查询词典 voltage barrier

The instantaneous voltage inner loop is used to control output voltage waveform to track a sinusoidal waveform.

在逆变器控制策略上采用电压瞬时值内环和平均值外环的双环控制方法。并用TMS320LF2407实现数字控制。

The instantaneous voltage PID control inverter has advantage on circuit and cost, compared with voltage current dual-loop control inverter.

逆变器瞬时电压PID控制与电压电流双环控制相比，在电路结构、成本等方面更具优越性。

We design a fast calculating amplitude method: obtain two instantaneous voltages at first, after that calculate the current voltage virtual value once we get another instantaneous voltage.

我们设计了一种快速计算幅值的方法，只需先采得两个电压瞬时值，之后每采样一个电压瞬时值即可求得当前的电压幅值。

Simulation and experimental results indicate that for the SPWM inverter based on instantaneous output voltage feedback control,the fundamental open circuit output voltage incr...

仿真和实验结果表明，对于采用瞬时输出电压反馈控制技术的SPWM逆变器，其输出电压在空载时随着死区时间的增加而增加，负载电流超过临界电流后其输出电压随死区时间增加而下降；其阻性负载时的外特性曲线是一条先下降后上升的曲线。

Based on the instantaneous output voltage and filter inductor current double closed loop feedback control and through sharing the same voltage regulator, the current sharing is achieved.

基于主从控制的逆变器并联系统由3个采用输出电压瞬时值和滤波电感电流瞬时值双闭环反馈控制的逆变器模块构成，通过共用电压调节器实现负载均分。

All voltage sources have internal resistance, so all voltage sources develop Johnson noise.

所有的电压源都具有内阻，所以所有的电压源都会产生约翰逊噪声。

This reduction is caused by the internal resistance, which creates an additional voltage drop called the voltage burden.

这种电流的降低是由安培计的内阻引起的，此内阻产生了一个附加的电压降，称为输入端压降。

The comparator 14 tests whether the voltage is greater or less than the voltage occurring at the inverting input and depending on the results of the comparison the bit corresponding to capacitor Cm is either kept or discarded.

比较器14测试是否电容器Cm的电压大于或者小于在反相输入处出现的电压，并且根据比较结果，保持或者丢弃对应于电容器Cm的位。

S1 is then changed to position 1. The voltage stored on C1 is inserted between the output and inverting input of the amplifier and the output of the amplifier changes by VIN to maintain the amplifier input at the input offset voltage. The output then changes from (VOS + IbiasR2) to (VIN + IbiasR2) as S1 is changed from position 2 to position 1. Amplifier bias current is supplied through R2 from the output of the amplifier or from C2 when S1 is in position 2 and position 1 respectively. R3 serves to reduce the offset at the amplifier output if the amplifier must have maximum linear range or if it is desired to DC couple the amplifier.

接着 S1 拨到位置 1，使 C1 的电压加在放大器的输出端和反相输入端之间，(由于电容端电压不能突变，所以)输出端的电压将产生大小等于 VIN 的变化，使放大器输入端维持输入失调电压，即当开关 S1 从位置 2 拨到位置 1 时，输出端电压将从(VOS + IbiasR2)变为(VIN + IbiasR2)。S1 处于位置 2 时，放大器的偏置电流是由输出端经电阻 R2 提供的，当 S1 转向位置 1 时则由 C2 提供。R3 的作用是降低输出失调电压，如果要求放大器具有最大的线性范围，或者采用直流耦合，就应该使用该电容。

Smoke Detection Circuit C The smoke comparator compares the ionization chamber voltage to a voltage derived from a resistor divider across VDD.

烟雾检测电路C的烟雾比较器比较电离室电压从整个VDD的电阻分压器产生一个电压。

Listen,point and check your answers.

听，指出并且检查你的答案。

Warming needle is one of effective treatment methods for knee arthralgia aggravated by cold,and it is simple,safety,so it should be developed in clinical acupuncture and moxibustion extensively.

但以本院科针灸门诊在2005年1月—2006年6月期间共收治膝痛患者100余例，经过临床的诊断后，其中施以温针治疗的48例，疗效显著，报道如下。1临床资料本组病例48