查询词典 vertiginous current

Use the Rogowski coil as the sensor and transmit the signal and energy with the optic fibre, analyse the principle of the measurement of harmonic current in HVDC system and the factors of its measurement of influence by opticelectricity and computer technology. The Rogowski coil is used to measure the harmonic current in HVDC system. It doesnot affect by direct current and has good frequency characteristics.

本文在全面分析高压直流谐波电流测量方法的基础上，确定以空心线圈为传感器，以光纤传输信号和能量，结合光电技术、微计算机技术，系统地分析了谐波电流测量系统的工作原理及影响其测量的多种因素，提出了解决问题的具体方法和措施。

AlN MSM devices were fabricated on AlN epitaxial thin film deposited on GaN/Sapphire substrates using helicon sputtering system at the low temperature of 300°C. The device characteristic was found to be improved by in situ metallization of Al electrodes. The extremely low dark current (1.39pA at 20V), the ideal factor (1.0125) and the Schottky barrier height (0.916eV) are superior compared to those of AlN MSM in the literature. When the device was illuminated by the 150W D2 lamp, the ratio of the induced photocurrent to dark current is more than 2 orders of magnitude. The illumination effect also shows the linear relationship between the radiation power and the photo current for the MSM devices, indicating the potential applicability for deep UV sensors.

氮化铝金属-半导体-金属光侦测器则是用In situ metallization制程，利用低温回旋溅镀法在氮化镓/蓝宝石基板上沉积之氮化铝，再直接溅镀金属铝作为指叉电极，比较目前文献制作出来的氮化铝MSM元件，可得到很好的元件金半接面之理想因子1.0125，算出萧特基能障高度为0.916eV，并有很低的暗电流为1.39 pA，提升了元件的特性，使用150 W氘灯入射，光暗电流差距可到两个order，且元件之光电流与入射光功率呈线性，显示所制作之氮化铝MSM元件，很适合针对深紫外光波段侦测。

Not only the transmission line current but also aerial current is considered in the calculation of induced current.

在计算外皮感应电流时，既考虑了传输线模式电流，也考虑了天线电流。

On the basis of the analysis and comparison of some sensors, Eddy Current Sensor is selected, and its equivalent circuit, strength and depth of the eddy current, radial distribution of the current, axile intensity of the magnetic inductorium are all analyzed. The processing circuit of sensors signal is designed. Because of coupling problem of the sensors, differential measurement of sensor is applied.

在分析比较各种传感器特性的基础上，选择了电涡流传感器作为转子位移的检测元件；分析了电涡流传感器的等效电路、涡流强度和深度、涡流的径向分布、线圈轴上的磁感应强度；设计了传感器的信号处理电路；对于传感器始终存在的偏置耦合问题，提出了传感器差动测量的方法。

By means of forced synchronization of current in thyristor branch with the line current, the mode switching from capacitive mode to Bypass can be implemented. In the switching strategy from capacitive mode to inductive veriner mode, a method of thyristor conditional firing is put forward. The thyristors will be fired and conducted on condition that both line current and capacitor voltage are inphase.

通过强制晶闸管支路电流与线路电流同步，实现由容性区到Bypass模式的切换；在由容性区到感性微调模式切换的过程中提出了晶闸管条件触发的方法，即当线路电流和电容电压满足同向条件时晶闸管才触发导通。

It is shown from the accelerated lifetime test and noise measurement for integrated operational amplifiers that if their failure is caused by the drift of input bias current or input offset current, the drift is strongly correlated with 1/f noise current in these devices, and both are proportional approximately.

摘要寿命试验和噪声测试结果表明，如果集成运算放大器的主要失效模式是输入偏置电流或失调电流随时间的漂移，则这种漂移量与运放的1/f噪声电流具有强相关性，二者近似呈正比关系。

aining at high impedance weak signal measurement,the relations among measuring precision,input impedance and input bias current,the guard technology is applied to design a measuring circuit with guard circuit,adding a guard potential to low-impedance nodes of circuit,the effect of leakage current is reduced.using spice simulation and validates that guard circuit can increase the input impedance of the system and lower the input bias current,the results show that the guard circuit provids a valuable solution for high accuracy measurement of the high impedance weak signal.

摘 要：针对高阻抗微弱信号测量问题，对测量精度与系统输入阻抗、输入偏置电流的关系进行分析，应用保护技术设计了带保护电路的测量电路，将电路中的低阻抗节点加上保护电势，减小漏电流的影响。通过pspice仿真分析，验证保护电路能提高测量系统的输入阻抗和降低输入偏置电流，结果表明保护电路技术能实现对高阻抗微弱信号的高精度测量。

The Electrochemical measurement system used to perform DPSV measurement is constructed with two parts, a low-current measurement system consists of low input bias current operational amplifier and a high resolution SAR ADC and a potentialstat consists of high resolution DAC and high current buffer amplifier.

对于差分脉冲伏安溶出测量，我们使用高精度连续逼近寄存器型ADC和低偏置电流运放构成微电流采样系统；使用高精度DAC和高速大电流缓冲放大器构成了恒电位计，在微控制器的控制下组成电化学测量系统。

In the transistor, the output current depends on the input current, hence it is a current-operated device.

在晶体管中，输出电流依赖于输入的电流，因此它是一个电流控制器件。

The paper introduces an improved harmonic and reactive current detecting method based on there-phase reactive current using instantaneous reactive power theory. By using matlab, simulation model is built, and the results show that this model can exactly detect harmonic and reactive current in time and it is feasible in DSP system.

本文在三相瞬时无功功率理论的基础提出了一种改进的单相无功电流检测算法，并建立了仿真模型，仿真结果表明：该算法可以及时、准确地检测出三相电路中的谐波电流和无功电流，同时也验证了此算法在DSP系统中的可行性。

Although translator has turned from being a crystal ball by which the original culture can unrestrainedly penetrate to another crystal ball by which the target culture can freely traverse, the translator's personal embodiment, in the process of cognitive act, are still absent in translation studies. Translators are still subjects without body or simply disembodied subjects.

译者虽然由原语文化可以自由穿透的玻璃球变成了译语文化可以自由穿越的玻璃球，但译者认知过程中的个体体验在翻译研究中依然缺席，译者依然仅仅是一个没有躯体体验的主体。

Chillingly, he claimed our technology is 'not nearly as sophisticated' as theirs and "had they been hostile", he warned 'we would be been gone by now'.

令人毛骨悚然的，他声称我们的技术是'并不那么复杂，像他们一样，和"如果他们敌意"，他警告说，'我们将现在已经过去了。