查询词典 voltage

Molded Case Circuit Breaker Shunt Trip coil and often took part in undervoltage trip coil, Shunt trip coil is the voltage at 70%~ 110% off ...70%~ 110% reliable means of shunt voltage range of movement, 70% minimum, and more than 110% of the shunt itself may be burned ...

塑壳断路器往往有分励脱扣线圈和欠压脱扣线圈，分励脱扣线圈是电压在70%~110%时脱。。。 70%~110%指的分励可靠动作的电压范围，70%为最小值，而超过110%分励本身可能会烧坏。。。。

At first the current sampling values pass through virtual digital CVTs. And then the voltage and current sampling values are processed by a low pass filter. According to the instantaneous value of transmission line voltage, the current instantaneous values of shunt reactors and P equivalent circuit capacitance can be calculated. After removing these two kinds of current, sampling value differential protection based on all components and fault component can be applied.

由线路电压瞬时值分别实时计算出流入并联电抗器和流入线路Π型等值电路两侧电容的电流瞬时值，再从线路每侧电流除去这两部分电流，用得到的新电流瞬时值作常规采样值差动和故障分量采样值差动保护计算。

If no lightning current arresters are installed at the service entrance of the building (for example in the low-voltage consumer's installation of the low-voltage main distribution), the operator must be informed that these must be added.

如果在建筑的引入线没有安装避雷器的话，（如在低压控制中心的低压电器）必须告诉操作员，一定要把避雷器加上。

Then, flaw of existing full-digital voltage commutation method is pointed out after the change of the critical area which switch sequence will encounter corresponding to the variety of displacement angle at the input-side of converter has been explicated, then several rules have been presented and used to instruct detailed voltage commutati.

通过分析输入侧功率角变化对矩阵变换器全数字电压换流技术的影响，指出现有全数字化电压换流方案的缺陷，并提出新的改进原则，接着给出详细的数字化电压换流策略实现方法，分析新方法对变换器换流次数的影响。

Then, flaw of existing full-digital voltage commutation method is pointed out after the change of the critical area which switch sequence will encounter corresponding to the variety of displacement angle at the input-side of converter has been explicated, then several rules have been presented and used to instruct detailed voltage commutation method built. Increment of switches' commutation-times, thanks to the new method employed, is analyzed in succession.

通过分析输入侧功率角变化对矩阵变换器全数字电压换流技术的影响，指出现有全数字化电压换流方案的缺陷，并提出新的改进原则，接着给出详细的数字化电压换流策略实现方法，分析新方法对变换器换流次数的影响。

This thesis proposed the design and implementation of an ASIC for the motor control with DTC technology. Note that this ASIC is implemented by cell-based Design style with Verilog language.The basic principle of the Direct Torque Control is to select the switch sequence of the inverter. Those switches will control the magnetism and torque of the stator, to induce a fast response of the induction motor. Furthermore, the d-q axle's static coordinate, which is transferred from both the three-phase current and voltage, is used to compute the stator's magnetism and torque. By comparing with original values, those magnetism and torque will be calculated and set to new data. Then the switching table and the hysteresis controller are decided with the new data to generate a voltage vector and to control the stator magnetism and torque.

直接转矩控制的基本原理为经由侦测马达定子磁通与转子转速，来适当的选择变频器功率电晶体的切换状态，以获得快速且不易受外在环境影响的马达控制响应；首先，根据量测三相电流与利用变频器的切换状态取得马达的三相电压，将其转换至d-q轴静止座标，然后藉此估测马达的磁通量与转矩量，再分别与侦测的定子磁通量和转矩量比较后，得到定子磁通量与转矩量比较的结果，再利用DTC电压向量切换表(DTC Voltage Vector Switching table)，依定子磁通与转矩的比较值及马达所在的角度位置，来选择一个适当的电压向量，进而依切换顺序来激发功率电晶体，达到控制感应马达的目的。

This gives self-heating PTC the advantage of dual of multi-voltage usage in different countries of different voltage.

根据不同用途的需要，调整工艺和配方，可以制造出不同电阻范围，不同表面温度的PTC元件。

B Inform the operator to set the voltage selector switch to the voltage to which the product will be connected.

&b 告知使用者接电压选择开关设定在产品将要连接的电压上，见12.2.3。&

Disadvantage of this device is high voltage, in order to reduce the operating voltage to achieve the purpose of actual use, screening of high dielectric constant material as the dielectric layer material is topic of future research.

缺点是工作电压偏高，需要进一步筛选出介电系数高的物质来作为介电绝缘层材料，以便降低工作电压，达到实际可以使用的目的。

It measures cyclical signal such as frequency ,cycle ,voltage average value or voltage tip-to-tip value of sinusoidal wave, triangular wave, ladder wave, saw-tooth wave, pulse signal and oblique wave which frequency ranges from 64Hz to 1MHz.

本设计为一个多功能数字式测量仪，测量频率范围为64Hz 1Mz的周期性确定信号（如正弦波、三角波、阶梯波、锯齿波、脉冲信号、斜波等）的频率、周期、电压平均值、电压峰峰值。

You can do some assertiveness training.

你可以进行一些自信训练。

We were well on the path to making a rear-wheel-drive global platform," says Mays."

我们正致力于建立一个后轮驱动的平台，"Mays这样说道。"