查询词典 volume density

Engine cylinder liner of the general process of measurement are: cylinder liner according to the nominal size measuring selection, that is, sub-thousand-foot-cylinder form and quantity (including the volume of cylinder rod inserted table); installation and adjustment of measuring, that is first to adjust micrometer cylinder liner the nominal size, and then loaded card good indicator of the volume of cylinder form measuring bar and the bar card inserted in the anvil micrometer measuring bar between the seat and adjust the volume of cylinder form of extended length of rod inserted, when the dial indicator of the 1.5-2.0 cells have small hands around the amount of pre-press under lock-lock female plug, and a large dial indicator to zero adjust

发动机气缸套测量的一般过程是：根据气缸套的公称尺寸选择量具，即千分尺和量缸表；安装和调整量具，即先将千分尺调整到气缸套的公称尺寸，再将卡装好百分表的量缸表的测杆和插杆卡在千分尺的砧座和测杆之间，调整量缸表插杆的伸出长度，当百分表的小表针有1.5-2.0格左右的预压量时锁紧插杆锁母，并将百分表的大表盘调整到零

The first direct measurement with micrometer piston skirt and the outside diameter Do micrometer stop screw to the locking plate position, and then dial indicator card installed and well well inserted under the initial installation of the amount of cards, directly into the cylinder corresponding cylinder kit, adjust the volume of the cylinder rod out in table inserted length, so that small hands dial indicator cell has about 1 volume of pre-press and lock locking rod inserted mother, at the same time, large dial indicator dial to adjust zero, the last cylinder to adjust the volume of good form under test card inserted rods and do at Anvil micrometer and measured the rod between the big hands dial indicator at this time than the "zero" high value is the piston and cylinder liner with the space.

3先直接用千分尺测量活塞裙部的外径并将干分尺止动螺钉扳转到锁紧位置，再将卡装好百分表和初步安装好插杆的量缸表直接卡入对应气缸套内，调整量缸表插杆的伸出长度，使百分表的小表针有1格左右的预压量并锁紧插杆锁母，同时将百分表的大表盘调整到零，最后将调整好的量缸表的测杆和插杆卡在干分尺的砧座和测杆之间，此时百分表大表针比&零&高的数值即为活塞和气缸套的配合间隙。

The first direct measurement with micrometer diameter piston skirt, and then dial indicator card installed and the initial installation of the amount of good cylinder rod inserted card table micrometer mounted on the anvil between the seat and the measuring bar, adjust the volume of cylinder table Interpolation of the extended length of rod, when the dial indicator has small hands around 1.5-2 cell volume preloading lock locking rod inserted mother, and a large dial indicator to zero adjust the final stretch to the volume of cylinder table into the Cylinder Sleeve, large dial indicator hands than "zero" low value (considering the small hands reading) is the piston and cylinder liner with the space.

2先直接用千分尺测量活塞裙部的外径，然后将卡装好百分表和初步安装好插杆的量缸表卡装在千分尺的砧座和测杆之间，调整量缸表插杆的伸出长度，当百分表的小表针有1.5-2格左右的预压量时锁紧插杆锁母，并将百分表的大表盘调整到零，最后将量缸表伸入气缸套内，百分表大表针比&零&低的数值即为活塞和气缸套的配合间隙。

Path analysis of nine traits, which were highly correlated with tree volume, showed that the direct contribution of DBH and height on the variations of tree volume took up about 63% of the total variations. On the other hand, those traits, such as tree crown and wall/lumina, affected the volume strongly by indirect way of the genetic correlation with DBH and height.

通过对与材积性状紧密相关的胸径等9个性状的通径分析发现，胸径和树高两个性状对单木材积的直接作用占材积总变异的63％，其余性状的直接控制作用很小；冠幅、壁腔比等性状通过胸径对单木材积具有很大的间接遗传控制作用，这种控制是通过与胸径、树高的遗传相关实现的。

Weigh's addition minishes the loss of net's volume in pure current, but makes no differnce in the pure wave condition. After installed of sinking ring or lower ring, the loss of net's volume is decreased. The loss of net volume is more in the current combined with wave condition than in the pure current condition.

在纯流条件下，增大配重均有利于减小网箱的体积损失；而在纯波条件下，配重的增加对于改善网衣的变形没有实质性的意义；设置了底圈或沉降圈后，均能在一定程度上减小网衣的体积损失；波流组合条件下网衣的体积损失要明显大于纯流条件下的体积损失。

The different points of views, transverse section, plane and volume changes are considered. The results show that the evolution of the Xinqiao Channel has experienced three stages: in 1861~1926 ,the Xinqiao Channel area had been eroded at first and then silted; the Xinqiao Channel is formed during 1926~1958 with the channel experiencing persistence erosion; from 1958 to 2002, the total volume of the Xinqiao Channel keeps stable with the volume of 5.02×108m^3. The pattern of 10m contour has shaped to a certainty in 1926 and 5m contour of the upper and lower parts of Biandansha has been joined. The change of sections of the Xinqiao Channel reflects its thalweg movement to the North Bank 1.1~2.8 km, its shape changes from "U" shape to "V" shape and its depth has been deepened.

