查询词典 vertical angles

The basic relationship between the the first half-wave peak value of transient current and the initial firing angles is found by means of analytical method.The practical method is put forward to determine the initial two-phase and the third phase firing angles with the limiting value and the space vector varying track of transient current.And then the subsequent series of firing angles with the even step are calculated by using the speed at the time of re-switching.The suppressive effect to the inrush current is verified with simulation and experiment of rapid soft re-switching control,by which the influence of different speed to rapid soft re-switching course is analyzed besides.3 To analyze the power loss for typical periodically variable running load and deeply study the energy-saving principle and control mode of the intermittent power supply approach. Futhermore,the novel integrated energy-saving control technique is developed on base of the intermittent power supply approach.

通过解析方法找到快速软投入初始触发角与瞬态电流首半波峰值之间的基本关系，进而提出了由限流值和空间向量轨迹确定初始两相和第三相触发角的方法，并以固定步长均匀递减的方式由投入时转速计算出其它后续触发角；结合仿真和实验验证了快速软投入对冲击电流的抑制作用，并分析了不同转速下投入时对电源快速软投入过程的影响。3对典型周期性变工况负载特性进行能耗分析，深入研究断续供电节能机理和控制模式，并进一步发展了以断续供电为主的综合节能控制新技术。

RESULTS: There were 20 mild slips with slip angles less than 31 degrees, 24 moderate with slip angles between 31 and 50 degrees, 20 slips were severe with slip angles between 51 and 90 degrees. In 61 cases, reduction was successful without being followed by AVN.

结果：20例患者轻度滑脱与滑脱，成角小于31度； 24例患者中等滑脱，成角介于31度和50度之间；20例患者严重滑脱，成角介于51度和90度之间。61例患者成功复位，随后无AVN并发。3例患者（2个女孩和1个男孩）发展成部分性AVN（ 4.7 ％）。

A vertical profile of the 3D wellbore trajectory is generally.The challenge is how to draw the actual wellbore trajectory on the vertical profile of planned well trajectory.A planned 3D well path profile is depicted using vertical depth and projection length,however,the actual wellpath profile is supposed to be drawn using vertical depth and apparent projection length.

三维井眼一般都绘制垂直剖面图，其难点就是怎样在设计井眼轨道的垂直剖面图上描绘实钻井眼轨迹的剖面线，由于三维井眼设计剖面图是用垂深与投影长度绘制，其实钻井眼轨迹剖面图应该是用垂深和视投影长度绘制。

The process is characterized in that, the zoomed image being defined by its horizontal and vertical homothety ratio with respect to the coded image (1, 7), it performs the following steps: calculation of the horizontal and vertical sizes of an initial display rectangle (8) from which would be obtained the sizes of the target display rectangle (2) as defined by the profile and level information by applying the horizontal and vertical homothety ratios, storage in the display_horizontal_size and display_vertical_size fields of an MPEG2 video data stream of the horizontal and vertical sizes of the initial display rectangle.

该方法的特点是被缩放图像由它针对被编码图像(1，7)的水平和垂直缩放率定义，它执行下面的步骤：通过应用水平和垂直缩放率来计算初始显示长方形(8)的水平和垂直尺寸，从中可以获得按照轮廓和级别信息定义的目标显示长方形(2)的尺寸，在MPEG2视频数据流的display_horizontal_size和display_vertical_size字段中存储初始显示长方形的水平和垂直尺寸。

Second, transient flow for vertical well and fractural well in porous media with arealanisotropy has been researched in this paper. The analytic solution for vertical well andsemi-analytic solution for vertical fractural well is developed by using image inversion,superposition principle, Laplace transformation, Fourier transformation, as well as theirinverse transforms, and storage and skin are taken into account. For vertical fractural well,influence of pressure and productivity is studied when the orientation of artificial fractureisn't in accordance with the direction of major permeability, it is fundamental to evaluatepotential and analyze well test data.

文中研究了平面各向异性储层不定常渗流问题，建立了平面各向异性储层交叉直线边界中一口直井渗流的数学模型，利用镜像反演、Laplace变换、Fouier变换及其反变换推导了不同边界条件下直井的Laplace空间解析解，考虑井储和表皮的影响，分析了曲线特征及影响因素的敏感性曲线；并运用影响椭圆及Duhamel叠加原理，推导了平面各向异性储层中垂直裂缝井的压力分布方程，考虑了水力裂缝与主渗透率轴成一定角度对压力及产能的影响，为垂直裂缝井的产能评价及试井分析提供依据。

With the vertical time sequence results computed by the monitoring data (until Aug, 2008) from 28 GPS stations of continuous observation in Tianjin and Beijing Area, the paper analyzes the variation characteristics of vertical component of each GPS continuous stations, calculates the vertical movement velocity of GPS stations in Tianjin and Beijing Area of 2007~2008, compares with the vertical deformation velocity calculated by leveling of 2007-2008 in Capital Circle Area; Furthermore, searches GPS stations nearby the leveling route, corresponding to the first and second leveling time period, calculates the section plane of GPS route, analyzes and compares the section results of GPS and leveling of 2 time periods.

