查询词典 view plane

These antennas can cover GSM900/DCS/PCS/UMTS operation. In the chapter 2, the antenna is designed based on the concept of monopole antenna. Furthermore, the antenna structure have two radiant paths and coupled each other at tail end to do impedance matching. In addition, to raise distance between radiation plane and ground will avoid capacitative effect effectually. In the chapter 3, the antenna is designed based on the concept of planar inverted-F antenna. Furthermore, that the antenna structure have two radiant paths and coupled each other at tail end to do impedance matching is similar to chapter 2. But there is a difference in them. We can choose the short position to change input impedance at this structure. In the chapter 4, the antenna is designed based on the concept of planar inverted-F antenna which takes coupled-fed. It will produce the first mode and high-order mode near the frequency, 900MHz. The feature of this type is to reduce the volume effectually. This antenna can not only cover GSM900/DCS/PCS/UMTS operation but maintain good radiation efficiency. Finally, we will compare three antennas, and develop procedure with industrial view, and propose the prospect of the GSM/GPRS antenna in PND, as a conclusion.

在第二章中，我们使用单极天线设计概念，使用双路径架构并於末端耦合来对天线阻抗做匹配，产生涵盖GSM900/DCS/PCS/UMTS四频操作频带，并提高与接地面的辐射高度，以避免电容效应，使天线具有良好的辐射特性；在第三章中，使用倒F形天线设计概念，使用双路径架构於末端耦合，并於辐射臂上采取适当接地点电感效应作输入阻抗匹配，达成涵盖GSM900/DCS/PCS/UMTS系统的四个操作频带；在第四章中，采用倒F形架构并使用耦合馈入方式，使得长辐射金属臂在低频900 MHz附近产生共振，产生低频基频模态及高阶模态，以达成宽频及频宽涵盖GSM900/DCS/PCS/UMTS频带操作，并有效缩减使用体积；最后，分别比较此三种架构的优缺点，再加以业界角度来思考，研发产品天线的流程及思考方向，以及天线应用於可携式导航装置中未来的展望作为本论文的总结。

By the numerical analysis of the ultimate bearing capacity of two- and three-dimensional footing under combined loading mode, the results show that the effect of alteration of underground water lever on bearing capacity of three-dimensional foundation is more than on that of two-dimensional foundation, the effect of soil gravity on bearing capacity of three-dimensional foundation is more than that of two-dimensional foundation. At the same time, the numerical calculation process of ABAQUS indicates that whether the geostatic stress is balanced or not has great effect on the numerical convergence. In view of the effect extent of dilation angle of soil on the ultimate bearing capacity and the failure pattern of foundation, the condition of two-dimensional plane strain is higher than that of the three-dimensional foundation.

复合加载模式下，通过对三维矩形基础和二维条形基础进行数值分析，结果表明：黏性土地基中地下水位的变化，对三维矩形基础极限承载力的影响程度高于对二维条形基础的影响；在求解地基极限承载力的过程中，土体重度对三维矩形基础的影响明显高于对二维条形基础的影响，同时ABAQUS数值计算过程表明，地基土体地应力能否合理平衡，对数值求解过程中是否收敛有很大的影响；就土体剪胀角对地基极限承载力的影响程度而言，二维平面应变情况下土体剪胀角对极限承载力的影响比三维情况下的影响更明显，即土体剪胀角对条形基础极限承载力的影响高于三维矩形基础。

Then the 3D data from each stereo visionmeasuring unit can be translated into a unique frame of refrence.2. Designed control points of plane form with homocentric arcs and ball markers.By the moment invariants and least-squared procedure of ellipse fit, the markers wererecognized and located automatically with high precision.3. Studied the technology of camera self-calibration, according to the camerawith wide field of view, set up the distorted projection camera model.

通过被测物表面的控制点，将局部测量数据统一到全局坐标系中。2、设计了平面型多重圆弧编码控制点及立体控制点，结合边缘矩的不变性和椭圆最小二乘拟合技术实现控制点的精确定位。3、研究了相机的自标定技术，针对大视场相机的特点，建立了非线性相机成像模型，采用优化算法完成了相机的内、外部参数标定。

The strategic analysis is introduced into coal enterprise logistics cost precontrol and it set goals for the logistics cost at last from the strategic plane of the coal enterprise competition demand,through logistics strategic cost agent analysis and logistics strategic location analysis to determine logistics service level under different logistics strategies in coal enterprise,and it provides premise and foundation for the logistics cost control from the view of value creating.

