查询词典 voltage

Electrostatic relays can be not compatible with the normal voltage (5V) because it needs high driving voltage. Thermomagnetic ones have the low response speed and are affected by the ambient temperature.

静电型由于需要较高的驱动电压，不易与标准电压源（5V）相兼容；热磁型响应速度低，受环境影响较大；微机械电磁继电器在结构原理上与传统机械继电器相似，更接近于实际应用。

Usually a high voltage is carried by the overhead-wire system, and the third rail has current at a much lower voltage.

通常高压电被高架线系统输送，第三根铁轨里的电压则是很低的，这是因为如果一个站在线路上的人就可能碰到电轨，那是很危险的，但是他不可能碰到高架线。

The output voltage and the detector threshold voltage can be set individually for each IC by laser trimming.

输出电压和阈值电压检测器可以设置为每个单独的激光微调集成电路。

By rational configuration of the low voltage solid circuits and hydrogen thyratron circuits,long precise delay and low jitter of high voltage output can be obtained.

采取低压固体电路与大小氢闸管电路的合理配置，较好地解决了精密长延迟和高压脉冲输出时低延迟时间晃动的难点。

CPU 8031 is used as the central controller and VE4137A quick hydrogen thyratron with high voltage,large current and low jitter is used as the high voltage pulse generator,and MOSFET is used as the driver.

设计高压脉冲形成级是本机的重点，关键是选择能满足本机各项技术指标要求的高电压、大电流、快速开关管。

A time-shared control circuit points to multiplexer, applies the control signal and switches and repeats to output the input signal by the predetermined cycle order. A comparator compares the voltages of the output signal from the multiplexer and the reference voltage and outputs a dimorphic signal representing the comparative result. A time-share controlled circuit applies the control signals, controls the action of the multiplexer and the latch circuit to lead the respective voltage comparative result to be maintained in the latch circuits.

分时控制电路(5)对多路调制器(4)，使用控制信号(Sc1)，以所定周期顺序切换反复输出所输入的信号(St1)-(St4)，比较器(3)对从多路调制器(4)输出的信号的电压和基准电压进行电压比较，输出表示该比较结果的二态信号，分时控制电路(5)使用控制信号(Sc1)及(Sc2)，控制多路调制器(4)及闩锁电路(LT1)-(LT4)的动作，使得信号(St1)-(St4)的各电压比较结果分别保持在闩锁电路(LT1)-(LT4)中。

Based on physical characteristics, existing stochastic estimation methods of equipment sensitivity to voltage sag use subjective probability models to express the probability distribution of voltage tolerance curve of equipment in the uncertain region. But the parameter estimation needs vast sample data. These methods may result in man-made errors.

现有负荷敏感度随机估计法以电压暂降的物理特征为基础，用主观概率模型描述负荷电压耐受曲线(voltage tolerance curve，VTC)的随机分布规律，所需样本量大，在实际中难以实现且可能引入主观误差。

C Supports both Firmware Hub and LPC Memory Read and Write Cycles Auto-detection of FWH and LPC Memory Cycles C Can Be Used as FWH for Intel 8xx, E7xxx, and E8xxx Series Chipsets C Can Be Used as LPC Flash for Non-Intel Chipsets Flexible, Optimized Sectoring for BIOS Applications C 16-Kbyte Top Boot Sector, Two 8-Kbyte Sectors, One 32-Kbyte Sector, Three 64-Kbyte Sectors C Or Memory Array Can Be Divided Into Four Uniform 64-Kbyte Sectors for Erasing Two Configurable Interfaces C FWH/LPC Interface for In-System Operation C Address/Address Multiplexed Interface for Programming during Manufacturing FWH/LPC Interface C Operates with the 33 MHz PCI Bus Clock C 5-signal Communication Interface Supporting Byte Reads and Writes C Two Hardware Write Protect Pins: TBL for Top Boot Sector and WP for All Other Sectors C Five General-purpose Input Pins for System Design Flexibility C Identification Pins for Multiple Device Selection C Sector Locking Registers for Individual Sector Read and Write Protection A/A Mux Interface C 11-pin Multiplexed Address and 8-pin Data Interface C Facilitates Fast In-System or Out-of-System Programming Single Voltage Operation C 3.0V to 3.6V Supply Voltage for Read and Write Operations Industry-Standard Package Options C 32-lead PLCC C 40-lead TSOP

0第0页，本页显示记录0-0，共0条记录分0页显示C支持两种固件中心和LPC内存读取和写入周期自动的FWH和LPC的记忆圈C检测可以用于英特尔8xx系列，E7xxx，E8xxx系列芯片组和C可以用作FWH与至于非英特尔芯片组的BIOS应用柔性优化扇区开放16字节热门引导扇区，两个8 - Kbyte的，一个32字节部门，3个64 - Kbyte的C或存储阵列，线性预测编码闪光可分为四个统一为两个可配置的接口擦除的FWH / LPC接口为64 - Kbyte的行业，系统运行C地址/地址多路复用在制造过程中用于编程接口的FWH /线性预测编码界面C与33 MHz的PCI总线时钟 5信号通信接口进行操作，支持字节读取和写入引导扇区的顶部和WP C两硬件写保护引脚：任务型为所有其他部门 5个通用输入的系统设计的灵活性识别的多种设备选型部门登记销锁定为个别部门读取和写保护的A /阿复用界面C 11引脚复用引脚地址和8引脚的数据界面C促进快速系统内或外的系统编程的单电压3.0V至3.6V的操作供应的读取和写入操作业界标准的封装选项电压 32 -引脚PLCC 40引脚的TSOP

The topological structure of a new type of static synchronous compensator, which consists of traditional 12-pulse converter and a cascaded H-bridge, is presented. The purpose of designing such a topological structure, which integrates the concepts of multi-level, soft-switching and re-injection, is to reduce the voltage harmonic content at AC side and to solve dynamic voltage balance among the switches connected in series.

介绍一种新型H桥级联静止同步补偿器(static synchronous compensator，STATCOM)的拓扑结构，它由传统的12脉冲变换器和一个H桥链构成，结合了多电平、软开关和注入技术，降低了交流侧电压谐波含量，解决了串联开关动态电压平衡的问题。

Note 9: Transconductance and voltage gain refer to the internal amplifier exclusive of the voltage divider.

注9：跨导和电压增益放大器的内部参考电压分压器的排他性。

The work of this paper is as follows: 1. Looking back the progressing history of the linear motor, introducing the features of the elevator driven by linear induction motor, radicating the topic of this paper "the digital frequency variable control of the elevator bi-side direct driven by linear induction motor". The research of this paper covers the conventional VVVF control, space vector based VVVF control, vector control and DTC.

本文主要开展了以下几个方面的工作： 1 回顾了直线电机发展历史，电机的驱动技术演变，特别是针对直线电机的驱动，简要介绍了直线感应电机驱动电梯的优点和不同结构类型，对传统的v／f控制，基于空间矢量法的v／f控制，矢量控制，和基于电压空间矢量的直接转矩控制进行了比较，确立了本课题的研究主题：直线感应电机双边直推式驱动电梯的全数字变频控制。

The article combines with the treatment of a superficial civil air defense work to introduce how the grouting method to improve the performance of the backfill soil.

文章从治理漂浮人防工事的角度提出了注浆技术在改善回填土性质方面的应用，并详细阐述了注浆技术的施工流程。