计算结果显示在所研究的区域内自1861年以来新桥水道冲淤过程明显被分为三个阶段：1861~1926年的66a间新桥水道区域经过一段时间的冲刷后又重新产生淤积，总容积变化不大；1926~1958年的33a间新桥水道在不断的冲刷中总容积由2.603亿立方公尺增长到5.076亿立方公尺；1958年至今的45a时间里水道容积基本保持在平均5.02亿立方公尺。1926年新桥水道10m等深线已经形成一定的格局，1947年5m等深线向上延伸，扁担沙已经不再与崇明岛相连；1958年上下扁担沙的5m等深线基本连成一体，可以认为此时新桥水道已经形成。

Bellows Gate Valves However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。

However, in large differential pressure operating conditions, evaporation pressure has eased, the evaporator load requirements of the fluid volume decreased, but the actual situation the contrary, in the suction superheat unchanged, due to evaporation pressure has eased, the evaporator outlet pressure be reduced accordingly, pressure changes above and below the diaphragm, causing the main valve opening increases for increased fluid; but in a small pressure operating conditions, evaporation pressure rise, evaporator load demand for fluid volume increased, but the reality is that in the suction gas superheat unchanged, due to evaporation pressure rise, a corresponding increase in the evaporator outlet pressure, pressure difference above and below the diaphragm smaller, so that the main valve opening decreased for the reduction of liquid volume; in variable load is all about.

但在大压差工况下，蒸发压力降低，蒸发器负荷需求的液量减少，但实际情况相反，在吸气过热度不变的情况下，由于蒸发压力降低，蒸发器出口压力相应降低，膜片上下的压差变大，使主阀开度增大，供液量增加；但在小压差工况下，蒸发压力上升，蒸发器负荷需求的液量增多，但实际情况是在吸气过热度不变的情况下，由于蒸发压力上升，蒸发器出口压力相应提高，膜片上下的压差变小，使主阀开度减小，供液量减少；在变负荷下亦如此。因此热力膨胀阀在变工况下供液量的调节方面需进一步改进。

Summary: Regard guava as raw materials, adopt the organic solvent to extract the law, pass the single factor experiment and orthogonal experiment, to influence many phenol draw abstraction pharmaceutical kind of quantity, draw pharmaceutical volume mark, draw time, draw temperature factor go on the discussion compared with material liquid,etc., the ones that confirm much phenol of guava draw the craft parameter bestly: Volume mark 70% ethanol according to material 1:10 volume ratio of liquid, 70 ℃lay reflux draw 40min in temperature, many abstraction amount of phenol can reach 62.35mg/g be thing.

问题补充：不好意思，我修改了一下摘要，正文应该是：以番石榴为原料，采用有机溶剂萃取法，通过单因素实验和正交实验，对影响多酚提取量的提取剂种类、提取剂体积分数、提取时间、提取温度和料液比等因素进行探讨，确定番石榴多酚的最佳提取工艺参数为：体积分数为70%的乙醇按1∶10的料液比，在温度70℃下回流提取40min，多酚的提取量可达到62.35mg/g干物。

Then,they are presented,to satisfy the demands of forestry development in new century,that the volume estimation method by using one-way volume table should be improved,and that some important forestry tables such as volume table and biomass table should be revised or supplemented.

从分析我国森林资源连续清查中的材积估计问题入手，提出为满足新世纪林业发展的需要，必须对目前用一元材积表估计材积的方法加以改进，并进一步补充完善材积表和生物量表等基础林业数表。

It is suggested that TDS can be used as a new method for the analysis of pedogenesis and climatic change.

总之，热处理过程中磁化率的变化能非常灵敏地反映磁性矿物的转化情况，而且，这种转化往往与样品所经历的土壤化作用强度密切相关，因此，TDS可做为分析成土作用强度和古气候变化的一种新方法。

Therefore, in this chapter, I will research into the conflict and contradiction of the paternity. Also, in this novel, the father's behavior of "He who loves well chastises well." is quite suspicious, one of the reasons is that the father thought his son belonged to him. And then, this thesis quoted Lacan's theory to touch upon that someone who has accepted the concept of patriarchal society, he will be influenced for his whole life. That also reveals that human being has no choice sometimes in this society.

因此本章会先就父子关系的冲突与矛盾做深入的探讨，小说中的父亲似有对儿子爱之深责之切的行为，其原因可能在於父亲将儿子视为所有物所致；其次，论文将引用拉冈相关理论，讨论在父权社会中，不论身分为何，只要是已受父权社会观念根深蒂固影响的人物，终生都将受其所苦，此也揭示出人生存於社会上的无奈。