煤炭企业物流成本事前控制引入战略分析法，从煤炭企业竞争需求的战略层面出发，通过物流战略性成本动因分析，物流战略定位分析，确定煤炭企业不同物流战略下的物流服务水平，可以最终为确定物流成本目标，为从价值创造的角度进行物流成本控制提供前提或基础。

Therefore, I restack many time points up on a plane of time axis and view "time" pantoscopicly to pursue the face fading in a time flow.

於是，我将多个时间点，再次重新堆叠於同一个时间轴的平面，将时间用广角的意识去观看，追求那个已模糊在时间流动中面容。

In the sagittal plane, fetal positioning is the most common cause of suboptimal visualization of the true midline view.

在矢状面，胎儿位置不佳是无法获得满意的正中矢状切面图象的常见原因。

The "daVinci representation"(right panel of Figure 6) is a comprehensive visual representation of the scoliotic spine that illustrates the orientation of the planes of maximum curvature of the 3 spine segments in the transverse view. The center of the circular plot is the point where the central hip vertical axis (CHVA, CHVA is a true vertical bisecting the bi-femoral head axis, often considered to represent the physiological center of balance of the spine-pelvic unit) intersects the transverse plane and every arrow radiating from the center represents a spine segment (PT, MT, and TL/L).

圆的圆心是位于髋中心的Z轴与横断面相交点(CHVA，CHVA是双侧股骨头连线重点的垂线，通常作为脊柱-骨盆单元生理平衡的中点)及每个箭头发自表示脊柱节段的中心。

With the plane on its final approach to Owen Roberts Airport a sudden sea of craning heads erupted, trying to take in everything visible through the small windows and, though Id seen it a million times, I still couldnt resist contorting my body from the aisle seat to catch the view.

当飞机快要到达欧文·罗伯茨国际机场时很多人都突然抬起了头，想通过狭小的飞机窗户将视线范围内的美景收纳眼中，尽管已经见过无数次了，我还是忍不住将身体从走廊座位上扭转过来欣赏这醉人的风景。

The camera calibration method is based on the 2D plane target\'s camera calibration method that is proposed by Zhang Zheng-you et al. Intrinsic and extrinsic parameters of fixed-focus camera are obtained and the precision and the error analysis of Camera calibration are done. The multi-sensor vision system errors are obtained. The error average value is 3.39 mm in X lateral, 0.43 mm in Y lateral, and 1.52 mm in Z laterals. The precision might satisfy the multi-sensor vision system\'s localization request.(3) The goal position and intensity have difference between the visible light image and the near-infrared image because of their image formation mechanism, resolution and field of view differences.

2建立了基于2D圆控制点的摄像机标定试验系统，对多源传感器视觉系统的摄像机，采用张正友等人提出的基于2D平面靶标摄像机标定方法进行了标定试验，得到了多源传感器视觉系统的摄像机内外参数，并对标定结果进行了精度和误差分析，得出视觉系统在X方向误差均值为3.39 mm，Y方向误差均值为0.43 mm，Z方向误差均值为1.52 mm，可以满足多源传感器视觉系统的定位要求。

However, from the view of the structure and shape of the Orbal oxidation ditch, the round or ellipse tri-ditch type may be difficult to plane layout for the engineering with narrow land locations; the independent sedimentation tank occupies relatively large area of land; central island counts some areas which enlarges inefficient land demand; and the backflow of sludge and nitrified water from the sedimentation tank relies on dynamic system, which increase the cost of construction and operation.

但就奥贝尔氧化沟的工艺构型来看，三沟道的圆形或椭圆形沟型对于狭长的工程选址地来说，平面布置相对困难；而且奥贝尔氧化沟需要独立的二沉池，占地较大；中心岛消耗一定的面积，增加了无效占地；另外，二沉池的污泥回流依靠动力回流，增加了基建和运行费用。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。