiously dilute with water, transfer to a 200-mL volumetric flask, dilute with water to volume, mix, and filter.

冷却解答，慎重地稀释用水，调动到200ml volumetric烧瓶，稀释用水对容量、混合和过滤器。

In various embodiments, improved mechanisms for controlling texture sampling are provided that enable 3-D accelerator hardware to greatly increase the level of realism in rendering, including improved mechanisms for (1) motion blur;(2) generating anisotropic surface reflections (3) generating surface self-shadowing (4) ray-cast volumetric sampling (4) self-shadowed volumetric rendering and (5) self-shadowed volumetric ray-casting.

在各个实施例中，提供了用于控制纹理采样的改进的机制，它们能使3-D加速器硬件大大地提高呈现时的逼真度，包括针对下列各项的改进的机制：(1)运动模糊；(2)生成各向异性表面反射；(3)生成表面自投阴影；(4)光线投射容量采样；(4)自投阴影容量呈现和(5)自投阴影容量光线投射。

The absorption and distribution of chromium were studied in ryeusing nutrient culture technique and pot experiment.

采用不同浓度K2CrO4(0，0.4，0.8和1.2 mmol/L)的Hoagland营养液处理黑麦幼苗，测定铬在黑麦体内的亚细胞分布、铬化学形态及不同部位的积累。

By analyzing theory foundation of mathematical morphology in the digital image processing, researching morphology arithmetic of the binary Image, discussing two basic forms for the least structure element: dilation and erosion.

通过分析数学形态学在图像中的理论基础，研究二值图像的形态分析算法，探讨最小结构元素的两种基本形态：膨胀和腐蚀；分析了数学形态学复杂算法的基本原理，把数学形态学的部分并行处理理念引入到家实际应用中。