查询词典 velocity function

The parameters optimization design model is proposed, which is based on a control model with the quasi-Euler angle, Euler angle velocity and absolute angular velocity as the feedback. The vibration-resistance parameters of the given controller are chosen as the optimization variables, and the on-off times of the engines is chosen as the optimization objective function.

基于一类采用拟欧拉角、拟欧拉角速度和飞行器绝对角速度为反馈信号的姿态机动控制模型，以其消振参数为优化变量，开关次数为优化指标，建立了姿态机动参数优化模型。

The dissertation put forward the function relation of economic velocity and anuual cost, calculating economic velocity with differential coefficient method.

本文提出的热风炉流体的经济流速是从设计的角度出发，计算出热风炉最经济的运行状况。

Combining with synchronously collected wind, current velocity and iceberg drift velocity, a kinematic relationship is developed as a multiple linear regression function and the result shows that the contribution of wind to iceberg drift is just half of that of current.

通过对冰山漂流速度和当地的风、流速度的回归分析发现，风对冰山运动的贡献是海流贡献的1／2左右。

This design paper introduced one kind based on the DSP chip entire numerical control single-phase frequency changer design, along with the frequency conversion velocity modulation technology unceasing development, the frequency changer application is more and more widespread, the frequency changer besides has the remarkable velocity modulation performance, but also has the remarkable energy conservation function, is the enterprise technological transformations and the

本设计论文介绍了一种基于DSP芯片的全数字控制单相变频器的设计，随着变频调速技术的不断发展，变频器的应用越来越广泛，变频器除了具有卓越的调速性能之外，还有显著的节能作用，是企业技术改造和产品更新换代的理想调速装置。

This design paper introduced one kind based on the DSP chip entire numerical control single-phase frequency changer design, along with the frequency conversion velocity modulation technology unceasing development, the frequency changer application is more and more widespread, the frequency changer besides has the remarkable velocity modulation performance, but also has the remarkable energy conservation function, is the enterprise technological transformations and the product renewal ideal speeder.

本设计论文介绍了一种基于DSP芯片的全数字控制单相变频器的设计，随着变频调速技术的不断发展，变频器的应用越来越广泛，变频器除了具有卓越的调速性能之外，还有显著的节能作用，是企业技术改造和产品更新换代的理想调速装置。

The main results of the investigation are as following:(1) Some important criteria for the design of multi-layer structure are acquired: the ratio of the layer thickness to the contact diameter should be controlled to a value about 0.8; increasing the number of the gradient layers and elasticity modulus of the top layer would benefit to the yield strength and the stress status at the interface.（2）By means of molecular dynamics simulations for a indentation and sliding process, it is discovered that dislocations of 45 direction to the surface occur in the surfaces layer, which is correspond to the direction of the plastic flows observed in the macroscopic continuous medium. The irreversible deformation caused by the dislocation and the atom piles at the surface are responsible for the irreversibility of the force response. They are also the main factors for the friction generation. The temperature and the indentation velocity have significant effects on the deformation behaviors of the material of the surface layer. The yield strength would increase obviously if the indentation velocity is greater than 10 m/s.（3）A method to evaluate the fracture toughness of coating by estimating the crack-density functionβof a Wicker''s indentation was proposed. Meanwhile a new surface treatment technology was developed using non-equilibrium plasma.（4）A MD-FE hybrid method and corresponding software was developed to analysis the tribological behaviors for multiplayer system.

研究主要内容和结果有：（1）得到指导梯度膜设计的几个准则：控制膜层厚度与接触半径比在0.8左右为宜；适当增加梯度层层数和顶层弹性模量，有利于提高抗屈服能力和改善界面处的应力状态；（2）通过对嵌入和滑动摩擦过程的分子动力学模拟，发现表层产生一个与宏观连续介质的塑性流动方向观测一致的45 方向位错；位错造成的不可逆变形和表面的原子堆积，是力的响应不可逆性的原因，也是构成摩擦力的主要因素；温度和嵌入速度对材料变形特性有显著的影响，当嵌入速度大于10 m/s时，屈服强度明显增加；（3）提出压痕裂纹密度系数β半定量判定膜层断裂韧性的方法；并开发出表面强化新工艺；（4）开发出分析表面摩擦学特性的MD-FE复合模拟方法和相应模拟软件。

After analyzing the relation between a quaternion function and the angular velocity it represents, a smooth angular velocity interpolation algorithm is proposed.

在分析了四元数函数与角速度的关系后，提出了角速度光滑插值的方法，并能计算出任一时间角速度的值。

This study measured the isovolumic contraction time , isovolu-mic relaxtion time and ejection time of CCP group and normal contrast group. Late,tei index was calculated, relationship between Tei index and LV function index such as ejection fraction ,the ratio of transmitral peak velocity at early diastole to transmitral peak velocity at late diastole etc.

本研究通过对正常对照组与肺心病病例组使用频谱多普勒超声心动图测量ICT、IRT、ET时间计算Tei指数，观察肺心病左心室Tei指数变化并分析其与超声测定的心功能指标EF、E/A等相关性，探讨Tei指数评价肺心病左心室整体功能的价值。

The wall function is adopted such that a resultant stream-wise velocity, U, is expressed by a local friction velocity at a first grid point to the wall of the computation domain.

和实测资料的对比验证了数值计算和边界处理技术的合理可靠性，并进一步分析复式断面明渠二次流运动的流动结构和特性。

It is a function of the velocity ratio between the hot jet and the main flow. Flows with velocity ratio between 0.01 and 1.50 were measured.

通过实验发现，横向射流的流动形式复杂，不同区域近壁区流体的温度随流速比变化的情况不尽相同。

In the United States, chronic alcoholism and hepatitis C are the most common ones.

在美国，慢性酒精中毒，肝炎是最常见的。

If you have any questions, you can contact me anytime.

如果有任何问题，你可以随时联系我。