利用北京和天津地区的28个GPS连续观测站资料（资料截至2008年8月）计算得到的垂直向时序结果，分析各个GPS连续观测站垂向分量的变化特征，计算得到2007~2008年北京天津地区GPS站垂直运动速率，并与水准测量计算得到的2007~2008首都圈地区垂直形变速率进行比较；通过寻找水准测量路线附近的GPS站点，相应于水准的初测和复测时段，计算得到GPS路线剖面图，将GPS与水准2个时段的剖面结果进行对比分析。

Firstly, it seeks the sources from which theories have been developed, by a summary of evolution or a road-map. Secondly, it explains the two basic forms taken by traditional theories on intra-industry trade, namely, horizontal intra-industry trade model and vertical intra-industry trade model. Both models take final products as trade objects and products of same industry are thus simultaneously exported and imported among developed nations and among developed nations and developing ones.Thirdly, it points out that the theory of vertical intra-industry trade has already been expanded in scope in the area of trade between developed countries and LDCs. It shows that the implication of vertical intra-industry trade has expanded to the importation and exportation of parts and components, intermediate products or processing products produced via various working procedures or different production links within the same industry, with MNCs as carriers. It gives the summary of the methods of measuring intra-industry trade and argues that the basic method adopted by this thesis is G-L Index. In addition, GHM and Input-output Analysis are introduced to demonstrate the expansion of vertical intra-industry trade.

首先，通过整理国际贸易理论的发展脉络，寻求产业内贸易的理论渊源；其次，阐述产业内贸易传统理论的两种基本形式，水平型产业内贸易与垂直型产业内贸易的理论模型，指出两者都以最终产品为贸易对象，实现了发达国家之间或发达国家与发展中国家之间的同一产业内产品的同时进口和出口；第三，结合全球化的特点和跨国公司在国际要素分工中的基础作用，指出发达国家与发展中国家之间的垂直型产业内贸易理论已经得到拓展，表明垂直型产业内贸易涵义已发展成为以跨国公司为载体的同一产业内不同生产工序或不同生产环节的零部件、中间产品或加工产品的进口和出口；最后，归纳了产业内贸易的计量方法，指出本文的产业内贸易基本计量方法是G-L指数(格鲁贝尔-洛伊德计量法)，并在此基础上进一步说明与垂直型产业内贸易的拓展相关的计量方法包括：GHM计量法和Hummels投入-产出分析法。

The combined production of vertical and horizontal wells can make horizontal well production rates be 2 to 5 times greater than unstimulated vertical well rates, but the areal sweep efficiency is less than that of vertical well pattern untill when the perforation ratio is greater then a certain value, which depends on the pattern of the combination. Seven spot pattern of the combination of vertical and horizontal wells has some advantages over others.

当水平井和直井联合面积布井时，在同样的压差下，水平井的产量要高于相应直井井网的直井产量的2～5倍，但只有当穿透比达到一定程度，或水平井达到一定长度时，其波及系数才高于相应直井井网的波及系数（五点法井网的穿透比界限为0.521，七点法井网的穿透比界限为0.430），因而在水平井开发油气田时，必须保证水平井一定的长度，这样从长远的观点，水平井才能显示出优势，对比性分析表明，水平井和直井的七点法联合布井和直井井网以及水平井和直井的五点法联合布井井网相比，具有一定的优势，数值模拟表明，在水平井和直井的联合面积布井的各种方式中，改进的九点井网是一种较好可取的布井方式。

The other one retrieves vertical velocity from the reflectivity using statistical algorithm and assimilates the vertical velocity taking Richardson's equation as observational operator. It is found that the vertical velo city derived by the former is usually too weak while the later gets the distinct three dimensional convective structure of meso-scale system with strong vertical velocity.

其一是采用Richardson方程通过水平风场、温度和气压来对垂直速度进行诊断，其二是利用统计方法由观测的反射率因子反演出垂直速度后，再采用Richardson方程作为观测算子对反演的垂直速度进行同化。

First, the color-image was preprocessed with grayscaling, smoothing. The vertical gradient components of the image were found using the vertical mask of Sobel operator. Then the candidate areas with sufficient amount of edges were determined by calculating the gradient of edges. After finding possible vehicle candidates, the proposed method measured the prominent vertical symmetry of candidate areas and verified all possible candidates, as symmetry is an important feature of vehicle. The proposed method also figured out the vertical axis of symmetry and the width of the candidate vehicle.

算法首先对图像进行灰度化、平滑去噪等预处理，使用Sobel算子垂直方向掩模计算图像感兴趣区域内的边缘梯度，确定候选区域；而后根据车辆图像垂直边缘具有对称性的特点，分析候选区域的对称性强弱，并计算其对称轴位置和车辆宽度。

Vishnu entered a dark fourth dimensional dream that did not support his field or continued life.

毗瑟挐进入了一个第四密度的黑暗梦想，那里并不支持他的能量场或继续生命。

Leaders and decision-making persons use it to collect the data, including the information of unit work, handing in fee, oweing fee, prepaying fee,changing and afterpaying and account transfering of joining-insurance employee, and account paying of all kinds of insurances from hospitalization insurance institutions.The collected data is picked up, organized, switched and showed to user.

该子系统主要面向各级领导、决策分析人员；从各个医疗保险经办机构和定点医疗机构采集数据，包括在各个医疗保险经办机构处理的单位办公信息，单位缴费、欠费、预缴费信息，参保职工变更信息，参保职工增减变动信息，参保职工补缴信息，参保职工帐户划拨信息：包括各定点医疗机构处理的各险种帐户支出信息，各险种的统筹金支付信息等；将采集的数据提取，组织和转换，然后展示给用户。